Effect of TiB2 content on the characteristics of spark plasma sintered Ti-TiBw composites

Spark plasma sintering (SPS) was employed to fabricate monolithic titanium and in-situ formed TiB whisker (TiBw) reinforced titanium matrix composites (TMCs) by adding different amounts of TiB2 as boron source. The sintering process was completed at 1050 degrees C for 5 min under 50 MPa. The influences of TiB2 content (0.6-9.6 wt. %) on microstructural evolution and mechanical properties of TMCs were investigated. Thermodynamics, XRD analysis and microstructural investigations confirmed the in-situ formation of TiBw in the composite samples. However, some semi-reacted TiB2 phases, surrounded by TiB coronas, were remained in the microstructure due to the unfinished chemical reaction between the components during a short-time sintering process. The results showed that all samples were appropriately densified by SPS process into the almost dense parts with relative density no less than 97.5%. While bending strength decreased and hardness increased with increasing TiB2 content, the sample with 4.8 wt. % TiB2 had the maximum tensile strength. Fractographical assessments showed that the addition of TiB2 hindered the grain growth of titanium matrix. With increasing TiB2 content, fracture mode changed from a multiple pattern to a predominantly transgranular and brittle state. (C) 2017 The Society of Powder Technology Japan. Published by Elsevier B.V. and The Society of Powder Technology Japan. All rights reserved.