4.5 Review

Factors that influence the performance of hydrogen detectors based on single-wall carbon nanotubes

Related references

Note: Only part of the references are listed.
Article Engineering, Electrical & Electronic

Improved Hydrogen Gas Sensing Performance of Carbon Nanotube Synthesized Using Microwave Oven

Ahmad M. Al-Diabat et al.

Summary: The performance of a hydrogen gas sensor based on carbon nanotubes can be greatly improved through acid treatment or functionalization.

IEEE SENSORS JOURNAL (2023)

Article Chemistry, Inorganic & Nuclear

NiN4S-doped single walled carbon nanotube as an ultrafast H2 gas sensor: A DFT simulation

Sahar Imeni et al.

Summary: In this study, the capability of NiN4S-doped single wall carbon nanotube (NiN4S-doped SWCNT) as a sensor material for detecting H2 gas at room temperature was investigated and compared with pristine single wall carbon nanotube (SWCNT). The results showed that the adsorption capacity of H2 on NiN4S-doped SWCNT was significantly improved compared to pristine SWCNT. It was found that the adsorption occurred via typical van der Waals interactions. Therefore, NiN4S-doped SWCNT can be considered as an ultrafast and efficient material for H2 sensing.

INORGANIC CHEMISTRY COMMUNICATIONS (2023)

Review Chemistry, Analytical

Wearable Electrochemical Sensors Based on Nanomaterials for Healthcare Applications

Xin Tong et al.

Summary: This review provides an overview of the importance of wearable electrochemical sensors in healthcare applications and discusses the concepts, methods, and manufacturing techniques related to nanoparticles. The future challenges and prospects of wearable electrochemical sensors based on nanoparticles are also discussed.

ELECTROANALYSIS (2023)

Article Polymer Science

Introduction of SWCNTs as a Method of Improvement of Electrical and Mechanical Properties of CFRPs Based on Thermoplastic Acrylic Resin

Szymon Demski et al.

Summary: The aim of this research was to improve the electrical and mechanical properties of carbon-fibre-reinforced polymers (CFRP) based on thermoplastic acrylic resin ELIUM (R), by introducing single-walled carbon nanotubes (SWCNTs) into their structure. The laminates were fabricated using the infusion technique of infiltrating the carbon fabric with the mixture of acrylic resin and SWCNTs. The addition of SWCNTs improved the electrical conductivity through the thickness of the laminate by several times compared to the laminate without modification, and also enhanced the mechanical properties of the material.

POLYMERS (2023)

Article Chemistry, Analytical

The Influence of Surfactants on the Deposition and Performance of Single-Walled Carbon Nanotube-Based Gas Sensors for NO2 and NH3 Detection

Antonio Orlando et al.

Summary: Solid-state chemiresistive gas sensors, particularly those based on carbon nanotubes, have received significant research attention due to their high sensitivity, low power consumption, low cost, and portability. This study explores the use of single-walled carbon nanotube (SWCNT)-based sensing films deposited by spray deposition for gas sensor fabrication. Different surfactants were utilized during deposition to investigate their impact on sensor performance. The results showed high selectivity towards ammonia (NH3) and nitrogen dioxide (NO2), with enhanced responses under humid conditions and at elevated temperatures. The best sensing conditions were achieved against NO2, utilizing sensors with 10 layers of deposition and operating at 150 degrees C.

CHEMOSENSORS (2023)

Article Chemistry, Multidisciplinary

A High-Performance, Sensitive, Wearable Multifunctional Sensor Based on Rubber/CNT for Human Motion and Skin Temperature Detection

Mengzhuan Lin et al.

Summary: A hydrogen bond cross-linked network based on XSBR and SS non-covalently modified CNTs has been designed and fabricated into multi-functional sensors, with high stretchability, strength, and sensitivity, as well as the ability to measure body temperature.

ADVANCED MATERIALS (2022)

Article Computer Science, Information Systems

Toward practical gas sensing with rapid recovery semiconducting carbon nanotube film sensors

Fangfang Liu et al.

Summary: Researchers have developed a gate assistant technology to accelerate the recovery of gas sensors and promote their practical application, by applying voltage to speed up the desorption of gas molecules in semiconducting carbon nanotube films. This technology, combined with a modified concentration calculation method, has resulted in highly reproducible and rapid detection systems for hydrogen gas.

SCIENCE CHINA-INFORMATION SCIENCES (2022)

Article Chemistry, Analytical

Amperometric sensor for the detection of hydrogen stable isotopes based on Pt nanoparticles confined within single-walled carbon nanotubes (SWNTs)

Jiacheng Hu et al.

Summary: Researchers have developed a gas sensor based on single-walled carbon nanotubes filled with platinum composite material to detect hydrogen stable isotopes H-2 and D-2. The sensor shows superior sensitivity and selectivity, allowing for accurate detection of hydrogen and deuterium in different environments.

