4.6 Article

Ni substitution effect on the structure, magnetization, resistivity and permeability of zinc ferrites

Journal

JOURNAL OF MATERIALS CHEMISTRY C
Volume 9, Issue 16, Pages 5425-5436

Publisher

ROYAL SOC CHEMISTRY
DOI: 10.1039/d0tc05692h

Keywords

-

Funding

  1. Government of the Russian Federation [A03.21.0011]
  2. RFBR [20-38-70057]
  3. Ministry of Science and High Education of the Russian Federation [P02-2017-2-4]

Ask authors/readers for more resources

Zn1-xNixFe2O4 ferrites were synthesized using solid state reactions and the sol-gel autocombustion technique, with the obtained samples exhibiting a spinel structure. The magnetic characteristics, Curie point variation, and electrical properties were determined for different compositions, showing a decrease in unit cell parameters with increasing nickel concentration. The composite samples with paraffin wax showed significant reductions in permeability.
Zn1-xNixFe2O4 ferrites up to x = 1.0 with Delta x = 0.2 have been synthesized via solid state reactions and the sol-gel autocombustion technique with step-by-step co-firing. Data on the chemical composition and the surface morphology of the samples have been obtained using a scanning electron microscope. An X-ray powder diffractometer has been used to establish the phase purity and to determine the unit cell parameters. It has been found that the obtained samples had a spinel structure with the Fd3m (No. 227) space group. The unit cell parameters decrease with increasing nickel concentration. The a unit cell parameter decreases almost linearly from similar to 8.443 angstrom for x = 0.0 down to similar to 8.337 angstrom for x = 1.0. The V unit cell volume decreases almost linearly from similar to 601.72 angstrom(3) for x = 0.0 down to similar to 579.52 angstrom(3) for x = 1.0. The magnetic characteristics of the obtained samples are determined and discussed. The Curie point of obtained samples varies in the range of 803.5-572.7 K. The maximum spontaneous magnetization of similar to 74.6 emu g(-1) at room temperature was fixed for the solid solution with x = 0.6. Ac-resistivity drops by more than 3 orders of magnitude in the frequency range 1-10(6) Hz. The composition with x = 0.6 has the minimum ac-resistivity of 5.3 kOm cm at a frequency of 10(6) Hz. The maximum value of the (mu ') real part of similar to 11.2 and (mu '') imaginary part of similar to 5.2 of the permeability in the frequency range of 50 MHz-10 GHz is observed for the composition with x = 0.4. The composite samples for the microwave study were prepared by mixing of the ferrite powders with molten paraffin wax. The volume fraction of the ferrite filler in the composites was 25%. The largest value of the (mu ') real part of similar to 3 and (mu '') imaginary part of similar to 0.63 of permeability is found for the x = 0.4 composite. The formation of the composite significantly reduces permeability.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.6
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available