Related references
Note: Only part of the references are listed.Acceleration self-compensation mechanism and experimental research on shock wave piezoelectric pressure sensor
Guicong Wang et al.
MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2021)
Investigation of vibration effect on dynamic calibration of pressure sensors based on shock tube system
Kuan Diao et al.
MEASUREMENT (2020)
A dynamic pressure calibration device based on the low speed servomotor and pistonphone technique
Di Liu et al.
MEASUREMENT (2020)
Research on piezoelectric pressure sensor for shock wave load measurement
Yingjun Li et al.
ISA TRANSACTIONS (2020)
An indirect comparison quasi-static calibration method for piezoelectric pressure sensors based on an inverse model
Chuanrong Zhao et al.
MEASUREMENT (2020)
A coarse-to-fine denoising method for dynamic calibration signals of pressure sensor based on adaptive mode decompositions
Zhenjian Yao et al.
MEASUREMENT (2020)
Numerical modeling and analysis of the pressure pulses generator for the dynamic calibration of high-pressure transducers
Lamine Elkarous et al.
APPLIED ACOUSTICS (2019)
A traceable dynamic calibration research of the measurement system based on quasi-static and dynamic calibration for accurate blast overpressure measurement
Fan Yang et al.
MEASUREMENT SCIENCE AND TECHNOLOGY (2019)
Development of a dynamic pressure generator based on a loudspeaker with improved frequency characteristics
M. Stefe et al.
MEASUREMENT (2018)
A calculation and uncertainty evaluation method for the effective area of a piston rod used in quasi-static pressure calibration
Tingwei Gu et al.
MEASUREMENT SCIENCE AND TECHNOLOGY (2018)
Investigation of polytropic corrections for the piston-in-cylinder primary standard used in dynamic calibrations of pressure sensors
A. Svete et al.
SENSORS AND ACTUATORS A-PHYSICAL (2018)
Dynamic modeling of liquid impulse pressure generator for calibration of pressure sensors
Jun Yang et al.
SENSORS AND ACTUATORS A-PHYSICAL (2018)
Accurate measurement of high-frequency blast waves through dynamic compensation of miniature piezoelectric pressure sensors
Fan Yang et al.
SENSORS AND ACTUATORS A-PHYSICAL (2018)
Development of a primary standard for dynamic pressure based on drop weight method covering a range of 10 MPa-400 MPa
J. Salminen et al.
METROLOGIA (2018)
Measurement correction method for force sensor used in dynamic pressure calibration based on artificial neural network optimized by genetic algorithm
Tingwei Gu et al.
METROLOGIA (2017)
Pressure prediction model based on artificial neural network optimized by genetic algorithm and its application in quasi-static calibration of piezoelectric high-pressure sensor
Tingwei Gu et al.
REVIEW OF SCIENTIFIC INSTRUMENTS (2016)
Dynamic pressure generator for dynamic calibrations at different average pressures based on a double-acting pneumatic actuator
A. Svete et al.
SENSORS AND ACTUATORS A-PHYSICAL (2016)
Novel method for estimating the dynamic characteristics of pressure sensor in shock tube calibration test
Qiang Li et al.
REVIEW OF SCIENTIFIC INSTRUMENTS (2015)
Novel Method for Processing the Dynamic Calibration Signal of Pressure Sensor
Zhongyu Wang et al.
SENSORS (2015)
Mathematical modelling to support traceable dynamic calibration of pressure sensors
C. Matthews et al.
METROLOGIA (2014)
High dynamic pressure standard based on the density change of the step pressure generator
In-Mook Choi et al.
METROLOGIA (2013)
Linking dynamic to static pressure by laser interferometry
Th Bruns et al.
METROLOGIA (2013)
Dynamic calibration method of high-pressure transducer based on quasi-δ function excitation source
Yu Zhang et al.
MEASUREMENT (2012)
Frequency analysis of a step dynamic pressure calibrator
In-Mook Choi et al.
REVIEW OF SCIENTIFIC INSTRUMENTS (2012)
Hydraulic square-wave pressure generator with a specific rotating valve
S. H. Wang et al.
MEASUREMENT (2009)
Evaluation of dynamic performance of pressure sensors using a pressure square-like wave generator
TT Tsung et al.
MEASUREMENT SCIENCE AND TECHNOLOGY (2004)
Share Paper
