Related references
Note: Only part of the references are listed.Influence of Si and cooling rate on microstructure and mechanical properties of Al-Si-Mg cast alloys
Baiwei Zhu et al.
SURFACE AND INTERFACE ANALYSIS (2016)
Application of EIS to In Situ Characterization of Hydrothermal Sealing of Anodized Aluminum Alloys: Comparison between Hexavalent Chromium-Based Sealing, Hot Water Sealing and Cerium-Based Sealing
A. Carangelo et al.
JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2016)
A study of formation and growth of the anodised surface layer on cast Al-Si alloys based on different analytical techniques
Baiwei Zhu et al.
MATERIALS & DESIGN (2016)
PEO of pre-anodized Al-Si alloys: Corrosion properties and influence of sealings
M. Mohedano et al.
APPLIED SURFACE SCIENCE (2015)
Effect of intermetallic phases on the anodic oxidation and corrosion of 5A06 aluminum alloy
Song-mei Li et al.
INTERNATIONAL JOURNAL OF MINERALS METALLURGY AND MATERIALS (2015)
Corrosion inhibitors for anodised aluminium
M. Whelan et al.
SURFACE & COATINGS TECHNOLOGY (2013)
Enhancing aluminum corrosion resistance by two-step anodizing process
L. Bouchama et al.
SURFACE & COATINGS TECHNOLOGY (2013)
Comparison of anodised aluminium surfaces from four fabrication methods
F. Riddar et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2012)
Degradation of the corrosion resistance of anodic oxide films through immersion in the anodising electrolyte
M. Garcia-Rubio et al.
CORROSION SCIENCE (2010)
Influence of molybdate species on the tartaric acid/sulphuric acid anodic films grown on AA2024 T3 aerospace alloy
M. Garcia-Rubio et al.
CORROSION SCIENCE (2009)
Evaluation of the corrosion resistance of anodized aluminum 6061 using electrochemical impedance spectroscopy (EIS)
Yuelong Huang et al.
CORROSION SCIENCE (2008)
Behaviour of different bare and anodised aluminium alloys in the atmosphere
M. J. Bartolome et al.
SURFACE & COATINGS TECHNOLOGY (2008)
Characterisation of porous and barrier layers of anodic oxides on different aluminium alloys
S. Feliu et al.
JOURNAL OF APPLIED ELECTROCHEMISTRY (2007)
EIS characterisation of anodic films formed on 2024 aluminium alloy, in sulphuric acid containing molybdate or permanganate species
V Moutarlier et al.
CORROSION SCIENCE (2005)
Influence of substrate microstructure on the growth of anodic oxide layers
LE Fratila-Apachitei et al.
ELECTROCHIMICA ACTA (2004)
A transmission electron microscopy study of hard anodic oxide layers on AlSi(Cu) alloys
LE Fratila-Apachitei et al.
ELECTROCHIMICA ACTA (2004)
Voltage transients and morphology of AlSi(Cu) anodic oxide layers formed in H2SO4 at low temperature
LE Fratila-Apachitei et al.
SURFACE & COATINGS TECHNOLOGY (2002)
Share Paper
