☆ 4.7 Article

Effect of powder dispersity on the optical properties of HIP sintered MgAl2O4 transparent ceramics

CERAMICS INTERNATIONAL (2023)

Related references

Note: Only part of the references are listed.

Article Materials Science, Ceramics

Transparent LiOH-doped magnesium aluminate spinel produced by spark plasma sintering: Effects of heating rate and dopant concentration

Vaclav Pouchly et al.

Summary: The effects of LiOH doping and different SPS schedules on densification behavior and final transparency of polycrystalline magnesium aluminate spinel were investigated. Slow heating rate was optimal for undoped spinel with the highest transmittance, while fast heating rate was beneficial for LiOH-doped spinel with reduced carbon contamination.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2023)

Add to Collection

Article Materials Science, Multidisciplinary

Tuning d-spacing of graphene oxide nanofiltration membrane for effective dye/salt separation

Chao Xing et al.

Summary: This study focused on tuning the interlayer spacing of a graphene oxide (GO) membrane using poly-ethyleneimine (PEI) and developing a robust composite nanofiltration membrane. The PEI/GO@PAN membrane exhibited excellent rejection performance and high flux, making it a promising candidate for dye/salt separation applications.

RARE METALS (2023)

Add to Collection

Article Materials Science, Ceramics

Effect of Y2O3 content on densification, microstructure and mechanical properties of reaction sintered magnesium aluminate spinel

Biswajit Baruah et al.

Summary: Dense magnesium aluminate spinels with favorable densification and improved mechanical properties can be developed by adding 2 wt% Y2O3 through a solid-state reaction sintering method. The addition of Y2O3 promotes densification of the spinels due to the similar crystal structure with yttrium aluminum garnet (YAG). Microstructural investigation shows that Y2O3-containing spinel batches have a controlled grain structure. The Y2O3-doped spinel batches sintered at 1650°C exhibit better mechanical properties than the undoped spinels.

CERAMICS INTERNATIONAL (2023)

Add to Collection

Article Materials Science, Multidisciplinary

Simultaneous precipitation of Zr4+and Y3+ions induced refinement of precursors and powders in fabrication of Zr4+doped Y2O3 transparent ceramics

Yifei Cao et al.

Summary: Zr4+ ion doping effectively enhances the optical and mechanical qualities of Y2O3 transparent ceramics. The simultaneous precipitation of Zr4+ and Y3+ ions leads to the refinement of precursors and Y2O3 powders. The acting mechanisms of Zr additive involve refining precursor, producing oxygen interstitial, and promoting solute-drag, resulting in high transmittance Y2O3 ceramics.

OPTICAL MATERIALS (2023)

Add to Collection

Article Materials Science, Ceramics

Gelling behavior of MgAl2O4 slurries with a common dispersant

Mengwei Liu et al.

Summary: In this study, transparent MgAl2O4 ceramics were successfully shaped by using polyacrylic acid (PAA) as a dispersant and gelling agent. Spinel slurries were prepared using ball-milling method, and the gelling occurred at room temperature without any other organic additive. A novel in situ characterization method was also developed to investigate the strengthening process of wet green body and guide the demolding.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2022)

Add to Collection

Letter Materials Science, Multidisciplinary

Kinetics and mechanism of the sulfurization behavior of silver conductive material in automobile industry

Ze-Di Shi et al.

RARE METALS (2022)

Add to Collection

Article Materials Science, Ceramics

Mechanical and optical properties of MgAl2O4 ceramics and ballistic efficiency of spinel based armour

Caroline Gajdowski et al.

Summary: This study focuses on understanding the relationship between the properties of MgAl2O4 ceramics and their ballistic performances. By adjusting the processing parameters, ceramics with different microstructures were obtained. One of the ceramics, a transparent MgAl2O4 spinel, demonstrated good mechanical properties and a reduced thickness and density compared to a regular glass armor when being tested against an armor piercing projectile.

CERAMICS INTERNATIONAL (2022)

Add to Collection

Article Materials Science, Ceramics

The effects of pre-sintering temperature and La2O3 addition on sinterability and corrosion resistance of stoichiometric magnesium aluminate spinel

Xinming Ren et al.

