4.6 Article

An Al-doped TiO2 interfacial layer for effective hole injection characteristics of quantum-dot light-emitting diodes

Journal

JOURNAL OF MATERIALS CHEMISTRY C
Volume 10, Issue 18, Pages 7294-7303

Publisher

ROYAL SOC CHEMISTRY
DOI: 10.1039/d2tc00678b

Keywords

-

Funding

  1. National Research Foundation of Korea [2020R1A6A1A03048004, 2021R1A2C1009442]
  2. Korea Basic Science Institute (National research Facilities and Equipment Center) - Ministry of Education [2021R1A6C101A437]
  3. National Research Foundation of Korea [2021R1A2C1009442, 2021R1A6C101A437] Funding Source: Korea Institute of Science & Technology Information (KISTI), National Science & Technology Information Service (NTIS)

Ask authors/readers for more resources

This paper presents the use of an Al-doped TiO2 (ATO) interfacial layer to improve the charge balance in QLEDs, resulting in enhanced luminance and efficiency. The study demonstrates that a better interfacial energy level alignment can be achieved by increasing the number of oxygen vacancies and titanium defect sites. With the optimized ATO interfacial layer, QLEDs exhibit improved luminance, current efficiency, and device lifetime.
The charge imbalance in quantum-dot light-emitting diodes (QLEDs) is a major hindrance in improving the performance of related devices. To realize high efficiency and stability of QLEDs with a high luminance behavior, the charge balance optimization of QLEDs should be achieved by introducing interfacial layers such as hole-transporting and electron-blocking layers. In this paper, we report an Al-doped TiO2 (ATO) interfacial layer to improve the charge balance for enhancing the luminance and efficiency of QLEDs. We focused on Al doping modulation in TiO2 for increasing the number of defect sites, which was confirmed through X-ray photoelectron spectroscopy (XPS). The photoluminescence spectra were analyzed to locate the oxygen vacancies and defect sites inside the ATO film. These findings suggested that a better interfacial energy level alignment can be achieved by both intrinsic defect sites related to oxygen vacancies and the induced titanium defect sites in TiO2. QLEDs with an optimized ATO interfacial layer showed a luminance and current efficiency of 119 516 Cd m(-2) and 18.46 Cd A(-1), respectively. The lifetime of the device was 12 hours, which was almost four times greater than that of the device without the ATO interfacial layer. This study shows that the enhanced hole injection from the ITO anode into the V2O5 hole injection layer (HIL) can be achieved by inserting an ATO interfacial layer. Also, a well-aligned energy level in QLEDs can help to improve the performance of the device.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.6
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available