Dominant effect of the grain size of the MAPbI3 perovskite controlled by the surface roughness of TiO2 on the performance of perovskite solar cells

Lead-halide perovskite solar cells (PSCs) have attracted attention due to their outstanding high power-conversion efficiency. In conventional inorganic solar cells such as Si solar cells, the relationship between cell performance and crystal grain size has been extensively discussed. However, in PSCs, the effect of the grain size on the cell performance has not previously been separated from other accompanying effects such as passivation at the grain boundary and variation in thickness and quality of the grains. Here, the average grain size of the methylammonium lead triiodide (MAPbI(3)) perovskite could be controlled alone by the surface roughness (R-ms) of the compact TiO2 layer using the same preparation conditions used for MAPbI(3). The direct dominant effect of the MAPbI(3) grain size on the inorganic PSC performance could be observed by controlling alone the R-Ms of the compact TiO2 as an electron transport layer. For a PSC with an active area of 0.54 cm(2), when the MAPbI(3) grain size was increased from 150 nm to 350 nm, the current density, respectively, increased from 8 to 17 mA cm(-2) and the photoelectric conversion efficiency from 6.1% to 11.4%. When a PSC with 0.54 cm(2) active area size had a compact TiO2 layer that had a lower R-ms of about 3 nm, the average MAPbI(3) grain size was between 300 nm and 400 nm, and the resulting efficiency for a PSC was 114%, and that with 0.16 cm(2) was 13.6%. When the MAPbI(3) grain size was increased, the shunt resistance increased and the serial resistance decreased. The increased MAPbI(3) grain size is clearly a crucial parameter to attain higher efficiency in PSCs.