4.6 Review

Photoelasticity for Stress Concentration Analysis in Dentistry and Medicine

Related references

Note: Only part of the references are listed.
Article Engineering, Biomedical

Evaluation of Biomechanical and Stress Distribution of Different Dental Implant Designs: Primary Stability and Photoelastic Analysis

J. D. C. Tardelli et al.

Summary: This study evaluated and compared the stress distribution and primary stability of three different designs of dental implants. The results showed that two of the implants exhibited high primary stability and satisfactory stress distribution, while the other implant had limited indication in low density bones.
Article Dentistry, Oral Surgery & Medicine

Impact of Endodontic Kinematics on Stress Distribution During Root Canal Treatment: Analysis of Photoelastic Stress

Shelyn Akari Yamakami et al.

Summary: This study analyzed the levels of stress produced by different endodontic instruments during root canal treatment using photoelastic analysis. The results showed that all endodontic systems resulted in accumulation of stress along the dental structure, with slight variations in stress levels among different instruments.

JOURNAL OF ENDODONTICS (2022)

Article Dentistry, Oral Surgery & Medicine

Is one dental mini-implant biomechanically appropriate for the retention of a mandibular overdenture? A comparison with Morse taper and external hexagon platforms

Guilherme Almeida Borges et al.

Summary: An in vitro and finite element analysis study compared the biomechanical behavior of MOs with EH, MT SDIs, and MIs. Results showed that MI is a promising rehabilitation method with similar peri-implant shear stress and lower von Mises stress on the implant, regardless of the implant number, compared to SDIs for MOs.

JOURNAL OF PROSTHETIC DENTISTRY (2021)

Article Dentistry, Oral Surgery & Medicine

Can ceramic veneer spark erosion and mechanical cycling affect the accuracy of milled complete-arch frameworks supported by 6 implants?

Leticia Del Rio Silva et al.

Summary: This study compared the accuracy of complete-arch fixed frameworks made from different materials, showing that titanium frameworks had poorer fit values but higher loosening torque at baseline. Ceramic veneer improved the fit levels for zirconia and cobalt-chromium, decreased the loosening torque for cobalt-chromium, and increased stress levels. Spark erosion was found to be a reliable technique to enhance fit and loosening torque for cobalt-chromium frameworks. Mechanical cycling did not affect loosening torque.

JOURNAL OF PROSTHETIC DENTISTRY (2021)

Review Optics

Research Progress of Stress Measurement Technologies for Optical Elements

Shan Wei et al.

Summary: This paper introduces the importance of accurately measuring residual stress distribution in optical elements and evaluating its impact on optical instruments. It discusses the relationship between stress and birefringence based on photoelasticity, and reviews the research progress of stress measurement technologies based on this principle, which can be categorized into polarization and interference methods. The advantages and disadvantages of various stress measurement technologies are analyzed and compared, and the future development trends of stress measurement technologies for optical elements are summarized and prospected.

INTERNATIONAL JOURNAL OF OPTICS (2021)

Article Computer Science, Interdisciplinary Applications

Finite element analysis and experimental evaluation on stress distribution and sensitivity of dental implants to assess optimum length and thread pitch

Mostafa Pirmoradian et al.

COMPUTER METHODS AND PROGRAMS IN BIOMEDICINE (2020)

Article Acoustics

An investigation of elastic waves producing stone fracture in burst wave lithotripsy

Adam D. Maxwell et al.

JOURNAL OF THE ACOUSTICAL SOCIETY OF AMERICA (2020)

Article Materials Science, Multidisciplinary

A Comparison of Photoelastic and Finite Elements Analysis in Internal Connection and Bone Level Dental Implants

Cristina Herraez-Galindo et al.

METALS (2020)

Proceedings Paper Materials Science, Multidisciplinary

Developing a soft tissue surrogate for use in photoelastic testing

S. E. Falconer et al.

MATERIALS TODAY-PROCEEDINGS (2019)

Article Dentistry, Oral Surgery & Medicine

Photoelastic analysis of stress distribution in mandibular second molar roots caused by several uprighting mechanics

Andre Felipe Abrao et al.

