Alteration of volcanic rocks: A new non-intrusive indicator based on induced polarization measurements

Induced polarization is a geophysical method investigating the ability of rocks to store reversibly electrical charges under a slowly alternating electrical field. The material property of interest is a complex-valued electrical conductivity with an in-phase component associated with conduction and a quadrature component associated with polarization. We investigated the relationship between complex conductivity spectra over the frequency range 1 mHz-45 kHz and the specific surface area (SSA) of 28 volcanic core samples extracted from a wellbore drilled for the Humu'ula Groundwater Research Project in Hawaii. The specific surface area of these samples was determined through the Brunauer, Emmett and Teller (BET) method. Subcritical nitrogen adsorption experiments were conducted using two different instruments and the samples were prepared in both pellets and powder forms. The BET specific surface area is found to be highly correlated to the cation exchange capacity of the core samples measured by the cobalthexamine method. The in-phase conductivity itself can be decomposed as the sum of a bulk contribution associated with conduction in the bulk pore water and a surface conductivity associated with conduction in the electrical double layer coating the grains. The surface conductivity, the quadrature conductivity, and the normalized chargeability (defined as the difference between the in-phase conductivity at high and low frequencies) are observed to be linearly correlated to the specific surface area or the surface per volume ratio of the core samples, which can be considered as proxy of alteration. These trends are consistent with those shown by sedimentary rocks. This new data set demonstrates that the induced polarization method can be potentially used to image alteration in volcanic environments. (C) 2017 Published by Elsevier B.V.