Summary: The study found that two-step sintering is more effective in achieving higher relative density compared to one-step pressureless sintering, and the addition of La2O3 can increase the relative density of the sample and improve its corrosion resistance.

CERAMICS INTERNATIONAL (2022)

Add to Collection

Article Materials Science, Ceramics

Fabrication, microstructure, and properties of 8 mol% yttria-stabilized zirconia (8YSZ) transparent ceramics

Penghui Chen et al.

Summary: Fine grained 8 mol% yttria-stabilized zirconia (8YSZ) transparent ceramics with high optical and mechanical properties were fabricated using air pre-sintering and hot isostatic pressing (HIP) techniques. The combination of high transparency and excellent mechanical properties in 8YSZ ceramics was systematically investigated.

JOURNAL OF ADVANCED CERAMICS (2022)

Add to Collection

Letter Materials Science, Multidisciplinary

High specific surface area inherited from sea-urchin-like AACH clusters prepared by a novel spray precipitation

Xi-Yue Zhang et al.

RARE METALS (2022)

Add to Collection

Article Materials Science, Ceramics

An efficient Yb2O3 additive for improved densification and corrosion resistance of MgAl2O4 spinel

Ke Shan et al.

Summary: The study showed that the appropriate addition of Yb2O3 can improve the densification and corrosion resistance of MgAl2O4 spinel, while also generating a second phase, Al5Yb3O12. With 2wt% Yb2O3 added, the samples exhibited the highest hardness, smallest corrosion depth, and smaller grain size.

CERAMICS INTERNATIONAL (2021)

Add to Collection

Article Materials Science, Ceramics

Effect of Yb2O3 and TiO2 on reaction sintering and properties of magnesium aluminate spinel

Somnath Sinhamahapatra et al.

Summary: The magnesium aluminate spinel was prepared from constituent oxides through a solid-state sintering process at temperatures ranging from 1550 to 1700 degrees C in a normal air atmosphere. The addition of TiO2 and Yb2O3 improved the densification and mechanical properties of the magnesia-rich spinel, with Yb2O3 showing better performance in room temperature flexural strength.

CERAMICS INTERNATIONAL (2021)

Add to Collection

Article Materials Science, Multidisciplinary

Influence of CaO on microstructure and properties of MgAl2O4 transparent ceramics

Yanqiu Jing et al.

Summary: The influence of CaO content on the microstructure and optical quality of MgAl2O4 ceramics was investigated. CaO was found to significantly promote the sintering process, but an excessive amount led to the occurrence of secondary phase grains, which reduced the optical quality.

OPTICAL MATERIALS (2021)

Add to Collection

Article Nanoscience & Nanotechnology

Modeling the sintering trajectories of MgAl2O4 Spinel

Gabriel Kerbart et al.

Summary: This paper investigates the sintering characteristics of MgAl2O4 spinel using Olevsky's model to simulate the sintering trajectories. Densification and grain growth behaviors were identified through ramping and interrupted isothermal cycles, highlighting changes in final stage sintering mechanisms. The sintering trajectory model is proposed as a powerful numerical tool for sintering optimizations.

SCRIPTA MATERIALIA (2021)

Add to Collection

Article Materials Science, Ceramics

Efficient spectral regulation in Ce:Lu3(Al,Cr)5O12 and Ce:Lu3(Al,Cr)5O12/Ce:Y3Al5O12 transparent ceramics with high color rendering index for high-power white LEDs/LDs

Tianyuan Zhou et al.

Summary: Ce,Cr:LuAG TCs achieved efficient spectral regulation through Cr3+ doping, enhancing their luminescence properties in white LED/LD applications. By combining with other materials, such as 0.5 at% Ce:YAG TC, even better results were obtained in terms of CRI values for TC based white LEDs and LDs.

JOURNAL OF ADVANCED CERAMICS (2021)

Add to Collection

Review Materials Science, Multidisciplinary

Materials development and potential applications of transparent ceramics: A review

Zhuohao Xiao et al.