AMERICAN JOURNAL OF ORTHODONTICS AND DENTOFACIAL ORTHOPEDICS (2018)

Article Biochemical Research Methods

Ultrafast polarization bio-imaging based on coherent detection and time-stretch techniques

Lu Song et al.

BIOMEDICAL OPTICS EXPRESS (2018)

Article Dentistry, Oral Surgery & Medicine

Physical and photoelastic properties of bulk-fill and conventional composites

Renata Pereira et al.

CLINICAL COSMETIC AND INVESTIGATIONAL DENTISTRY (2018)

Article Dentistry, Oral Surgery & Medicine

A photoelastic and strain gauge comparison of two attachments for obturator prostheses

Marcelo Coelho Goiato et al.

JOURNAL OF PROSTHETIC DENTISTRY (2017)

Article Dentistry, Oral Surgery & Medicine

Marginal fit and photoelastic stress analysis of CAD-CAM and overcast 3-unit implant-supported frameworks

Anna Gabriella Camacho Presotto et al.

JOURNAL OF PROSTHETIC DENTISTRY (2017)

Article Materials Science, Biomaterials

Photoelastic analysis of mandibular full-arch implant-supported fixed dentures made with different bar materials and manufacturing techniques

Danilo Zaparolli et al.

MATERIALS SCIENCE & ENGINEERING C-MATERIALS FOR BIOLOGICAL APPLICATIONS (2017)

Review Materials Science, Biomaterials

Effect of fibre posts, bone losses and fibre content on the biomechanical behaviour of endodontically treated teeth: 3D-finite element analysis

Manila Chieruzzi et al.

MATERIALS SCIENCE AND ENGINEERING C-MATERIALS FOR BIOLOGICAL APPLICATIONS (2017)

Article Dentistry, Oral Surgery & Medicine

Short implants to support mandibular complete dentures - photoelastic analysis

Marcele Jardim Pimentel et al.

BRAZILIAN ORAL RESEARCH (2017)

Article Optics

Digital photoelastic analysis applied to implant dentistry

K. Ramesh et al.

OPTICS AND LASERS IN ENGINEERING (2016)

Article Engineering, Multidisciplinary

Biomechanical analysis of damaged intervertebral disc using reflective photoelasticity

Ricardo Gustavo Rodriguez-Canizo et al.

REVISTA FACULTAD DE INGENIERIA-UNIVERSIDAD DE ANTIOQUIA (2016)

Article Dentistry, Oral Surgery & Medicine

Mechanical and photoelastic analysis of four different fixation methods for mandibular body fractures

Danillo Costa Rodrigues et al.

JOURNAL OF CRANIO-MAXILLOFACIAL SURGERY (2015)

Article Dentistry, Oral Surgery & Medicine

Photoelastic comparison of as-cast and laser-welded implant frameworks

Karina Albino Lencioni et al.

JOURNAL OF PROSTHETIC DENTISTRY (2015)

Article Materials Science, Multidisciplinary

Analysis of Stress and Fracture Strength of Zirconia Implants after Cyclic Loading

Diogo Rodrigues Cruvinel et al.

MATERIALS RESEARCH-IBERO-AMERICAN JOURNAL OF MATERIALS (2015)

Article Materials Science, Biomaterials

Photoelastic analysis of stresses transmitted by complete dentures lined with hard or soft liners

Izabella P. Pereira et al.

MATERIALS SCIENCE & ENGINEERING C-MATERIALS FOR BIOLOGICAL APPLICATIONS (2015)

Article Dentistry, Oral Surgery & Medicine

Analysis of residual stress and hardness in regions of pre-manufactured and manual bends in fixation plates for maxillary advancement

Marcelo Marotta Araujo et al.

ORAL AND MAXILLOFACIAL SURGERY-HEIDELBERG (2015)

Article Dentistry, Oral Surgery & Medicine

Mechanical and photoelastic analysis of conventional screws and cannulated screws for sagittal split osteotomy fixation: a comparative study

Cristina Jardelino de Lima et al.

