4.6 Article

A flexible in-plane p-n heterojunction nano-generator with phonon-enhanced photothermoelectric effect to harvest solar energy

Journal

JOURNAL OF MATERIALS CHEMISTRY A
Volume 9, Issue 26, Pages 14958-14968

Publisher

ROYAL SOC CHEMISTRY
DOI: 10.1039/d1ta02946k

Keywords

-

Funding

  1. Anhui Provincial Natural Science Foundation [1908085QF251]
  2. National Natural Science Foundation of China [11704002]
  3. Natural Science Foundation of Anhui Province in China [1608085ME99]
  4. Support Project of Outstanding Young Talents in Anhui Provincial Universities [gxyqZD2018006]
  5. Anhui Provincial Major Scientific and Technological Special Project [17030701062]

Ask authors/readers for more resources

The study introduces a novel composite film capable of collecting solar energy from visible to infrared spectrum by forming a p-n heterojunction. A nano-generator utilizing this composite film demonstrates the ability to harvest solar energy and achieve voltage output through the photovoltaic and photo-thermoelectric effects.
Photothermoelectric (PTE) devices show a promising prospect for realizing photo-induced output voltage using infrared light, which can meet the crucial requirements for photodetectors and power supply. However, limited utilization of visible light partly weakens the ability of harvesting solar energy. Particularly, an as-prepared composite (CM) film with the unique ability to harvest solar light with a broadband spectrum from visible to infrared was presented in this study. An enlarged light harvesting range was obtained by forming an in-plane p-n heterojunction between p-type multi-walled carbon nanotubes (MWCNTs) and an n-type Ti3C2Tx nanosheet (MXene) film. When the interface between MWCNTs and MXene was irradiated using lasers of 405, 520, 635, 808 and 1064 nm, spontaneous separations of photogenerated electron-hole pairs originated from the photovoltaic (PV) effect (405, 520, 635 and 808 nm) and PTE effect (1064 nm). A nano-generator with ten CM films was fabricated to harvest solar energy. The PV voltage always had a fixed value as a function of incident light intensity, while the PTE voltage could be increased by adjusting the temperature difference. Finally, the peak value of the total output voltage increased to a stable value of 2.0 mV for the CM film under the irradiation of AM 1.5 G simulated sunlight. This study not only introduces the carrier separation and transmission mechanism by means of the co-action between the built-in electric field of the p-n heterojunction and thermal field, but also provides a new suggestion for better utilization of solar energy.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.6
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available