Related references
Note: Only part of the references are listed.Using an Al-Cu binary alloy to compare processing by multi-axial compression and high-pressure torsion
Xiaochang Xu et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2013)
Influence of annealing on ductility of ultrafine-grained titanium processed by equal-channel angular pressing-Conform and drawing
Alexander V. Polyakov et al.
MRS COMMUNICATIONS (2013)
Enhanced fatigue properties of ultrafine-grained Ti rods processed by ECAP-Conform
I. P. Semenova et al.
JOURNAL OF MATERIALS SCIENCE (2012)
Cyclic deformation behavior and fatigue lives of ultrafine-grained Ti-6AL-4V ELI alloy for medical use
L. R. Saitova et al.
INTERNATIONAL JOURNAL OF FATIGUE (2009)
Processing by severe plastic deformation: an ancient skill adapted for the modern world
Ruslan Z. Valiev et al.
INTERNATIONAL JOURNAL OF MATERIALS RESEARCH (2009)
Fatigue strength, microstructural stability and strain localization in ultrafine-grained copper
L. Kunz et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2006)
Producing bulk ultrafine-grained materials by severe plastic deformation
RZ Valiev et al.
JOM (2006)
Mechanical properties of Ti-6Al-4V titanium alloy with submicrocrystalline structure produced by severe plastic deformation
S Zherebtsov et al.
MATERIALS TRANSACTIONS (2005)
The effect of equal-channel angular pressing on the structure and mechanical behavior of Ti-6A1-4V alloy
IP Semenova et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2004)
Fatigue and microstructure of ultrafine-grained metals produced by severe plastic deformation
H Mughrabi et al.
SCRIPTA MATERIALIA (2004)
Cyclic behavior of ultrafine-grain titanium produced by severe plastic deformation
AY Vinogradov et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2001)
Share Paper
