Related references
Note: Only part of the references are listed.Finite element analysis of machining processes of turbine disk of Inconel 718 high-temperature wrought alloy based on the theorem of minimum potential energy
Liangbao Liu et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2017)
Study on the machining distortion of aluminum alloy parts induced by forging residual stresses
Liangbao Liu et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART B-JOURNAL OF ENGINEERING MANUFACTURE (2017)
An analytical model for predicting the machining deformation of a plate blank considers biaxial initial residual stresses
Hanjun Gao et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2017)
Experimental Investigation on the Fatigue Life of Ti-6Al-4V Treated by Vibratory Stress Relief
Han-Jun Gao et al.
METALS (2017)
Residual stresses reconstruction in shot peened specimens containing sharp and blunt notches by experimental measurements and finite element analysis
M. Benedetti et al.
INTERNATIONAL JOURNAL OF FATIGUE (2016)
Finite element simulation and experimental investigation on the residual stress-related monolithic component deformation
Xiaoming Huang et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2015)
Influence of Drilling Parameters on the Accuracy of Hole-drilling Residual Stress Measurements
M. Steinzig et al.
EXPERIMENTAL MECHANICS (2014)
Influence of geometrical ratios in forgeability of complex shapes during hot forging of Ti-6Al-4V titanium alloy
Antonino Ducato et al.
11TH INTERNATIONAL CONFERENCE ON TECHNOLOGY OF PLASTICITY, ICTP 2014 (2014)
Machining deformation prediction for frame components considering multifactor coupling effects
Z. T. Tang et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2013)
Constitutive equations for high temperature flow stress of TC4-DT alloy incorporating strain, strain rate and temperature
Xiaona Peng et al.
MATERIALS & DESIGN (2013)
The effect of microstructure on the mechanical properties of TC4-DT titanium alloys
Ping Guo et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2013)
Evaluation of process causes and influences of residual stress on gear distortion
Remi Husson et al.
CIRP ANNALS-MANUFACTURING TECHNOLOGY (2012)
Distortion minimization of disks for gear manufacture
Ekkard Brinksmeier et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2011)
Dual-Axis Hole-Drilling ESPI Residual Stress Measurements
Gary S. Schajer et al.
JOURNAL OF ENGINEERING MATERIALS AND TECHNOLOGY-TRANSACTIONS OF THE ASME (2010)
Distortion engineering -: Identification of causes for dimensional and form deviations of bearing rings
E. Brinksmeier et al.
CIRP ANNALS-MANUFACTURING TECHNOLOGY (2007)
Finite element optimization of diamond tool geometry and cutting-process parameters based on surface residual stresses
W. J. Zong et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2007)
Progress in structural materials for aerospace systems
JC Williams et al.
ACTA MATERIALIA (2003)
Residual stress measurement using the hole drilling method and laser speckle interferometry Part II: Analysis technique
E Ponslet et al.
EXPERIMENTAL TECHNIQUES (2003)
Application of theorem of minimum potential energy to a complex structure Part I: two-dimensional analysis
EC Preissner et al.
INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES (2003)