SENSORS AND ACTUATORS B-CHEMICAL (2022)

Article Engineering, Environmental

Carbon nanotubes-based adsorbents: Properties, functionalization, interaction mechanisms, and applications in water purification

Muhammad Sajid et al.

Summary: Carbon nanotubes-based adsorbents are widely used for the adsorption of inorganic and organic pollutants from water and wastewater due to their unique properties. Various approaches have been used to modify or functionalize carbon nanotubes for enhanced adsorption, and different mechanisms are involved depending on the adsorption conditions and functionalization. This review provides an overview of the properties, functionalization, and mechanisms of carbon nanotubes-based adsorption, as well as the critical parameters for water purification. It also discusses the challenges and potential solutions associated with carbon nanotubes-based adsorbents.

JOURNAL OF WATER PROCESS ENGINEERING (2022)

Article Nanoscience & Nanotechnology

Metal-Organic Frameworks on Palladium Nanoparticle- Functionalized Carbon Nanotubes for Monitoring Hydrogen Storage

Sean I. Hwang et al.

Summary: In this study, the dynamic monitoring of hydrogen adsorption and desorption was achieved by growing the metal-organic framework HKUST-1 on palladium nanoparticle-functionalized single-walled carbon nanotubes. The addition of HKUST-1 significantly improved the sensitivity and detection limit of the nanocomposite material to hydrogen.

ACS APPLIED NANO MATERIALS (2022)

Article Chemistry, Physical

pn-Heterojunction of the SWCNT/ZnO nanocomposite for temperature dependent reaction with hydrogen

Nguyen Duc Chinh et al.

Summary: Hydrogen breath test is a crucial diagnostic tool for exploring functional gastrointestinal disorders with high accuracy. The use of composite sensors made of single wall carbon nanotubes and zinc oxide has shown excellent hydrogen sensing performance, highlighting the importance of sensor development in medical diagnostics.

JOURNAL OF COLLOID AND INTERFACE SCIENCE (2021)

Article Chemistry, Physical

pH Modeling to Predict SWCNT-COOH Gas Sensor Response to Multiple Target Gases

Ruth Sang Jones et al.

Summary: Carboxylated single-walled carbon nanotubes have been studied for gas and vapor sensing, with controlled pH values enabling an array of sensors that can give orthogonal responses to target gases and vapors. The gas detection mechanism for these sensors under prevailing humidity is via protonation or deprotonation of the carboxylate groups induced by pH changes. A computational model has been developed to control pH and test various target gases, confirming its utility in decision-making on sensor design and developing multiple sensor arrays for constructing an electronic nose with machine learning.

JOURNAL OF PHYSICAL CHEMISTRY C (2021)

Article Chemistry, Physical

Sub-10 parts per billion detection of hydrogen with floating gate transistors built on semiconducting carbon nanotube film

Shaoyuan Zhou et al.

Summary: By adopting a floating gate (FG) field-effect-transistor (FET) structure with Y2O3 dielectric layer, the sensitivity and performance of carbon nanotube (CNT) based hydrogen sensors have been significantly enhanced, achieving a detection limit of 90 ppb and even down to 5 ppb at 100 degrees C. FG FET sensors show more than one magnitude enhancement in response compared to conventional resistance-type sensors, with excellent stability and compatibility to CNT integrated circuits, making them a potential platform for developing smart sensors.

CARBON (2021)

Article Engineering, Electrical & Electronic

Enhanced H2 Sensitivity in Ultraviolet-Activated Pt Nanoparticle/SWCNT/Graphene Nanohybrids

Mohammed A. Alamri et al.

Summary: UVC irradiation can effectively enhance H-2 gas response and response speed of Pt-NPs/SWCNTs/Gr sensors, with up to 4.3-fold increase in response and 3.6-fold increase in speed achieved at optimal conditions. This demonstrates the importance of carbon surface activation for high-performance H-2 sensors using carbon nanostructures.

IEEE SENSORS JOURNAL (2021)

Article Chemistry, Physical

Post-treatment effects on the gas sensing performance of carbon nanotube sheets

Maeum Han et al.

APPLIED SURFACE SCIENCE (2019)

Article Chemistry, Physical

Pt doped (8,0) single wall carbon nanotube as hydrogen sensor: A density functional theory study

M. Ferdi Fellah

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2019)

Article Chemistry, Multidisciplinary

Batch Fabrication of Ultrasensitive Carbon Nanotube Hydrogen Sensors with Sub-ppm Detection Limit

Mengmeng Xiao et al.

ACS SENSORS (2018)

Article Chemistry, Analytical

An overview: Facet-dependent metal oxide semiconductor gas sensors

Xing Gao et al.

