Related references
Note: Only part of the references are listed.
Article
Materials Science, Multidisciplinary
Z. Mamiyev et al.
Materials Today Sustainability
(2023)
Article
Engineering, Electrical & Electronic
Kahlaa H. Aboud et al.
Summary: A hydrothermal method was used to synthesize Ni-doped CdS (Ni-CdS) flowers-like nanostructures with high-surface area using different Ni concentrations. The structural, morphological, and optical characteristics were determined by various techniques. The results showed that increasing Ni doping concentration resulted in a decrease in the energy gap and the formation of flower-like nanostructures. The photocatalytic performance of the Ni-CdS films for organic dye degradation was evaluated under xenon light at room temperature.
JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS
(2023)
Article
Engineering, Electrical & Electronic
Y. Al-Douri et al.
JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS
(2023)
Article
Engineering, Electrical & Electronic
P. Vidhya et al.
Summary: In this study, p-PbS/n-Si photodiodes were successfully fabricated using the jet nebulizer spray pyrolysis technique. The effect of substrate temperature on the properties of PbS thin films was investigated. X-ray Diffraction (XRD) confirmed the crystal structure of the films, while Field Emission Transmission Microscopy (FESEM) revealed changes in morphology with increasing temperature. The UV-Vis absorption spectrum showed an increase in bandgap with deposition temperature. The fabricated p-PbS/n-Si diode exhibited excellent rectification and photovoltaic properties.
JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS
(2023)
Article
Engineering, Electrical & Electronic
M. Mohanraj et al.
Summary: By using jet nebulizer spray pyrolysis (JNSP), we have successfully created a highly sensitive P-N junction diode using nanostructured Ag-PbS films as the junction layer. The Ag-PbS films exhibited single-crystalline hexagonal phases and distinctive surface morphology with square-shaped grain structures at 3 wt% Ag content. The optical band-gap energy of the films increased with Ag concentration. We reported the photodiode features of nanostructure p-Si/n-Ag:PbS diodes, which showed positive photoresponse current under illumination. The diode with 3 wt% Ag content achieved high responsivity, minimum ideality factor, and maximum barrier, making it suitable for photo-detector applications.
JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS
(2023)
Article
Engineering, Electrical & Electronic
Mitesh H. Patel et al.
Summary: A solid state in situ thermolysis technique was used to produce PbS/polyethylene oxide (PEO)/polyvinyl pyrrolidone (PVP) nanocomposite films with varying concentrations of Pb2+-Tu complex. X-ray diffractogram investigation confirmed the presence of PbS in the PEO/PVP blend network. Transmission electron microscopy analysis revealed the size and shape of the PbS nanoparticles in the PEO/PVP matrix. UV-Vis-NIR spectroscopy showed that the bandgap energies of the PbS/PVP/PEO nanocomposite films decreased with increasing stoichiometric concentration of Pb2+-TU complex. FTIR spectroscopy was used to study the hydrogen bonding between PEO and PVP and the interaction of PbS with PEO/PVP. Electrochemical impedance spectroscopy was utilized to investigate the effect of Pb2+-TU complex concentration on the electrical characteristics of PEO/PVP.
JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS
(2023)
Article
Electrochemistry
Yu. Parasotchenko et al.
Summary: In this study, the kinetics of silicon electrodeposition and the initial stages of the process were investigated using various electrochemical methods. The reduction of silicon at the cathode was found to occur in one irreversible stage. The diffusion coefficient of silicon ions was determined to be 8.44 x 10(-11) and 1.00 x 10(-10) m(2) s(-1) using cyclic voltammetry and chronoamperometry, respectively. The electrodeposition of silicon on glassy carbon was found to proceed progressively with the continuous formation of new nuclei. The obtained silicon films had a thickness of several microns and consisted of spherical nuclei up to 0.7 microns in diameter. The impurity content in the deposits was extremely low, with oxygen being the main contaminant (0.4-1.2 wt%).
JOURNAL OF THE ELECTROCHEMICAL SOCIETY
(2023)
Article
Energy & Fuels
Li Wang et al.
