Related references
Note: Only part of the references are listed.Planar defect formation in the γ' phase during high temperature creep in single crystal CoNi-base superalloys
Y. M. Eggeler et al.
ACTA MATERIALIA (2016)
High strength and high ductility copper obtained by topologically controlled planar heterogeneous structures
Xiaowei Liu et al.
SCRIPTA MATERIALIA (2016)
Quantitative experimental determination of the solid solution hardening potential of rhenium, tungsten and molybdenum in single-crystal nickel-based superalloys
Ernst Fleischmann et al.
ACTA MATERIALIA (2015)
Creep-induced planar defects in L12-containing Co- and CoNi-base single-crystal superalloys
Michael S. Titus et al.
ACTA MATERIALIA (2015)
Significant contribution of stacking faults to the strain hardening behavior of Cu-15%Al alloy with different grain sizes
Y. Z. Tian et al.
SCIENTIFIC REPORTS (2015)
Microscopic mechanisms contributing to the synchronous improvement of strength and plasticity (SISP) for TWIP copper alloys
R. Liu et al.
SCIENTIFIC REPORTS (2015)
Effects of Co content on tensile properties and deformation behaviors of Ni-based disk superalloys at different temperatures
Chenggang Tian et al.
MATERIALS & DESIGN (2015)
Stacking fault effects on dynamic strain aging in a Ni-Co-based superalloy
Y. J. Xu et al.
SCRIPTA MATERIALIA (2014)
Deformation twinning with zero macroscopic strain in a coarse-grained Ni-Co-based superalloy
Y. J. Xu et al.
SCRIPTA MATERIALIA (2014)
Optimizing strength and ductility of austenitic stainless steels through equal-channel angular pressing and adding nitrogen element
F. Y. Dong et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2013)
Strengthening an austenitic Fe-Mn steel using nanotwinned austenitic grains
H. T. Wang et al.
ACTA MATERIALIA (2012)
High-resolution electron microscopy of dislocation ribbons in a CMSX-4 superalloy single crystal
V. A. Vorontsov et al.
ACTA MATERIALIA (2012)
Strength and ductility of 316L austenitic stainless steel strengthened by nano-scale twin bundles
F. K. Yan et al.
ACTA MATERIALIA (2012)
A first-principles study of the effect of Ta on the superlattice intrinsic stacking fault energy of L12-Co3(Al,W)
Alessandro Mottura et al.
INTERMETALLICS (2012)
Creep mechanisms of a new Ni-Co-base disc superalloy at an intermediate temperature
Y. Yuan et al.
JOURNAL OF MICROSCOPY (2012)
Enhanced strength at intermediate temperatures in a Ni-base disk superalloy with high Co addition
Y. Yuan et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2012)
Effect of Solution Temperature on the Microstructure and Mechanical Properties of a Newly Developed Superalloy TMW-4M3
Zhihong Zhong et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2012)
A new method to strengthen turbine disc superalloys at service temperatures
Y. Yuan et al.
SCRIPTA MATERIALIA (2012)
Optimizing strength and ductility of Cu-Zn alloys through severe plastic deformation
P. Zhang et al.
SCRIPTA MATERIALIA (2012)
Deformation mechanisms in a new disc superalloy at low and intermediate temperatures
Y. Yuan et al.
SCRIPTA MATERIALIA (2012)
Enhanced strength-ductility synergy in nanostructured Cu and Cu-Al alloys processed by high-pressure torsion and subsequent annealing
X. H. An et al.
SCRIPTA MATERIALIA (2012)
Effects of stacking fault energy, strain rate and temperature on microstructure and strength of nano structured Cu-Al alloys subjected to plastic deformation
Y. Zhang et al.
ACTA MATERIALIA (2011)
Effect of stacking fault energy on mechanical behavior of bulk nanocrystalline Cu and Cu alloys
Khaled Youssef et al.
