4.7 Article

Chemical characteristics of artificial plastic plants and the presence of hazardous elements from the recycling of electrical and electronic waste

Journal

SCIENCE OF THE TOTAL ENVIRONMENT
Volume 903, Issue -, Pages -

Publisher

ELSEVIER
DOI: 10.1016/j.scitotenv.2023.166083

Keywords

Polyethylene terephthalate; Polyolefins; Electronic waste; Brominated flame retardants; Antimony; Lead

Ask authors/readers for more resources

The demand for decorative plastic plants has been increasing due to their convenience. However, little information is available about the origin and nature of the polymers and additives used in these plants. A study analyzed parts from 175 plastic plants bought from European shops and found potentially hazardous elements and contaminants, suggesting that many of these plants are made from contaminated recyclates. This contamination may pose difficulties for recycling and disposal of plastic plants.
Because of their convenience, the demand for decorative plastic plants has been increasing over recent years. However, no information exists on the origin or nature of the polymers employed or the type of additives used in order to understand potential environmental impacts and inform safe and sustainable disposal or recycling practices. In this study, 203 parts or offcuts from 175 plastic plants acquired from European shops and venues have been analysed by X-ray fluorescence spectrometry to determine elemental content, while a selection has been analysed by infrared spectrometry to establish polymer type. The (usually green) moulded components (n = 159) were commonly constructed of polyethylene or polypropylene, while leaves and colourful petals (n = 40) were generally made of polyethylene terephthalate fabric that had been glued to the moulded component. However, both components also exhibited evidence of being coated with a resin or adhesive for support, protection or appearance. Barium, Fe, Ti and Zn-based additives were commonly encountered but more important from an environmental and health perspective were variable concentrations of potentially hazardous elements in the moulded parts: namely, Br (6.1 to 108,000 mg kg -1; n = 78), Pb (7.6 to 17,400 mg kg -1; n = 53) and Sb (58.6 to 70,800 mg kg -1; n = 17). These observations suggest that many of the moulded components are derived from recyclates that are contaminated by waste electronic and electrical plastic, introducing brominated flame retardants, the flame retardant synergist, Sb2O3, and Pb into the final product. There are no standards for these chemicals in plastic plants, but regulations for electronic plastic, toy safety and packaging are frequently exceeded or potentially exceeded. Widespread contamination of plastic plants may impose constraints on their recycling and disposal.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available