4.6 Article

Optoelectronic property comparison for isostructural Cu2BaGeSe4 and Cu2BaSnS4 solar absorbers

Journal

JOURNAL OF MATERIALS CHEMISTRY A
Volume 9, Issue 41, Pages 23619-23630

Publisher

ROYAL SOC CHEMISTRY
DOI: 10.1039/d1ta05666b

Keywords

-

Funding

  1. U.S. Department of Energy, Office of Science, Basic Energy Sciences (BES) [DE-SC0020061]
  2. National Science Foundation [ECCS-2025064]
  3. U.S. Department of Energy (DOE) [DE-SC0020061] Funding Source: U.S. Department of Energy (DOE)

Ask authors/readers for more resources

A new class of chalcogenides, Cu2BaGeSe4 (CBGSe) and Cu2BaSnS4 (CBTS), has been introduced to mitigate anti-site defect formation in Cu2ZnSnS4-xSex. CBGSe films exhibit higher hole carrier concentration, lower mobility, and pronounced deep-level emission compared to CBTS films. The prototype CBGSe solar cells show an efficiency of 1.5% with a 0.62 V open-circuit voltage, pointing to possible limiting factors for CBGSe and related films in PV and optoelectronics applications.
To target mitigation of anti-site defect formation in Cu2ZnSnS4-xSex, a new class of chalcogenides, for which Ba or Sr (group 2) replace Zn (group 12), has recently been introduced for prospective solar absorber application. Cu2BaGeSe4 (CBGSe) and Cu2BaSnS4 (CBTS) are two such compounds, which share a common trigonal crystal structure (P3(1) space group) and similar quasi-direct band gap (similar to 2 eV). While CBTS-based films have already been studied, there are no reports yet on films and solar cells based on related CBGSe. To identify key differences and similarities in the electronic properties between these two materials, electronic characteristics (e.g., carrier concentration, mobility, electron affinity, defect levels, recombination, and charge carrier kinetics) of vacuum-deposited CBGSe and CBTS films are compared using a variety of characterization methods. Hall effect measurements reveal that CBGSe films have relatively higher hole carrier concentration and lower mobility (3 x 10(15) cm(-3), 0.6 cm(2) V-1 s(-1)) compared to CBTS (5 x 10(12) cm(-3), 3.5 cm(2) V-1 s(-1)). Photoelectron spectroscopy yields low electron affinity values for both CBGSe (3.7 eV) and CBTS (3.3 eV), pointing to the necessity of pursuing low electron affinity buffer materials for both types of absorbers. At low temperatures, CBGSe films show free-exciton photoluminescence, as well as pronounced deep-level emission at similar to 1.4 eV, while CBTS films exhibit a strong bound-exciton signal with noticeably less intense deep-level emission than for CBGSe. Charge carrier kinetics, transport, and recombination properties of both types of films are also analyzed using optical-pump terahertz-probe spectroscopy and time-resolved microwave conductivity. The first CBGSe prototype solar cells (using chemical bath deposited CdS as a buffer layer) show a maximum of 1.5% efficiency with similar to 0.62 V open-circuit voltage. The measured properties point to possible limiting factors for CBGSe and related films for PV and optoelectronics and provide insights on possible approaches for improvement within this multinary chalcogenide family.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.6
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available