4.0 Article

Postcombustion CO2 Capture: A Comparative Techno-Economic Assessment of Three Technologies Using a Solvent, an Adsorbent, and a Membrane

Related references

Note: Only part of the references are listed.
Article Green & Sustainable Science & Technology

Techno-economic assessment of post-combustion CO2 capture using aqueous piperazine at different flue gas compositions and flowrates via a general optimization methodology

Jose-Francisco Perez-Calvo et al.

Summary: This study presents an overall techno-economic assessment of a post-combustion CO2 capture process using aqueous piperazine. A two-step techno-economic optimization approach is developed to minimize work and maximize productivity. The results show that the specific reboiler duties increase as the flue gas CO2 concentrations decrease, while the costs are computed at the technical optimal conditions as a function of CO2 capture efficiency, flue gas flowrate, and CO2 concentration. Maps of minimum cost and associated optimal conditions are obtained to evaluate the economic feasibility and performance of the capture process under different cost scenarios and assumptions.

INTERNATIONAL JOURNAL OF GREENHOUSE GAS CONTROL (2022)

Article Green & Sustainable Science & Technology

Beyond 90% capture: Possible, but at what cost?

Patrick Brandl et al.

Summary: Carbon capture and storage (CCS) technologies are crucial for meeting climate change mitigation targets. While a 90% CO2 capture rate is commonly assumed, going beyond this rate is necessary for achieving a 1.5 degrees C target, with residual emissions needing to be indirectly captured through carbon dioxide removal technologies.

INTERNATIONAL JOURNAL OF GREENHOUSE GAS CONTROL (2021)

Article Engineering, Chemical

Techno-economic assessment of optimised vacuum swing adsorption for post-combustion CO2 capture from steam-methane reformer flue gas

Sai Gokul Subraveti et al.

Summary: This study focuses on the techno-economic assessment and optimization of CO2 capture and storage technology based on vacuum swing adsorption (VSA) process. Different adsorbents were optimized to minimize CO2 capture costs, with the IISERP MOF2 outperforming other options. The importance of using cost as a means of evaluating separation techniques was highlighted, along with the consideration of factors such as vacuum pump efficiency and material costs.

SEPARATION AND PURIFICATION TECHNOLOGY (2021)

Article Chemistry, Physical

Measurement of competitive CO2 and H2O adsorption on zeolite 13X for post-combustion CO2 capture

Nicholas Stiles Wilkins et al.

ADSORPTION-JOURNAL OF THE INTERNATIONAL ADSORPTION SOCIETY (2020)

Article Energy & Fuels

Comparison of Technologies for CO2 Capture from Cement ProductionPart 2: Cost Analysis

Stefania Osk Gardarsdottir et al.

ENERGIES (2019)

Article Green & Sustainable Science & Technology

Pilot plant demonstration of piperazine with the advanced flash stripper

Gary T. Rochelle et al.

INTERNATIONAL JOURNAL OF GREENHOUSE GAS CONTROL (2019)

Article Engineering, Chemical

110th Anniversary: Process Developments in Carbon Dioxide Capture Using Membrane Technology

Sandra E. Kentish

INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2019)

Article Chemistry, Multidisciplinary

Process Optimization-Based Screening of Zeolites for Post-Combustion CO2 Capture by Vacuum Swing Adsorption

Vishal Subramanian Balashankar et al.

ACS SUSTAINABLE CHEMISTRY & ENGINEERING (2019)

Article Engineering, Chemical

MO-MCS, a Derivative-Free Algorithm for the Multiobjective Optimization of Adsorption Processes

Federico Capra et al.

INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2018)

Review Engineering, Chemical

Recent advances on the membrane processes for CO2 separation

Jiayou Xu et al.

CHINESE JOURNAL OF CHEMICAL ENGINEERING (2018)

Article Engineering, Chemical

Postcombustion CO2 Capture from Wet Flue Gas by Temperature Swing Adsorption

Max Hefti et al.

INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2018)

Article Green & Sustainable Science & Technology

Modeling of absorber pilot plant performance for CO2 capture with aqueous piperazine

Yue Zhang et al.

INTERNATIONAL JOURNAL OF GREENHOUSE GAS CONTROL (2017)

Article Engineering, Chemical

Extended field trials of Polaris sweep modules for carbon capture

Lloyd S. White et al.

JOURNAL OF MEMBRANE SCIENCE (2017)

Article Engineering, Chemical

On the optimal design of membrane-based gas separation processes

Paolo Gabrielli et al.

JOURNAL OF MEMBRANE SCIENCE (2017)

Article Engineering, Environmental

Cost-optimal CO2 capture ratio for membrane-based capture from different CO2 sources

Simon Roussanaly et al.

CHEMICAL ENGINEERING JOURNAL (2017)

Article Engineering, Chemical

Rational design of temperature swing adsorption cycles for post-combustion CO2 capture

Lisa Joss et al.

CHEMICAL ENGINEERING SCIENCE (2017)

Article Engineering, Environmental

Carbon Capture in the Cement Industry: Technologies, Progress, and Retrofitting

Thomas Hills et al.

ENVIRONMENTAL SCIENCE & TECHNOLOGY (2016)

Article Engineering, Chemical

Optimization of Two-Stage Pressure/Vacuum Swing Adsorption with Variable Dehydration Level for Postcombustion Carbon Capture

Karson T. Leperi et al.

INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2016)

Article Chemistry, Physical

Pilot plant test of the advanced flash stripper for CO2 capture

Yu-Jeng Lin et al.

