Journal
DENTISTRY JOURNAL
Volume 9, Issue 8, Pages -Publisher
MDPI
DOI: 10.3390/dj9080083
Keywords
composite resins; polymerization; biofilms; curing lights; dental; surface properties
Categories
Funding
- University of Maryland School of Dentistry
Ask authors/readers for more resources
The study evaluated the effects of different light-curing conditions on the degree of conversion, Streptococcus mutans biofilm growth, and surface roughness. It revealed that improper light-curing procedures can decrease the degree of conversion, increase biofilm formation, and result in higher surface roughness.
How dentists cure a resin-based material has deleterious effects on the material's properties and its interaction with surrounding dental tissues. Biofilm accumulation has been implicated in the pathogenesis of carious lesions around dental restorations, with its composition manifesting expressed dysbiosis in patients suffering from dental caries. To evaluate the influence of varying radiant exposure on the degree of conversion (DC%), Streptococcus mutans biofilm growth, and surface roughness of bulk-fill composites under different light-curing conditions. Two light-curing units (LCU) at 600 and 1000 mW/cm(2) were used to simulate curing conditions with different angulations ( spherical angle 20 degrees and spherical angle 35 degrees) or 2 mm-distance displacements of the LCU tip. The radiant exposure (RE) was assessed, and the composites were analyzed for DC%. Biofilm formation was induced over the bulk-fill composites and analyzed via colony-forming units counting and scanning electron microscopy (SEM). The surface roughness was analyzed via a profilometer and SEM after biofilm formation. Curing conditions with different angulation or displacement decreased RE compared to the optimal condition. The moderately ( spherical angle 35 degrees) angulated LCU tip and low (600 mW/cm(2)) radiant emittance significantly reduced the DC% (p < 0.05). The difference in DC% between the top and bottom of the composites ranged from 8 to 11% for 600 mW/cm(2) and 10 to 20% for 1000 mW/cm(2). Greater S. mutans biofilm and surface changes were found in composites with non-optimal RE delivery (e.g., tip displacement and angulation) (p < 0.05). Inadequate polymerization of bulk-fill composites was associated with more biofilm accumulation and surface topography changes. Overall, non-optimally performed curing procedures reduced the amount of delivered RE, which led to low DC%, more biofilm formation, and higher surface roughness. The improper light-curing of bulk-fill composites compromises their physicochemical and biological properties, which could lead to inferior clinical performance and reduced restorative treatments' longevity.
Authors
I am an author on this paper
Click your name to claim this paper and add it to your profile.
Reviews
Recommended
No Data Available