ACTA MATERIALIA (2011)
Dislocation decorrelation and relationship to deformation microtwins during creep of a γ′ precipitate strengthened Ni-based superalloy
R. R. Unocic et al.
ACTA MATERIALIA (2011)
A Novel Strategy for the Design of Advanced Engineering Alloys-Strengthening Turbine Disk Superalloys via Twinning Structures
Yong Yuan et al.
ADVANCED ENGINEERING MATERIALS (2011)
Influence of Co content on stacking fault energy in Ni-Co base disk superalloys
Yong Yuan et al.
JOURNAL OF MATERIALS RESEARCH (2011)
Anomalous deformation behavior and twin formation of Ni-base superalloys at the intermediate temperatures
I. S. Kim et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2011)
Dependence of tensile deformation behavior of TWIP steels on stacking fault energy, temperature and strain rate
S. Curtze et al.
ACTA MATERIALIA (2010)
Microtwinning and other shearing mechanisms at intermediate temperatures in Ni-based superalloys
L. Kovarik et al.
PROGRESS IN MATERIALS SCIENCE (2009)
Strengthening Materials by Engineering Coherent Internal Boundaries at the Nanoscale
K. Lu et al.
SCIENCE (2009)
Revealing the Maximum Strength in Nanotwinned Copper
L. Lu et al.
SCIENCE (2009)
Nanoprecipitate-hardened 1.5 GPa steels with unexpected high ductility
D. Raabe et al.
SCRIPTA MATERIALIA (2009)
Thermomechanical fatigue mechanism in a modern single crystal nickel base superalloy TMS-82
J. X. Zhang et al.
ACTA MATERIALIA (2008)
High-temperature strength and deformation of gamma/gamma ' two-phase Co-Al-W-base alloys
Akane Suzuki et al.
ACTA MATERIALIA (2008)
Interactions between non-screw lattice dislocations and coherent twin boundaries in face-centered cubic metals
Z. -H. Jin et al.
ACTA MATERIALIA (2008)
Temperature dependence of tensile behavior of Ni-based superalloy M951
Z. W. Lian et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2008)
Combined effects of crystallographic orientation, stacking fault energy and grain size on deformation twinning in fcc crystals
W. Z. Han et al.
PHILOSOPHICAL MAGAZINE (2008)
Effect of thermal annealing on mechanical properties of a nanostructured copper prepared by means of dynamic plastic deformation
Y. S. Li et al.
SCRIPTA MATERIALIA (2008)
Grain boundary segregation in a Ni-Fe-based (Alloy 718) superalloy
D. H. Ping et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2007)
Mechanical properties of nanocrystalline materials
MA Meyers et al.
PROGRESS IN MATERIALS SCIENCE (2006)
Decorrelated movements of Shockley partial dislocations in the γ-phase channels of nickel-based superalloys at intermediate temperature
S Raujol et al.
PHILOSOPHICAL MAGAZINE (2006)
The interaction mechanism of screw dislocations with coherent twin boundaries in different face-centred cubic metals
ZH Jin et al.
SCRIPTA MATERIALIA (2006)
High density nano-scale twins in Cu induced by dynamic plastic deformation
WS Zhao et al.
SCRIPTA MATERIALIA (2005)
Investigation of creep deformation mechanisms at intermediate temperatures in Rene 88 DT
GB Viswanathan et al.
ACTA MATERIALIA (2005)
Superlattice stacking fault formation and twinning during creep in γ/γ′ single crystal superalloy CMSX-4
DM Knowles et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2003)
The role of ⟨112⟩ {111} slip in the asymmetric nature of creep of single crystal superalloy CMSX-4
DM Knowles et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2002)
The high temperature decrease of the critical resolved shear stress in nickel-base superalloys
M Kolbe
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2001)
A metallographic and quantitative analysis of the influence of stacking fault energy on shock-hardening in Cu and Cu-Al alloys
A Rohatgi et al.
ACTA MATERIALIA (2001)
Share Paper
