Journal
SURFACE & COATINGS TECHNOLOGY
Volume 332, Issue -, Pages 275-282Publisher
ELSEVIER SCIENCE SA
DOI: 10.1016/j.surfcoat.2017.05.097
Keywords
Ti-Al-W-N; Arc evaporation; Thermo-mechanical properties; Tribological behavior; Phase evolution; Macro particles
Funding
- Austrian Federal Ministry of Economy, Family and Youth
- National Foundation for Research, Technology and Development
- Plansee Composite Materials GmbH
- Oerlikon Balzers, Oerlikon Surface Solutions AG
- X-Ray Center
- University Service Centre for Transmission Electron Microscopy, at TU Wien Austria
Ask authors/readers for more resources
The protection of various tools and components through wear resistant coatings is imperative in highly efficient and precise industrial manufacturing processes. Especially, physical vapor deposited Ti1-xAlxN and Cr1-xAlxN coatings have been commonly used as hard protective coatings due to their outstanding thermal stability and mechanical strength. However, to increase the applicable working temperatures by simultaneously enhancing the wear performance (e.g., to allow for higher cutting speeds) further improvements are required. Therefore, we studied in detail the impact of tungsten (W)-in combination with the substrate bias potential (tibias)-on the thermo-mechanical properties and wear performance of arc evaporated Ti1-x-yAlxWyN thin films. With increasing W content, the quality of our coatings significantly increases due to pronounced reduction of growth defects (quantity of macro particles). All coatings studied crystallize in a supersaturated, single-phased face-centered cubic Ti1-x-yAlxWyN structure and their hardness (H) increases whereas the indentation modulus (E) decreases with increasing W content. This results in increased H-3/E-2 values, with a maximum of 0.19 GPa for TioseAloAiWo.o9N prepared with U-bias =-120 V (H cze, 35 GPa, E 483 GPa). All W-alloyed coatings exhibit wear rates below 4.10-5 min(3)/Nm during our dry sliding pin-on-disk tests against alumina balls at room temperature, with a tendency for reduced values if more droplets are present. The highest thermal stability, with respect to the decomposition of the supersaturated Ti1-x-yAlxWyN phase towards the stable constituents (at high temperature) TiN, AIN, and W, is obtained for Ti(0.53)Al(0.42)W(0,0)5N prepared with Ubjas = -80 V. Here, the formation of the wurtzite-structured AIN can be delayed to 1000 degrees C after 60 min lasting isothermal annealings in vacuum. (C) 2017 Elsevier B.V. All rights reserved.
Authors
I am an author on this paper
Click your name to claim this paper and add it to your profile.
Reviews
Recommended
No Data Available