FARADAY DISCUSSIONS (2016)

Article Engineering, Chemical

Membrane properties required for post-combustion CO2 capture at coal-fired power plants

Simon Roussanaly et al.

JOURNAL OF MEMBRANE SCIENCE (2016)

Article Chemistry, Physical

Pilot plant test of the advanced flash stripper for CO2 capture

Yu-Jeng Lin et al.

FARADAY DISCUSSIONS (2016)

Article Engineering, Chemical

Energy and cost estimates for capturing CO2 from a dry flue gas using pressure/vacuum swing adsorption

Naresh Susarla et al.

CHEMICAL ENGINEERING RESEARCH & DESIGN (2015)

Article Green & Sustainable Science & Technology

Rate-based model development, validation and analysis of chilled ammonia process as an alternative CO2 capture technology for coal-fired power plants

Dawid P. Hanak et al.

INTERNATIONAL JOURNAL OF GREENHOUSE GAS CONTROL (2015)

Article Chemistry, Applied

Adsorption equilibrium of binary mixtures of carbon dioxide and nitrogen on zeolites ZSM-5 and 13X

Max Hefti et al.

MICROPOROUS AND MESOPOROUS MATERIALS (2015)

Article Engineering, Chemical

Cold Rich Bypass to Strippers for CO2 Capture by Concentrated Piperazine

David H. Van Wagener et al.

CHEMICAL ENGINEERING & TECHNOLOGY (2014)

Review Chemistry, Multidisciplinary

Carbon capture and storage update

M. E. Boot-Handford et al.

ENERGY & ENVIRONMENTAL SCIENCE (2014)

Article Green & Sustainable Science & Technology

Process modifications for solvent-based post-combustion CO2 capture

Yann Le Moullec et al.

INTERNATIONAL JOURNAL OF GREENHOUSE GAS CONTROL (2014)

Proceedings Paper Chemistry, Applied

Evaluation of reclaimer sludge disposal from post-combustion CO2 capture

A. Sexton et al.

12TH INTERNATIONAL CONFERENCE ON GREENHOUSE GAS CONTROL TECHNOLOGIES, GHGT-12 (2014)

Article Engineering, Chemical

Cycle Synthesis and Optimization of a VSA Process for Postcombustion CO2 Capture

Reza Haghpanah et al.

AICHE JOURNAL (2013)

Article Engineering, Environmental

Techno-Economic Assessment of Polymer Membrane Systems for Postcombustion Carbon Capture at Coal-Fired Power Plants

Haibo Zhai et al.

ENVIRONMENTAL SCIENCE & TECHNOLOGY (2013)

Article Chemistry, Physical

Fixed bed adsorption of CO2/H2 mixtures on activated carbon: experiments and modeling

Nathalie Casas et al.

ADSORPTION-JOURNAL OF THE INTERNATIONAL ADSORPTION SOCIETY (2012)

Review Chemistry, Multidisciplinary

Carbon Dioxide Capture in Metal-Organic Frameworks

Kenji Sumida et al.

CHEMICAL REVIEWS (2012)

Review Engineering, Chemical

Post-Combustion CO2 Capture Using Solid Sorbents: A Review

Arunkumar Samanta et al.

INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2012)

Review Thermodynamics

Recent developments in membrane-based technologies for CO2 capture

Patricia Luis et al.

PROGRESS IN ENERGY AND COMBUSTION SCIENCE (2012)

Article Chemistry, Physical

Arithmetic approach for complex PSA cycle scheduling

Amal Mehrotra et al.

ADSORPTION-JOURNAL OF THE INTERNATIONAL ADSORPTION SOCIETY (2010)

Review Chemistry, Multidisciplinary

An overview of CO2 capture technologies

Niall MacDowell et al.

ENERGY & ENVIRONMENTAL SCIENCE (2010)

Article Engineering, Chemical

Power plant post-combustion carbon dioxide capture: An opportunity for membranes

Tim C. Merkel et al.

JOURNAL OF MEMBRANE SCIENCE (2010)

Article Engineering, Chemical

Membrane technologies for CO2 separation

A. Brunetti et al.

JOURNAL OF MEMBRANE SCIENCE (2010)

Review Chemistry, Multidisciplinary

State-of-the-art Adsorption and Membrane Separation Processes for Carbon Dioxide Production from Carbon Dioxide Emitting Industries

Armin D. Ebner et al.

SEPARATION SCIENCE AND TECHNOLOGY (2009)

Article Chemistry, Physical

Heavy reflux PSA cycles for CO2 recovery from flue gas:: Part I.: Performance evaluation

Steven P. Reynolds et al.

ADSORPTION-JOURNAL OF THE INTERNATIONAL ADSORPTION SOCIETY (2008)

Article Chemistry, Physical

Capture of CO2 from flue gas streams with zeolite 13X by vacuum-pressure swing adsorption

Penny Xiao et al.

ADSORPTION-JOURNAL OF THE INTERNATIONAL ADSORPTION SOCIETY (2008)

Article Engineering, Chemical

Experimental investigation on CO2 post-combustion capture by indirect thermal swing adsorption using 13X and 5A zeolites

Jerome Merel et al.

INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2008)

Article Thermodynamics

Approximate design and costing methods for heat exchangers

Geoff F. Hewitt et al.

HEAT TRANSFER ENGINEERING (2007)

Article Chemistry, Applied

An experimental adsorbent screening study for CO2 removal from N2

PJE Harlick et al.

MICROPOROUS AND MESOPOROUS MATERIALS (2004)