Polylactic Acid-based Wood-plastic 3D Printing Composite and its Properties

Wood-plastic composites for 3D printing from plant fiber (bleached pulp powder, mechanical pulp powder, newspaper pulp powder, eucalyptus powder, pine powder, and lignin) and polylactic acid (PLA), with silane coupling agent (KH550) as plasticizer, were prepared via melt extrusion. The physical properties, such as surface morphology, apparent density, tensile strength, melt flow rate, compatibility, and thermal stability were measured. Moreover, the effects of the content of various types of plant fiber powder in PLA on the properties of the prepared composites were investigated. The results showed that the modified lignin/PLA composite exhibited a superior performance under the same added amount. In particular, when the amount of lignin added was 15%, the tensile strength of the composite was 74.0% higher than that of pure PLA, and the melt flow rate was reduced by 17.8% compared with pure PLA. The density of the composite increased 15.8% compared with pure PLA when the lignin content was 20%. The scanning electron microscopy cross-sectional morphology and differential scanning calorimetry analyses showed that the optimal addition amount of lignin was 15%. Finally, the prepared lignin/PLA composite material was used in 3D printing with a smooth silky property and an excellent printing performance.