Towards safer helmets: characterisation, modelling and monitoring

Bike and ski helmets are mainly made up of two layers: the external shell and the foam liner. The foam liner, typically made of expanded polystyrene (EPS) or polypropylene (EPP), is asked to provide energy absorption in case of impacts. Standard helmet design requires the foam to maximize this energy absorption, thus achieving large deformations (up to 25% in compression) while maintaining the stress level below a threshold value. To optimize the helmet construction in terms of foam composition, structure and density, reliable numerical models are required, which in turn need to be fed with accurate experimental data. A characterisation of several foams was performed, including EPS and EPP having varying densities, under tensile and compressive stress states at varying strain rates. Typical mechanical parameters (elastic moduli and plateau stress in compression, Poisson's ratio) were compared with literature data and applicability of existing models to experimental results was discussed. A marked strain rate dependence - very important for impact applications - was accurately described using the Nagy phenomenological model. The foam microstructure was investigated using scanning electron microscopy (SEM) to assess structural changes before and after compression. The aforementioned mechanical features were then adopted in a rate-dependent constitutive law for crushable foams, to model the shock attenuation properties of helmets and validate the approach against available data. Finally, a microelectromechanical system based in-helmet wireless micro monitoring system was developed and inserted in a helmet prototype. The system is capable of acquiring impact load spectra, providing valuable information to investigate generic impacts with varying angles and energy. In particular, it can monitor the effect of repeated micro-impacts on the residual energy absorption characteristics of the foam. (C) 2016 The Authors. Published by Elsevier Ltd.