SENSORS AND ACTUATORS B-CHEMICAL (2018)

Article Chemistry, Multidisciplinary

Wireless Oxygen Sensors Enabled by Fe(II)-Polymer Wrapped Carbon Nanotubes

Rong Zhu et al.

ACS SENSORS (2017)

Article Chemistry, Physical

Functionalization effect on a Pt/carbon nanotube composite catalyst: a first-principles study

Byung-Hyun Kim et al.

PHYSICAL CHEMISTRY CHEMICAL PHYSICS (2016)

Article Nanoscience & Nanotechnology

Palladium/Single-Walled Carbon Nanotube Back-to-Back Schottky Contact-Based Hydrogen Sensors and Their Sensing Mechanism

Miluo Zhang et al.

ACS APPLIED MATERIALS & INTERFACES (2014)

Article Nanoscience & Nanotechnology

Metal nanoparticles and DNA co-functionalized single-walled carbon nanotube gas sensors

Heng C. Su et al.

NANOTECHNOLOGY (2013)

Article Chemistry, Analytical

Effective hydrogen gas nanosensor based on bead-like nanowires of platinum-decorated tin oxide

Nguyen Van Duy et al.

SENSORS AND ACTUATORS B-CHEMICAL (2012)

Article Chemistry, Multidisciplinary

Hydrogen Sensing with Diameter- and Chirality-Sorted Carbon Nanotubes

Marc Ganzhorn et al.

ACS NANO (2011)

Article Chemistry, Multidisciplinary

Hydrogen Sensing and Sensitivity of Palladium-Decorated Single-Walled Carbon Nanotubes with Defects

Vaikunth R. Khalap et al.

NANO LETTERS (2010)

Article Nanoscience & Nanotechnology

H2 sensing characteristics of SnO2 coated single wall carbon nanotube network sensors

Myung Yang et al.

NANOTECHNOLOGY (2010)

Article Chemistry, Analytical

Synthesis of porous CuO nanowires and its application to hydrogen detection

Nguyen Duc Hoa et al.

SENSORS AND ACTUATORS B-CHEMICAL (2010)

Article Chemistry, Analytical

Highly sensitive hydrogen gas sensors using single-walled carbon nanotubes grafted with Pd nanoparticles

Seonghwa Ju et al.

SENSORS AND ACTUATORS B-CHEMICAL (2010)

Article Chemistry, Analytical

High-performance carbon nanotube hydrogen sensor

Wei Li et al.

SENSORS AND ACTUATORS B-CHEMICAL (2010)

Article Materials Science, Multidisciplinary

Combined electron microscopy and spectroscopy characterization of as-received, acid purified, and oxidized HiPCO single-wall carbon nanotubes

Belinda I. Rosario-Castro et al.

MATERIALS CHARACTERIZATION (2009)

Article Chemistry, Analytical

Micromachined sol-gel carbon nanotube/SnO2 nanocomposite hydrogen sensor

Jianwei Gong et al.

SENSORS AND ACTUATORS B-CHEMICAL (2008)

Article Chemistry, Analytical

Exfoliated single-walled carbon nanotube-based hydrogen sensor

M. Krishna Kumar et al.

SENSORS AND ACTUATORS B-CHEMICAL (2008)

Article Chemistry, Physical

Electrochemically decorated carbon nanotubes for hydrogen sensing

Ulrich Schlecht et al.

APPLIED SURFACE SCIENCE (2007)

Article Chemistry, Physical

Palladium nanoparticles decorated single-walled carbon nanotube hydrogen sensor

Syed Mubeen et al.

JOURNAL OF PHYSICAL CHEMISTRY C (2007)

Article Chemistry, Analytical

Novel selective sensors based on carbon nanotube films for hydrogen detection

I. Sayago et al.

SENSORS AND ACTUATORS B-CHEMICAL (2007)

Article Physics, Applied

Hydrogen-sensing response of carbon-nanotube thin-film sensor with Pd comb-like electrodes

Yuki Hayakawa et al.

JAPANESE JOURNAL OF APPLIED PHYSICS PART 2-LETTERS & EXPRESS LETTERS (2007)

Article Materials Science, Multidisciplinary

Hydrogen sensors based on carbon nanotubes thin films

I Sayago et al.

SYNTHETIC METALS (2005)

Letter Chemistry, Physical

Electronic properties of carbon nanotubes with covalent sidewall functionalization

JJ Zhao et al.

JOURNAL OF PHYSICAL CHEMISTRY B (2004)

Article Multidisciplinary Sciences

Ballistic carbon nanotube field-effect transistors

A Javey et al.

NATURE (2003)

Article Multidisciplinary Sciences

Nanotube molecular wires as chemical sensors

J Kong et al.

SCIENCE (2000)