Related references
Note: Only part of the references are listed.Non-isothermal precipitation kinetics and its effect on hot working behaviors of an Al-Zn-Mg-Cu alloy
Fulin Jiang et al.
JOURNAL OF MATERIALS SCIENCE (2018)
Understanding precipitate evolution during friction stir welding of Al-Zn-Mg-Cu alloy through in-situ measurement coupled with simulation
J. F. dos Santos et al.
ACTA MATERIALIA (2018)
Analysis of age hardening precipitates of Al-Zn-Mg-Cu alloys in a wide range of quenching rates using small angle X-ray scattering
Yong Zhang et al.
MATERIALS & DESIGN (2018)
Coupling of dislocations and precipitates: Impact on the mechanical behavior of ultrafine grained Al-Zn-Mg alloys
Kaka Ma et al.
ACTA MATERIALIA (2016)
Characterisation of precipitation upon cooling of an AA2618 Al-Cu-Mg alloy
N. Chobaut et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2016)
Characterizing precipitate evolution of an Al-Zn-Mg-Cu-based commercial alloy during artificial aging and non-isothermal heat treatments by in situ electrical resistivity monitoring
Fulin Jiang et al.
MATERIALS CHARACTERIZATION (2016)
Fine precipitation scenarios of AlZnMg(Cu) alloys revealed by advanced atomic-resolution electron microscopy study Part I: Structure determination of the precipitates in AlZnMg(Cu) alloys
J. Z. Liu et al.
MATERIALS CHARACTERIZATION (2015)
Static softening following multistage hot deformation of 7150 aluminum alloy: Experiment and modeling
Fulin Jiang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2015)
Quantitative measurements of dynamic precipitation during fatigue of an Al-Zn-Mg-(Cu) alloy using small-angle X-ray scattering
C. R. Hutchinson et al.
ACTA MATERIALIA (2014)
Hot tensile deformation behaviors and constitutive model of an Al-Zn-Mg-Cu alloy
Mi Zhou et al.
MATERIALS & DESIGN (2014)
Heat treatment of 7xxx series aluminium alloys-Some recent developments
Paul A. Rometsch et al.
TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2014)
Quantitative analyses of dissolution and precipitation kinetics of θ-Al2Cu phase in an Al-6.2Si-2.9Cu alloy using electrical resistivity
Jae-Gil Jung et al.
METALS AND MATERIALS INTERNATIONAL (2013)
Effects of thermomechanical processing on production of Al-Zn-Mg-Cu alloy plate
Yunlai Deng et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2012)
Improved solution treatment for an as-rolled Al-Zn-Mg-Cu alloy. Part I. Characterisation of constituent particles and overheating
D. K. Xu et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2012)
Influence of alloy composition and heat treatment on precipitate composition in Al-Zn-Mg-Cu alloys
T. Marlaud et al.
ACTA MATERIALIA (2010)
Revisiting the precipitation sequence in Al-Zn-Mg-based alloys by high-resolution transmission electron microscopy
J. Z. Liu et al.
SCRIPTA MATERIALIA (2010)
Nanostructural hierarchy increases the strength of aluminium alloys
Peter V. Liddicoat et al.
NATURE COMMUNICATIONS (2010)
Study of the early stages of clustering in Al-Mg-Si alloys using the electrical resistivity measurements
Hossein Seyedrezai et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2009)
Electrical resistivity and thermal conductivity of pure aluminum and aluminum alloys up to and above the melting temperature
R. Brandt et al.
INTERNATIONAL JOURNAL OF THERMOPHYSICS (2007)
Examination of precipitation in the aluminum alloy AA6111 using electrical resistivity measurements
B Raeisinia et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2006)
Early-stage precipitation in Al-Zn-Mg-Cu alloy (7050)
G Sha et al.
ACTA MATERIALIA (2004)
Precipitation sequences during quenching of the AA 7010 alloy
D Godard et al.
ACTA MATERIALIA (2002)
Deformation of copper single crystals to large strains at 4.2 K - I. Mechanical response and electrical resistivity
M Niewczas et al.
PHILOSOPHICAL MAGAZINE A-PHYSICS OF CONDENSED MATTER STRUCTURE DEFECTS AND MECHANICAL PROPERTIES (2001)
Dispersoid precipitation and process modelling in zirconium containing commercial aluminium alloys
JD Robson et al.
ACTA MATERIALIA (2001)
Modelling of non-isothermal transformations in alloys containing a particle distribution
OR Myhr et al.
ACTA MATERIALIA (2000)
High temperature precipitation kinetics and TTT curve of a 7xxx alloy by in-situ electrical resistivity measurements and differential calorimetry
P Archambault et al.
SCRIPTA MATERIALIA (2000)
Additivity and isokinetic behaviour in relation to diffusion controlled growth
O Grong et al.
ACTA MATERIALIA (2000)
Share Paper
