Microstructure and mechanical properties of Al-Mg-Zr alloys processed by selective laser melting

Gas-atomized powders of two ternary alloys, Al-3.60Mg-1.18Zr and Al-3.66Mg-1.57Zr (wt.%), were densified via laser powder bed fusion. At energy densities ranging from 123 to 247 J/mm(3), as-fabricated components are near-fully densified (relative density 99.2-99.9%) as verified by X-ray tomography. While Mg acts a solid-solution strengthener, Zr creates two types of metastable L1(2) Al3Zr precipitates, each playing dual roles: (a) sub-micrometer Al3Zr particles form in the melt upon solidification and act as grain refining agents, nucleating fine aluminum grains, which (i) prevent hot-tearing during the rapid solidification inherent to laser melting and (ii) enhance tensile strength (Hall-Petch strengthening) and ductility (influence a heterogenous grain structure) after fabrication; (b) Al3Zr nano-precipitates form in the solid alloy during subsequent aging, which (i) precipitation-strengthen the alloy leading to an increase of >40% in strength over the as-fabricated value, and (ii) promote thermal stability of the fine grain size (and the associated Hall-Petch strengthening) after exposure to high temperature due to the slow kinetics of Al3Zr coarsening (from the sluggish diffusivity of Zr in solid Al-Mg). While the Zr-richer alloy shows higher yield and ultimate tensile strength in the as-fabricated state, both alloys have identical mechanical properties after peak aging. Interconnected bands of fine (similar to 0.8 mu m), equiaxed, isotropic grains and coarser (similar to 1 x 10 mu m), columnar, textured grains - both containing oxide particles and Al3Zr precipitates - provide a combination of high yield strength and high ductility (e.g., similar to 354 MPa, and similar to 20%, respectively) with isotropic values in both as-fabricated and peak-aged samples, unlike Al-Si alloys processed via laser fusion of commercial Al-Si-based powders. The pre-alloyed, gas-atomized Al-Mg-Zr powders do not contain expensive alloying elements such as Sc, nor do they require blending with a second powder to nucleate fine grains, making them excellent candidates for economical, large-scale additive manufacturing applications. (C) 2018 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.