Spatial resolution and 2D chemical image of light-addressable potentiometric sensor improved by inductively coupled-plasma reactive-ion etching

Inductively coupled plasma reactive-ion etching (ICP-RIE) is first applied to decrease the thickness of a Si substrate for light-addressable potentiometric sensor (LAPS) characterization. A simple and reliable process flow with the self-aligned Al layer as a hard mask layer in ICP-RIE is used to fabricate a thin semiconductor substrate with Al back-side contact. A single-side polished P-type Si wafer with a thickness of 350 mu m is decreased to 100 mu m by ICP-RIE from the polished side. The thickness of the thin Si substrate and the dimensions of the designed patterns determined by ICP-RIE are verified using scanning electron microscopy (SEM) and an optical microscope (OM). A selective high-dielectric constant insulator, niobium oxide (NbOx), is directly deposited on the unpolished side of the thin Si substrate as the sensing membrane of a LAPS by reactive ratio frequency (rf) sputtering. A high photocurrent was found in the ICP-RIE LAPS sample under back-side illumination, particularly in high-frequency operation. Compared to an Si substrate without ICP-RIE, 3-fold and 6.5-fold higher photocurrents were achieved by the proposed LAPS with ICP-RIE measured at 1 and 50 kHz of light modulated frequency, respectively. The highest modulated frequency of illumination was 50 kHz for an acceptable photocurrent in the LAPS with ICP-RIE, which is sufficient for two-dimensional (2D) images acquired with high-speed scanning. The NbOx layer deposited on the unpolished Si surface could automatically generate higher pH sensitivity than conventional polished Si surfaces because of the higher surface roughness. The calculated pH sensitivity and linearity were 55.8 mV/pH and 99.6%, respectively, in a pH range from 2 to 12. No clear degradation of hysteresis was found for the LAPS with ICP-RIE. For the designed patterns of the Al hard mask layer, the spatial resolution of the 2D image of the LAPS with ICP-RIE could be obtained by the difference between dimensions observed by OM and the dimensions calculated from the photocurrent versus scanning length controlled by the X-Y stage. A pattern with a length of 250 mu m generated by ICP-RIE was measured as 255 mu m in the LAPS with scanning step of 5 mu m. ICP-RIE is demonstrated to achieve a spatial resolution of 5 mu m in the Si-based LAPS. Further reduction of the thickness of an Si substrate by ICP-RIE controlling and its ability to create a dynamic 2D image are suggested for future investigation in spatial resolution optimization. (C) 2017 Elsevier B.V. All rights reserved.