Preliminary study of improving reservoir quality of tight gas sands in the near wellbore region by microwave heating

The formation damages, such as water blocking and clay swelling, in tight gas reservoir have been recognized as severe problems impairing gas production. To remedy these damages, formation heat treatment (FHT) was taken as one of the effective measures by some researchers. In this paper, the effects of microwave heating on the petrophysical properties of sandstone samples has been investigated. A modified commercial microwave oven was used to heat the core plugs and aluminum tubes were used to accommodate tight sandstone samples in order to confine them and reduce their contact with air. After microwave heating, any alterations in the porosity, permeability, texture, structure, mineralogy, and pore size distribution of tight sandstones were investigated by a series of lab experiments. By subjecting tight sandstone samples to microwave, the surface temperature of sandstone can be elevated to approximately 400 degrees C or more. The intense heat is effective in changing the structure, texture and mineralogy of the sandstone. The shrinkage or decomposition of minerals, which are shown by XRD analysis, and generation of micro-fractures created more spaces in the samples. By employing Automated Permeameter, porosity and permeability are found increased after heating. Nuclear Magnetic Resonance (NMR) and CT numbers of all samples after microwave heating indicate the increase of porosity as well. Moreover, the NMR T-2 distribution reveals the smaller pores diminished, so the incremental porosity of short NMR T-2 decreased. Micro-fractures generated between grains or in grains due to decomposition of some cement minerals and clay shrinkage, so the amplitude of long NMR T-2 increased. The fractures are visible both in X-ray CT images and in Scanning Electronic Microscopy (SEM) images. By comparing with NMR T-2 distribution data, it is found that the presence of micro-fractures accounts for the increased population of pores with T-2 larger than 10 ms. The numerical simulation of microwave heating in the borehole indicates that the microwave heating is effective to raise the temperature of reservoir rock to approximately 900 degrees C within 1 day and to remove the-water within a distance of 25 cm from the borehole wall. The efficiency of microwave heating can be further improved by optimizing the downhole microwave device. (C) 2016 Elsevier B.V. All rights reserved.