☆ 4.7 Article

Characterising the bonding between asphalt ultra-thin layers applying a new cyclic shear test

INTERNATIONAL JOURNAL OF FATIGUE (2023)

Related references

Note: Only part of the references are listed.

Review Construction & Building Technology

Review: Shear Properties and Various Mechanical Tests in the Interface Zone of Asphalt Layers

Hatim M. Akraym et al.

Summary: Researchers have focused on the lack of interlayer bonding between asphalt layers in flexible pavements, which leads to premature pavement failures. Various factors such as tack coat material and surface characteristics influence the shear strength performance. Different types of materials and construction methods have been investigated to improve the bonding quality. The shear test is commonly used to verify the interlayer bonding strengths, and further research is recommended.

INFRASTRUCTURES (2023)

Add to Collection

Article Construction & Building Technology

Temperature Changes of Interlaminar Bonding Layer in Different Seasons and Effects on Mechanical Properties of Asphalt Pavement

Junjie Xu et al.

Summary: In this study, the effects of temperature changes on the mechanical responses of asphalt pavement were investigated using a discrete-element model. Results showed that temperature changes significantly affect the distribution of temperature within different depth ranges of the pavement, thereby influencing the state and mechanical properties of the interlaminar bond. Lower temperatures in winter increase the continuity of pavement layers and reduce compressive stress in the upper layer, while higher temperatures in summer weaken the interlaminar bond and increase horizontal tensile stress in the upper layer and at the interlaminar interface.

INTERNATIONAL JOURNAL OF PAVEMENT RESEARCH AND TECHNOLOGY (2022)

Add to Collection

Article Construction & Building Technology

Effect of Tack Coat and Milk Lime on the Asphalt Mix Interlayer Bond Strength

Saannibe Ciryle Some

Summary: This study investigated the impact of spreading milk lime over the tack coat layer on interlayer bond strength. The results show that using tack coat or tack coat + milk lime increases the bond strength, and the impact of milk lime on the bond strength is not significant at room temperature.

INTERNATIONAL JOURNAL OF PAVEMENT RESEARCH AND TECHNOLOGY (2022)

Add to Collection

Article Materials Science, Multidisciplinary

Adhesive Property and Road Performance Evaluation of Asphalt Overlay Pavement with Geotextile Interlayer

Haiwei Zhang et al.

Summary: The research found that the interface adhesive property of asphalt overlay with geotextile interlayer using SBS-modified asphalt is best at an application rate of 0.8 kg/m(2). Higher paving temperature is beneficial for improving the adhesion performance of the geotextile interlayer, while temperature has a smaller impact on the interlayer adhesion performance compared to water immersion.

ADVANCES IN MATERIALS SCIENCE AND ENGINEERING (2022)

Add to Collection

Article Construction & Building Technology

Investigating the use of equivalent elastic approach to identify the potential location of bending-induced interface debonding under a moving load

Bongsuk Park et al.

Summary: Poor interface bonding conditions in asphalt pavements lead to reduced bearing capacity and distresses, such as near-surface longitudinal cracking. Accurate prediction and identification of the potential location and extent of localized interface debonding is crucial in preventing further pavement damage.

MATERIALS AND STRUCTURES (2021)

Add to Collection

Article Construction & Building Technology

A new proposal to assess shear fatigue resistance of asphalt pavement interfaces

Rodrigo Miro et al.

Summary: In this study, the shear fatigue behavior of two interfaces with different stiffness was analyzed through cyclic compression tests. Fatigue laws for each type of interface were obtained, and by combining these laws with a calculation method, it was possible to estimate the number of cycles each interface could withstand under certain load assumptions.

ROAD MATERIALS AND PAVEMENT DESIGN (2021)

Add to Collection

Review Engineering, Civil

Characterization of bonding property in asphalt pavement interlayer: A review

Kai Yang et al.

Summary: Research has shown that higher requirements for interlayer bonding property are needed with the increase of traffic load, requiring correct characterization, analysis of influencing factors, and selection of appropriate tack coat rate. Future work should focus on the correlation between different test methods and evaluation parameters, as well as integrating the evaluation of interlayer bonding property into the pavement design system.

JOURNAL OF TRAFFIC AND TRANSPORTATION ENGINEERING-ENGLISH EDITION (2021)

Add to Collection

Article Construction & Building Technology

Use of epoxy asphalt as surfacing and tack coat material for roadway pavements

Panos Apostolidis et al.

CONSTRUCTION AND BUILDING MATERIALS (2020)

Add to Collection

Article Construction & Building Technology

Semi-empirical method for the calculation of shear stress, stiffness and maximum shear strength of bituminous interfaces under in-service conditions

Jorge Ortiz-Ripoll et al.

CONSTRUCTION AND BUILDING MATERIALS (2020)

Add to Collection

Article Engineering, Mechanical

Fatigue performance of interface bonding between asphalt pavement layers using four-point shear test set-up

Ali Rahman et al.

INTERNATIONAL JOURNAL OF FATIGUE (2019)

Add to Collection

Article Engineering, Civil

Mechanical Testing and Modeling of Interlayer Bonding in HMA Pavements

Sabine Leischner et al.

TRANSPORTATION RESEARCH RECORD (2019)

Add to Collection

Article Construction & Building Technology

Fatigue investigation on asphalt mixture layers' interface

Ivan Isailovic et al.

ROAD MATERIALS AND PAVEMENT DESIGN (2017)

Add to Collection

Review Construction & Building Technology

Application of tack coat in pavement engineering

Jiayu Wang et al.

CONSTRUCTION AND BUILDING MATERIALS (2017)

Add to Collection

Article Construction & Building Technology

Laboratory investigation of interlayer shear fatigue performance between open-graded friction course and underlying layer

Weimin Song et al.

CONSTRUCTION AND BUILDING MATERIALS (2016)

Add to Collection

Article Engineering, Chemical

Evaluation of the shear characteristics of steel-asphalt interface by a direct shear test method

Bo Yao et al.

INTERNATIONAL JOURNAL OF ADHESION AND ADHESIVES (2016)

Add to Collection

Article Engineering, Mechanical

Energy approach for the fatigue of thermoviscoelastic materials: Application to asphalt materials in pavement surface layers

M. Boudabbous et al.

INTERNATIONAL JOURNAL OF FATIGUE (2013)

Add to Collection

Article Construction & Building Technology

Influence of surface macro-texture and binder dosage on the adhesion between bituminous pavement layers

Aitor C. Raposeiras et al.

CONSTRUCTION AND BUILDING MATERIALS (2012)

Add to Collection

Article Construction & Building Technology

Experimental investigation of tack coat fatigue performance: Towards an improved lifetime assessment of pavement structure interfaces

M. Diakhate et al.

CONSTRUCTION AND BUILDING MATERIALS (2011)

Add to Collection

Article Construction & Building Technology

Numerical and Experimental Analysis for the Interlayer Behavior of Double-Layered Asphalt Pavement Specimens

Hyunwook Kim et al.

JOURNAL OF MATERIALS IN CIVIL ENGINEERING (2011)

Add to Collection

Article Construction & Building Technology

Shear bond strength between asphalt layers for laboratory prepared samples and field cores

A. C. Collop et al.

CONSTRUCTION AND BUILDING MATERIALS (2009)

Add to Collection

© Peeref 2019-2024. All rights reserved.