4.6 Article

Naphthalene diimide-based random terpolymer acceptors for constructing all-polymer solar cells with enhanced fill factors

Journal

RSC ADVANCES
Volume 12, Issue 28, Pages 17898-17904

Publisher

ROYAL SOC CHEMISTRY
DOI: 10.1039/d2ra03062d

Keywords

-

Funding

  1. Guangdong Basic and Applied Basic Research Foundation [2019A1515011141]
  2. characteristic Innovation Project for Higher Education Institution of Guangdong Province [2019KTSCX170]

Ask authors/readers for more resources

In this study, a series of NDI-based terpolymer acceptors were synthesized by adding a small amount of DCB unit to the NDI-based polymer acceptor N2200 through random copolymerization. PNDI5 and PNDI10 showed better crystallization and miscibility with PBDB-T compared to the terpolymer based on DCB-free N2200. Moreover, the PNDI5-based device exhibited a higher PCE and an enhanced FF in all-PSCs.
All-polymer solar cells (all-PSCs) with mechanical and thermal stability have potential for applications in flexible devices. Polymer acceptors based on naphthalene diimide (NDI) have been widely studied because of their strong electron affinity, high electron mobility, and high mechanical reliability. However, controlling the film morphology of the polymer-polymer blends of NDI-based all-PSCs is difficult. Consequently, all-PSCs based on NDI building blocks exhibit a low fill factor (FF) and a lower power-conversion efficiency (PCE) than state-of-the-art polymer solar cells. In this work, we added a small amount of dicyanodistyrylbenzene (DCB) unit to the NDI-based polymer acceptor N2200 through random copolymerization and synthesized a series of NDI-based terpolymer acceptors PNDIx, where x is the molar concentration of DCB units relative to NDI units. PNDI5 and PNDI10, corresponding to 5% and 10% molar concentrations of DCB, respectively, showed lower crystallization and good miscibility with PBDB-T, a widely used electron-donating copolymer, than the terpolymer based on DCB-free N2200. Moreover, compared to the PBDB-T:N2200 device, the PNDI5-based device exhibited a much higher PCE (8.01%), and an enhanced FF of 0.75 in all-PSCs. These results indicate that ternary random copolymerization is a convenient and effective strategy for optimizing the film morphology of NDI-based polymers, and that the resulting terpolymer acceptor is a promising n-type acceptor for constructing high-performance all-PSCs.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.6
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available