ORAL AND MAXILLOFACIAL SURGERY-HEIDELBERG (2015)

Article Orthopedics

ANALYSIS OF STRESS INDUCED BY SCREWS IN THE VERTEBRAL FIXATION SYSTEM

Sarah Fakher Fakhouri et al.

ACTA ORTOPEDICA BRASILEIRA (2014)

Article Chemistry, Organic

Asymmetric Synthesis of a CBI-Based Cyclic N-Acyl O-Amino Phenol Duocarmycin Prodrug

Mika Uematsu et al.

JOURNAL OF ORGANIC CHEMISTRY (2014)

Article Dentistry, Oral Surgery & Medicine

COMPARISON OF THE CORRELATION OF PHOTOELASTICITY AND DIGITAL IMAGING TO CHARACTERIZE THE LOAD TRANSFER OF IMPLANT-SUPPORTED RESTORATIONS

Rodrigo Tiossi et al.

JOURNAL OF PROSTHETIC DENTISTRY (2014)

Article Dentistry, Oral Surgery & Medicine

Assessment of the fixation of mandibular symphysis fractures using conical cannulated screws: mechanical and photoelastic tests

Saulo Gabriel Moreira Falci et al.

ORAL SURGERY ORAL MEDICINE ORAL PATHOLOGY ORAL RADIOLOGY (2014)

Article Dentistry, Oral Surgery & Medicine

Photoelastic stress analysis in mandibular bone surrounding bar-clip overdenture implants

Monica Nogueira Pigozzo et al.

BRAZILIAN ORAL RESEARCH (2014)

Article Dentistry, Oral Surgery & Medicine

Photoelastic analysis of all-on-four concept using different implants angulations for maxilla

Castelo Pedro Vemba Cidade et al.

BRAZILIAN ORAL RESEARCH (2014)

Article Dentistry, Oral Surgery & Medicine

Importance of a distal proximal contact on load transfer by implant-supported single adjacent crowns in posterior region of the mandible: a photoelastic study

Fabio Afranio de Aguiar Junior et al.

JOURNAL OF APPLIED ORAL SCIENCE (2013)

Article Dentistry, Oral Surgery & Medicine

Fixation of mandibular angle fractures: in vitro biomechanical assessments and computer-based studies

Bruno Ramos Chrcanovic

ORAL AND MAXILLOFACIAL SURGERY-HEIDELBERG (2013)

Article Orthopedics

PHOTOELASTIC ANALISYS IN THE LOWER REGION OF VERTEBRAL BODY L4

Sarah Fakher Fakhouri et al.

ACTA ORTOPEDICA BRASILEIRA (2012)

Article Biophysics

EXPERIMENTAL STUDY ON ORAL BITING FORCE DETECTION BY PHOTOELASTIC METHOD

Kouji L. Yamamoto et al.

JOURNAL OF BIOMECHANICS (2012)

Article Orthopedics

How stiffness and distal interlocking of revision hip stems influence the femoral cortical strain pattern

Martin Ellenrieder et al.

JOURNAL OF ORTHOPAEDIC SCIENCE (2012)

Article Anatomy & Morphology

Tibiofibular screw fixation for syndesmotic ruptures: a biomechanical analysis

G. Stein et al.

SURGICAL AND RADIOLOGIC ANATOMY (2012)

Article Dentistry, Oral Surgery & Medicine

Photoelastic evaluation of the effect of composite formulation on polymerization shrinkage stress

Karla Mychellyne Costa Oliveira et al.

BRAZILIAN ORAL RESEARCH (2012)

Article Biophysics

Correlation between vertical misfits and stresses transmitted to implants from metal frameworks

Erica Miranda de Torres et al.

JOURNAL OF BIOMECHANICS (2011)

Article Dentistry, Oral Surgery & Medicine

PHOTOELASTIC STRESS ANALYSIS OF EXTERNAL VERSUS INTERNAL IMPLANT-ABUTMENT CONNECTIONS

Pattapon Asvanund et al.

