4.6 Article

A conversion-based highly energy dense Cu2+ intercalated Bi-birnessite/Zn alkaline battery

Journal

JOURNAL OF MATERIALS CHEMISTRY A
Volume 5, Issue 30, Pages 15845-15854

Publisher

ROYAL SOC CHEMISTRY
DOI: 10.1039/c7ta05347a

Keywords

-

Funding

  1. US Department of Energy, ARPA-E [DE AR0000150]
  2. National Science Foundation [CHE-1041832]

Ask authors/readers for more resources

Manganese dioxide (MnO2)-zinc (Zn) batteries are cheap and environmentally benign and have sufficient theoretical energy density to be used as an energy storage device for the grid; however, they have been relegated to primary systems, where the complete energy is delivered in a single discharge, due to the irreversibility of their active materials. Until recently, rechargeable MnO2-Zn batteries have only been able to cycle similar to 10% of MnO2's theoretical 2-electron capacity (617 mA h g(-1)), thus delivering significantly reduced energy density. In a recent paper from our group, we reversibly accessed the full theoretical 2-electron capacity of MnO2 for > 6000 cycles by using a layered polymorph of MnO2 mixed with bismuth oxide (Bi2O3) called Bi-birnessite (Bi-d-MnO2) intercalated with Cu2+ ions. This discovery highlighted the possibility of achieving very high energy densities from inexpensive aqueous batteries; however, a full-cell demonstration with Zn as the anode was not studied. Here we report for the first time the effect of Zn anodes on the cycle life and energy density of a full cell, where we observe that 15% depth-of-discharge (DOD) of the Zn's theoretical capacity (820 mA h g(-1)) creates a cell energy density of similar to 160 W h L-1; however, this causes a drastic shape change and formation of irreversible zinc oxide (ZnO) at the anode, which ultimately causes cell failure after similar to 100 cycles. A drop in energy density is also observed as a result of the interaction of dissolved Zn ions with the cathode, which forms a resistive Zn-birnessite compound in the early cycles, and then forms a highly resistive haeterolite (ZnMn2O4) in the later cycles, and ultimately causes cathode failure. A possible solution using a calcium hydroxide layer as a separator is presented, where the layer blocks the interaction of zinc ions through a complexing mechanism to obtain >900 cycles with >80% retention of MnO2 DOD.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.6
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available