3.8 Article

Application of X-ray Diffraction for Residual Stress Analysis in Truncated Cones Made by Incremental Forming

Journal

Publisher

LUBLIN UNIV TECHNOLOGY, POLAND
DOI: 10.12913/22998624/118829

Keywords

drawpiece; incremental forming; ISF; steel sheet

Ask authors/readers for more resources

The final accuracy of the parts formed using single point incremental forming greatly depends on the mechanical properties of the material to be formed and the residual stress formation. In this paper, an X-ray diffraction technique was used to study the distribution of the residual stress along the generating line of the conical drawpiece. A DC04 steel sheet with a thickness of 0.8 mm was used as a test material. The basic mechanical properties of the DC04 sheet metal were determined in the uniaxial tensile test according to the EN ISO 6892-1:2016. It was found that the maximum amount of the residual stress existed in a point located in the midway between a base and a truncation of the drawpiece. In the outer surface of the drawpiece, the orange peel defect associated with a rough surface appearance after SPIF a drawpiece, was observed. In contrast, the inner surface of component was characterized by linear grooves associated with the interaction of tool tip with the sheet surface. This defect is mainly influenced by vertical step size.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

3.8
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available