Related references
Note: Only part of the references are listed.Effect of solution time in T6 heat treatment on microstructure and hardness of a directionally solidified Al-Si-Cu alloy
Thiago A. Costa et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2016)
Influence of upward and horizontal growth direction on microstructure and microhardness of an unsteady-state directionally solidified Al-Cu-Si alloy
Raimundo Lucivaldo Maraes de Araujo et al.
MATERIA-RIO DE JANEIRO (2016)
Measurements of Microhardness During Transient Horizontal Directional Solidification of Al-Rich Al-Cu Alloys: Effect of Thermal Parameters, Primary Dendrite Arm Spacing and Al2 Cu Intermetallic Phase
Andre Santos Barros et al.
METALS AND MATERIALS INTERNATIONAL (2015)
Effect of solidification parameters on mechanical properties of directionally solidified Al-Rich Al-Cu alloys
Emin Cadirli
METALS AND MATERIALS INTERNATIONAL (2013)
The heat treatment of Al-Si-Cu-Mg casting alloys
Emma Sjolander et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2010)
Variation of microindentation hardness with solidification and microstructure parameters in the Al based alloys
H. Kaya et al.
APPLIED SURFACE SCIENCE (2008)
Effect of metallurgical parameters on the hardness and microstructural characterization of as-cast and heat-treated 356 and 319 aluminum alloys
M. Tash et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2007)
Improvement of 319 aluminum alloy casting durability by high temperature solution treatment
JH Sokolowski et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2001)
Share Paper