JOURNAL OF PROSTHETIC DENTISTRY (2011)

Article Dentistry, Oral Surgery & Medicine

Photoelastic analysis of stress generated by a silorane-based restoration system

Murilo Baena Lopes et al.

BRAZILIAN ORAL RESEARCH (2011)

Review Dentistry, Oral Surgery & Medicine

Fracture Resistance of Teeth Restored with Post-retained Restorations: An Overview

Mahmoud Khaled Al-Omiri et al.

JOURNAL OF ENDODONTICS (2010)

Article Materials Science, Multidisciplinary

Stress distribution in orthodontic mini-implants

A. Dobranszki et al.

MATERIA-RIO DE JANEIRO (2010)

Article Orthopedics

PHOTOELASTIC ANALISYS OF A HUMAN VERTEBRA MODEL WITH PEDICULAR SCREW

Dayana Pousa Paiva de Sioueira et al.

ACTA ORTOPEDICA BRASILEIRA (2009)

Article Biophysics

Design and construction of a transducer for bite force registration

Juan F. Isaza et al.

JOURNAL OF BIOMECHANICS (2009)

Article Dentistry, Oral Surgery & Medicine

Effect of light-curing units and activation mode on polymerization shrinkage and shrinkage stress of composite resins

Lawrence Gonzaga Lopes et al.

JOURNAL OF APPLIED ORAL SCIENCE (2008)

Article Dentistry, Oral Surgery & Medicine

Photoelastic stress analysis of various retention mechanisms on 3-implant-retained mandibular overdentures

Gozde Celik et al.

JOURNAL OF PROSTHETIC DENTISTRY (2007)

Article Dentistry, Oral Surgery & Medicine

Abutment load transfer by removable partial denture obturator frameworks in different acquired maxillary defects

KM Lyons et al.

JOURNAL OF PROSTHETIC DENTISTRY (2005)

Article Biophysics

Acromion-fixation of glenoid components in total shoulder arthroplasty

LA Murphy et al.

JOURNAL OF BIOMECHANICS (2005)

Article Orthopedics

Photoelastic study of the internal and contact stresses on the knee joint before and after osteotomy

G Papachristou

ARCHIVES OF ORTHOPAEDIC AND TRAUMA SURGERY (2004)

Article Dentistry, Oral Surgery & Medicine

Stress transfer of four mandibular implant overdenture cantilever designs

SJ Sadowsky et al.

JOURNAL OF PROSTHETIC DENTISTRY (2004)

Article Dentistry, Oral Surgery & Medicine

Photoelastic analysis of the effect of palatal support on various implant-supported overdenture designs

KT Ochiai et al.

JOURNAL OF PROSTHETIC DENTISTRY (2004)

Article Medicine, General & Internal

Images from Waves - photoelastic modelling of bones

JF Orr

IRISH JOURNAL OF MEDICAL SCIENCE (2003)

Article Dentistry, Oral Surgery & Medicine

Description of a photoelastic coating technique to describe surface strain of a dog skull loaded in vitro

RB Judge et al.

JOURNAL OF PROSTHETIC DENTISTRY (2003)

Article Dentistry, Oral Surgery & Medicine

Photoelastic stress analysis of implant-tooth connected prostheses with segmented and nonsegmented abutments

KT Ochiai et al.

JOURNAL OF PROSTHETIC DENTISTRY (2003)

Article Dentistry, Oral Surgery & Medicine

Effect of splinting and interproximal contact tightness on load transfer by implant restorations

DL Guichet et al.

JOURNAL OF PROSTHETIC DENTISTRY (2002)

Article Dentistry, Oral Surgery & Medicine

Stress distribution around maxillary implants in anatomic photoelastic models of varying geometry. Part II

MD Gross et al.

JOURNAL OF PROSTHETIC DENTISTRY (2001)

Article Dentistry, Oral Surgery & Medicine

Effect of anchorage systems and extension base contact on load transfer with mandibular implant-retained overdentures

SJ Sadowsky et al.

JOURNAL OF PROSTHETIC DENTISTRY (2000)