Related references
Note: Only part of the references are listed.Impact of deposition temperature on crystalline structure of plasma-sprayed Al2O3 splats revealed by FIB-HRTEM technique
Er-Juan Yang et al.
CERAMICS INTERNATIONAL (2016)
Hierarchical Formation of Intrasplat Cracks in Thermal Spray Ceramic Coatings
Lin Chen et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2016)
A TEM Study of the Microstructure of Plasma-Sprayed YSZ Near Inter-splat Interfaces
Er-Juan Yang et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2015)
Fracture-Based Fabrication of Normally Closed, Adjustable, and Fully Reversible Microscale Fluidic Channels
Byoung Choul Kim et al.
SMALL (2014)
Fracture-based micro- and nanofabrication for biological applications
Byoung Choul Kim et al.
BIOMATERIALS SCIENCE (2014)
Effect of intersplat interface bonding on the microstructure of plasma-sprayed Al2O3 coating
Er-Juan Yang et al.
INTERNATIONAL SYMPOSIUM ON INTERFACIAL JOINING AND SURFACE TECHNOLOGY (IJST2013) (2014)
Critical bonding temperature for the splat bonding formation during plasma spraying of ceramic materials
Guan-Jun Yang et al.
SURFACE & COATINGS TECHNOLOGY (2013)
Amorphous zones in flame sprayed alumina-titania-zirconia compounds
Tim Kratschmer et al.
CERAMICS INTERNATIONAL (2011)
Influence of Deposition Temperature on the Microstructures and Properties of Plasma-Sprayed Al2O3 Coatings
Shun Hao et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2011)
Instantaneous fabrication of arrays of normally closed, adjustable, and reversible nanochannels by tunnel cracking
K. L. Mills et al.
LAB ON A CHIP (2010)
An explicit elastic solution for a brittle film with periodic cracks
H. M. Yin et al.
INTERNATIONAL JOURNAL OF FRACTURE (2008)
Influence of through-lamella grain growth on ionic conductivity of plasma-sprayed yttria-stabilized zirconia as an electrolyte in solid oxide fuel cells
Ya-Zhe Xing et al.
JOURNAL OF POWER SOURCES (2008)
Influence of Microstructure on the Ionic Conductivity of Plasma-Sprayed Yttria-Stabilized Zirconia Deposits
Ya-Zhe Xing et al.
JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2008)
Influence of interfacial delamination on channel cracking of elastic thin films
Haixia Mei et al.
INTERNATIONAL JOURNAL OF FRACTURE (2007)
Tuneable elastomeric nanochannels for nanofluidic manipulation
Dongeun Huh et al.
NATURE MATERIALS (2007)
Suppression of crystallization during high velocity impact quenching of alumina droplets: Observations and characterization
L. Li et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2007)
Investigation of splat curling up in thermal spray coatings
Minxia Xue et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2006)
Fabrication of reconfigurable protein matrices by cracking
XY Zhu et al.
NATURE MATERIALS (2005)
Ceramic materials for thermal barrier coatings
XQ Cao et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2004)
Transient contact pressure during flattening of thermal spray droplet and its effect on splat formation
CJ Li et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2004)
In situ measurement of residual stresses and elastic moduli in thermal sprayed coatings - Part 1: apparatus and analysis
J Matejicek et al.
ACTA MATERIALIA (2003)
Effect of different substrate conditions upon interface with plasma sprayed zirconia - a TEM study
T Chraska et al.
SURFACE & COATINGS TECHNOLOGY (2002)
Materials science - Thermal barrier coatings for gas-turbine engine applications
NP Padture et al.
SCIENCE (2002)
Transmission electron microscopy study of rapid solidification of plasma sprayed zirconia - part I. First splat solidification
T Chraska et al.
THIN SOLID FILMS (2001)
Transmission electron microscopy study of rapid solidification of plasma sprayed zirconia - part II. Interfaces and subsequent splat solidification
T Chraska et al.
THIN SOLID FILMS (2001)
Splat formation and microstructure development during plasma spraying: deposition temperature effects
S Sampath et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2001)
Crack patterns in brittle thin films
VB Shenoy et al.
INTERNATIONAL JOURNAL OF FRACTURE (2001)
Role of condensates and adsorbates on substrate surface on fragmentation of impinging molten droplets during thermal spray
XY Jiang et al.
THIN SOLID FILMS (2001)
Non-destructive evaluation of delamination in ceramic thin films on metal substrates by scanning electron microscopy
S Rangarajan et al.
THIN SOLID FILMS (2001)
A revisited criterion for crack defection at an interface in a brittle bimaterial
E Martin et al.
COMPOSITES SCIENCE AND TECHNOLOGY (2001)
Interface debonding ahead of a primary crack
D Leguillon et al.
JOURNAL OF THE MECHANICS AND PHYSICS OF SOLIDS (2000)
Crack patterns in thin films
ZC Xia et al.
JOURNAL OF THE MECHANICS AND PHYSICS OF SOLIDS (2000)
General characteristics of crack arrays in epilayers grown under tensile strain
RT Murray et al.
SEMICONDUCTOR SCIENCE AND TECHNOLOGY (2000)
Share Paper