MATERIALS SCIENCE & ENGINEERING R-REPORTS (2020)

Add to Collection

Article Chemistry, Physical

Densification of Magnesium Aluminate Spinel Using Manganese and Cobalt Fluoride as Sintering Aids

Ali Talimian et al.

MATERIALS (2020)

Add to Collection

Article Materials Science, Ceramics

Transparent MgAl2O4 ceramics prepared by microwave sintering and hot isostatic pressing

Yinan Liu et al.

CERAMICS INTERNATIONAL (2020)

Add to Collection

Review Materials Science, Multidisciplinary

A review on processing polycrystalline magnesium aluminate spinel (MgAl2O4): Sintering techniques, material properties and machinability

Zhuoqi Shi et al.

MATERIALS & DESIGN (2020)

Add to Collection

Article Materials Science, Multidisciplinary

Microstructure and properties of MgAl2O4 transparent ceramics fabricated by hot isostatic pressing

Qiang Liu et al.

OPTICAL MATERIALS (2020)

Add to Collection

Article Materials Science, Ceramics

Role of different rare earth oxides on the reaction sintering of magnesium aluminate spinel

Somnath Sinhamahapatra et al.

CERAMICS INTERNATIONAL (2019)

Add to Collection

Article Materials Science, Ceramics

Effect of pretreated microstructure on subsequent sintering performance of MgAl2O4 ceramics

Shengqiang Guo et al.

CERAMICS INTERNATIONAL (2019)

Add to Collection

Article Materials Science, Ceramics

Preparation of high-quality transparent Al-rich spinel ceramics by reactive sintering

Dan Han et al.

CERAMICS INTERNATIONAL (2018)

Add to Collection

Article Materials Science, Ceramics

Effect of CaO on the optical quality and microstructure of transparent MgO center dot 1.5Al(2)O(3) spinel ceramics prepared by reactive sintering

Dan Han et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2018)

Add to Collection

Article Materials Science, Ceramics

MgO assisted densification of highly transparent YAG ceramics and their microstructural evolution

Tianyuan Zhou et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2018)

Add to Collection

Article Materials Science, Ceramics

Polycrystalline transparent magnesium aluminate spinel processed by a combination of spark plasma sintering (SPS) and hot isostatic pressing (HIP)

Shahar Cohen et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2018)

Add to Collection

Article Materials Science, Ceramics

Fabrication of transparent Tb3Al5O12 ceramics by hot isostatic pressing sintering

Pingping Duan et al.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2017)

Add to Collection

Review Materials Science, Ceramics

Transparent Ceramics at 50: Progress Made and Further Prospects

Adrian Goldstein et al.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2016)

Add to Collection

Article Chemistry, Physical

Effect of additives on the sintering of MgAl2O4

Taehyung Kim et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2014)

Add to Collection

Review Materials Science, Ceramics

Fifty Years of Research and Development Coming to Fruition; Unraveling the Complex Interactions during Processing of Transparent Magnesium Aluminate (MgAl2O4) Spinel

Marc Rubat du Merac et al.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2013)

Add to Collection

Article Materials Science, Ceramics

Fundamentals and applications on in situ spinel formation mechanisms in Al2O3-MgO refractory castables

E. Y. Sako et al.

CERAMICS INTERNATIONAL (2012)

Add to Collection

Article Materials Science, Multidisciplinary

Transparent Lu2O3:Eu ceramics by sinter and HIP optimization

Z. M. Seeley et al.

OPTICAL MATERIALS (2011)

Add to Collection

Article Materials Science, Ceramics

Transparent MgAl2O4 spinel ceramics produced by HIP post-sintering

Koji Tsukuma

JOURNAL OF THE CERAMIC SOCIETY OF JAPAN (2006)

Add to Collection

Article Materials Science, Ceramics

A new sintering aid for magnesium aluminate spinel

I Ganesh et al.

CERAMICS INTERNATIONAL (2001)

Add to Collection

© Peeref 2019-2024. All rights reserved.