3.8 Article

Experimental Study of Microgroove Surface Using Three-Dimensional Elliptical Vibration Texturing

Journal

Publisher

ASME
DOI: 10.1115/1.4043957

Keywords

microgroove; vibration mark; 3D-EVT; microstructured surface

Funding

  1. Basic Science Research Program through the National Research Foundation of Korea (NRF) - Ministry of Science, ICT, and Future Planning [NRF-2017R1A2B2003932]
  2. Basic Science Research through the National Research Foundation of Korea (NRF) - Ministry of Education [NRF-2017R1A4A1015581]
  3. Ministry of Trade, Industry & Energy (MOTIE, Korea)

Ask authors/readers for more resources

This paper presents our preliminary study of the microstructured surface on microgrooves patterns, which have manufactured using the three-dimensional elliptical vibration texturing (3D-EVT) method. The 3D-EVT method uses a three-dimensional trajectory of elliptical locus of the cutting tool tip in high vibration frequency to fabricate the microstructure or the vibration mark pattern on the machined surface. The experimental study has been done with a variation of the nominal cutting speeds from 300 to 600 mm/min. The preliminary results showed that in the low nominal cutting speed of 300 and 450 mm/min, the microstructured surfaces were not manufactured well due to the bulging existence on the microstructured surface in which it is correlated with the build-up edge phenomena. On the other hand, a relative excellent microstructured surface can be achieved at the higher nominal cutting speed of 600 mm/min. In addition, a lubricant could be used to obtain an excellent microstructured surface to avoid the built-up edge phenomena.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

3.8
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available