Related references
Note: Only part of the references are listed.Warm Spray Forming of Ti-6Al-4V
R. M. Molak et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2014)
High Pressure Cold Sprayed (HPCS) and Low Pressure Cold Sprayed (LPCS) Coatings Prepared from OFHC Cu Feedstock: Overview from Powder Characteristics to Coating Properties
Heli Koivuluoto et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2012)
Effect of Pulsed Laser Ablation and Continuous Laser Heating on the Adhesion and Cohesion of Cold Sprayed Ti-6Al-4V Coatings
M. Perton et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2012)
NIH Image to ImageJ: 25 years of image analysis
Caroline A. Schneider et al.
NATURE METHODS (2012)
Theoretical and Experimental Particle Velocity in Cold Spray
Victor K. Champagne et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2011)
Influence of Helium and Nitrogen Gases on the Properties of Cold Gas Dynamic Sprayed Pure Titanium Coatings
Wilson Wong et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2011)
Mechanical properties of additive manufactured titanium (Ti-6Al-4V) blocks deposited by a solid-state laser and wire
Erhard Brandl et al.
MATERIALS & DESIGN (2011)
As-Fabricated and Heat-Treated Microstructures of the Ti-6Al-4V Alloy Processed by Selective Laser Melting
T. Vilaro et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2011)
A study of the micro structural evolution during selective laser melting of Ti-6Al-4V
Lore Thijs et al.
ACTA MATERIALIA (2010)
Additive manufacturing of Ti-6Al-4V components by shaped metal deposition: Microstructure and mechanical properties
Bernd Baufeld et al.
MATERIALS & DESIGN (2010)
Nanostructure formation and its effects on the mechanical properties of kinetic sprayed titanium coating
Gyuyeol Bae et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2010)
Elimination of porosity in directly fabricated titanium via cold gas dynamic spraying
Saden H. Zahiri et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2009)
Assessment of CFD Modeling via Flow Visualization in Cold Spray Process
B. Samareh et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2009)
The Laser-assisted Cold Spray process and deposit characterisation
Matthew Bray et al.
SURFACE & COATINGS TECHNOLOGY (2009)
General aspects of interface bonding in kinetic sprayed coatings
Gyulyeol Bae et al.
ACTA MATERIALIA (2008)
Review on Cold Spray Process and Technology: Part I-Intellectual Property
Eric Irissou et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2008)
Development of a generalized parameter window for cold spray deposition
T Schmidt et al.
ACTA MATERIALIA (2006)
An analysis of the cold spray process and its coatings
T Stoltenhoff et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2002)
The features of cold spray nozzle design
AP Alkhimov et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2001)
Share Paper
