Selective Etching of Si versus Si1-xGex in Tetramethyl Ammonium Hydroxide Solutions with Surfactant

We investigated the selective etching of Si versus Si1-xGex with various Ge concentrations (x = 0.13, 0.21, 0.30, 0.44) in tetramethyl ammonium hydroxide (TMAH) solution. Our results show that the Si1-xGex with a higher Ge concentration was etched slower due to the reduction in the Si(Ge)-OH bond. Owing to the difference in the etching rate, Si was selectively etched in the Si0.7Ge0.3/Si/Si0.7Ge0.3 multi-layer. The etching rate of Si depends on the Si surface orientation, as TMAH is an anisotropic etchant. The (111) and (010) facets were formed in TMAH, when Si was laterally etched in the and directions in the multi-layer, respectively. We also investigated the effect of the addition of Triton X-100 in TMAH on the wet etching process. Our results confirmed that the presence of 0.1 vol% Triton reduced the roughness of the etched Si and Si1-xGex surfaces. Moreover, the addition of Triton to TMAH could change the facet formation from (010) to (011) during Si etching in the -direction. The facet change could reduce the lateral etching rate of Si and consequently reduce selectivity. The decrease in the layer thickness also reduced the lateral Si etching rate in the multi-layer.

Automated summary

We investigated the selective etching of Si versus Si1-xGex with different Ge concentrations. The etching rate of Si1-xGex decreases with increasing Ge concentration due to the reduction in Si(Ge)-OH bond. The morphology of the etched surfaces and the etching rate depend on the surface orientation and the presence of Triton X-100 in TMAH solution.