4.6 Article

Fabrication of dog-bone shaped Au NRcore-Pt/Pd-shell trimetallic nanoparticle-decorated reduced graphene oxide nanosheets for excellent electrocatalysis

Journal

JOURNAL OF MATERIALS CHEMISTRY A
Volume 4, Issue 10, Pages 3765-3776

Publisher

ROYAL SOC CHEMISTRY
DOI: 10.1039/c6ta00379f

Keywords

-

Funding

  1. DST-FIST
  2. Grants-in-Aid for Scientific Research [25288009, 15H00763, 15H00883, 16H04099] Funding Source: KAKEN

Ask authors/readers for more resources

Herein, a wet-chemical synthetic approach has been adopted, taking advantage of electrostatic interactions between positively charged [CTA](+) capped Au NRs and negative functionalities of graphene oxide (GO), to fabricate dog-bone shaped Au NRcore-Pt/Pd-shell decorated reduced graphene oxide (rGO) nanosheets (GMTs) for efficient ethanol electrooxidation reaction (EOR). This new strategy is based on an exceptionally efficient immobilization of trimetallic nanoparticles onto rGO sheets. It is important to note that the sequential addition of Pt and Pd precursor salts into the reaction mixture evolves Pd as the surface layer in the trimetallic assembly (described as GMT-1), whereas reversal of the sequence of addition results in spongy Pt NPs at the outer surface (designated as GMT-2), and thus two different types of Au-core-Pt/Pd(sandwi)ch-Pd/Pt-shell nanoparticle-decorated rGO nanocomposites have been fabricated. The well recognized electrocatalytic performance of Pt is improved towards EOR by controlled assembling of Au and Pd in the rGO support in both the GMTs, exceeding the performance of the corresponding bimetallic composites. The presence of Pd and rGO decreases the CO poisoning of Pt and rGO supports restrict the aggregation of the nanoparticles during CV cycles. Thus the durability of the GMT catalysts has been improved in contrast to other related materials. Interestingly, the exposed spongy Pt NPs, present at the exterior of the trimetallic particles in GMT-2, help to exhibit better EOR activity (similar to 1.22 times) but lower durability (similar to 10%) in comparison to its analogue, GMT-1. The observed electrocatalytic efficiencies of GMTs are superior to commercial Pt/C (more than 6 times better mass utilization and similar to 40% higher durability) and most of the recently reported related materials, which suggest cost-effective and efficient practical fuel cell application of GMTs.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.6
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available