Related references
Note: Only part of the references are listed.Regimes of jetting and bubbling in a fluidized bed studied using real-time magnetic resonance imaging
A. Penn et al.
CHEMICAL ENGINEERING JOURNAL (2020)
Separate degree based Otsu and signed similarity driven level set for segmenting and counting anthrax spores
Yaochi Zhao et al.
COMPUTERS AND ELECTRONICS IN AGRICULTURE (2020)
Incoherent, non-invasive and non-scanning superoscillation-based microscope for super-resolution imaging
Qingkun Xie et al.
OPTICS COMMUNICATIONS (2020)
Coupled CFD-PBM simulation of bubble size distribution in a 2D gas-solid bubbling fluidized bed with a bubble coalescence and breakup model
Teng Wang et al.
CHEMICAL ENGINEERING SCIENCE (2019)
Micromechanical analysis of bubbles formed in fluidized beds operated with a continuous single jet
S. Shrestha et al.
POWDER TECHNOLOGY (2019)
A comparative study of induced and transferred charges for mass flow rate measurement of pneumatically conveyed particles
Yonghui Hu et al.
POWDER TECHNOLOGY (2019)
Improved models for predicting bubble velocity, bubble frequency and bed expansion in a bubbling fluidized bed
Cornelius Emeka Agu et al.
CHEMICAL ENGINEERING RESEARCH & DESIGN (2019)
Comparative study of two non-intrusive measurement methods for bubbling gas-solids fluidized beds: Electrical capacitance tomography and pressure fluctuations
Xiaoxu Li et al.
FLOW MEASUREMENT AND INSTRUMENTATION (2018)
A perspective on electrostatics in gas-solid fluidized beds: Challenges and future research needs
Farzam Fotovat et al.
POWDER TECHNOLOGY (2018)
Monitoring of particle motions in gas-solid fluidized beds by electrostatic sensors
Yao Yang et al.
POWDER TECHNOLOGY (2017)
Experimental study on the pressure wave attenuation across gas-solid fluidized bed by single bubble injection
Kamal Nosrati et al.
POWDER TECHNOLOGY (2017)
Electrostatics in gas-solid fluidized beds: A review
Farzam Fotovat et al.
CHEMICAL ENGINEERING SCIENCE (2017)
Measurement of the Mass Flow and Velocity Distributions of Pulverized Fuel in Primary Air Pipes Using Electrostatic Sensing Techniques
Xiangchen Qian et al.
IEEE TRANSACTIONS ON INSTRUMENTATION AND MEASUREMENT (2017)
Measurement of Charge Distributions in a Bubbling Fluidized Bed Using Wire-Mesh Electrostatic Sensors
Wenbiao Zhang et al.
IEEE TRANSACTIONS ON INSTRUMENTATION AND MEASUREMENT (2017)
Measurement of Flow Characteristics in a Bubbling Fluidized Bed Using Electrostatic Sensor Arrays
Wenbiao Zhang et al.
IEEE TRANSACTIONS ON INSTRUMENTATION AND MEASUREMENT (2016)
Non-intrusive measurement and hydrodynamics characterization of gas-solid fluidized beds: a review
Jingyuan Sun et al.
MEASUREMENT SCIENCE AND TECHNOLOGY (2016)
Application of electrical capacitance tomography in particulate process measurement - A review
Wenbiao Zhang et al.
ADVANCED POWDER TECHNOLOGY (2014)
Hydrodynamics of a fluidized bed co-combustor for tobacco waste and coal
Kai Zhang et al.
BIORESOURCE TECHNOLOGY (2012)
Bubble Size Distribution in Two-Dimensional Gas-Solid Fluidized Beds
S. Movahedirad et al.
INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2012)
Magnetic resonance studies of a gas-solids fluidised bed: Jet-jet and jet-wall interactions
Meenal Pore et al.
PARTICUOLOGY (2010)
Charge distribution around a rising bubble in a two-dimensional fluidized bed by signal reconstruction
Aihua Chen et al.
POWDER TECHNOLOGY (2007)
Sensing characteristics of electrostatic inductive sensor for flow parameters measurement of pneumatically conveyed particles
Chuanlong Xu et al.
JOURNAL OF ELECTROSTATICS (2007)
Rise velocities of bubbles and slugs in gas-fluidised beds: Ultra-fast magnetic resonance imaging
C. R. Muller et al.
CHEMICAL ENGINEERING SCIENCE (2007)
Share Paper