Summary: High-efficiency silicon-based tandem solar cells have the potential to drive the production of terawatt-scale PV and achieve net zero emissions by 2050. This study analyzes the material consumption and sustainability issues of future tandem solar cells. It shows that perovskites are the most sustainable option for the top cell, while the PERC cell architecture with Al as the rear p-type contact can significantly reduce silver consumption compared to TOPCon and SHJ. Rapid upscaling is needed to support the transition towards terawatt-scale manufacturing. This research emphasizes the importance of considering sustainability when designing high-efficiency tandem cells to mitigate the dangers of climate change.
PROGRESS IN PHOTOVOLTAICS
(2023)
Article
Chemistry, Multidisciplinary
Muhammad Monirul Islam et al.
Summary: In this study, silicon films were deposited on low-cost graphite substrates by electrochemical reduction. The results showed that the crystallinity and morphology of the deposited silicon films could be improved by controlling the reduction potential, and the substrate materials and particle size also had an influence on the film morphology.
Article
Chemistry, Physical
Jun-Sik Cho et al.
Summary: Transparent photovoltaic tandem devices with controlled absorber thickness exhibited high power conversion efficiencies and improved performance under bifacial illumination. These devices maintained excellent PV performance even at low-light intensities.
APPLIED SURFACE SCIENCE
(2022)
Article
Chemistry, Physical
Hua Lv et al.
Summary: A novel WS2/Mn0.5Cd0.5S/CuInS2 hierarchical tandem p-n heterostructure was constructed based on energy band engineering theory, achieving effective charge separation and sufficient light harvesting for enhanced photocatalytic hydrogen production.
APPLIED SURFACE SCIENCE
(2022)
Review
Energy & Fuels
Xiaopu Wang et al.
Summary: With the exponential increase in global installations, the number of end-of-life solar PV panels is also surging. However, current recycling technology studies are mainly in the experimental stage and often overlook the issues of high cost, low recycling value, and secondary pollution. This review provides a systematic summary of the recycling technologies and condition parameters for end-of-life PV modules, discusses the strengths and weaknesses of current technologies, and explores future research directions. It aims to serve as a technical reference for the upcoming recycling surge of end-of-life PV modules worldwide.
SOLAR ENERGY MATERIALS AND SOLAR CELLS
(2022)
Article
Engineering, Electrical & Electronic
Yonghong Xiao et al.
Summary: In this study, we investigated the preparation of PbS thin films using magnetron sputtering at room temperature and studied the effect of process parameters and post-annealing conditions. By optimizing the sputtering parameters and post-annealing conditions, we successfully fabricated a p-Si/n-PbS heterojunction infrared detector based on sputtered PbS thin films.
JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS
(2022)
Article
Chemistry, Physical
Faisal K. Algethami et al.
Summary: This study investigates the photocatalytic properties of nanohybrids composed of PbS nanoparticles decorated silicon nanowires for wastewater treatment. The results show that the decorated PbS/SiNWs nanohybrids exhibit enhanced photocatalytic degradation, suggesting their potential as efficient photocatalytic systems for organic compound purification from wastewaters.
Article
Chemistry, Physical
Km Kanchan et al.
Summary: In this article, a thin-film solar cell based on non-toxic materials is proposed to enhance the performance of the solar cell while reducing the use of toxic materials. The optimized thin-film structure achieves improved conversion efficiency compared to previous reports.
Article
Engineering, Electrical & Electronic
Zein K. Heiba et al.
Summary: In this study, PbSx thin films were prepared using spin coating method, and the structures, microstructures, and optical properties of the films were investigated using various techniques. The experimental results show that the direct band gap transition values of the PbSx films increase with the reduction of sulfur.
JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS
(2022)
Review
Engineering, Electrical & Electronic
J. Ajayan et al.
Summary: In this article, the issues and challenges of transferring GaN or AlGaN channel HEMTs onto Si-wafers are critically reviewed. The popular architectures and techniques for enhancing their breakdown performance are highlighted, along with the challenges in fabrication and reliability issues.
MATERIALS SCIENCE IN SEMICONDUCTOR PROCESSING
(2022)
Article
Metallurgy & Metallurgical Engineering
O. B. Pavlenko et al.
Summary: The possibility of silicon electrodeposition using different electrolytes was investigated in this study. The kinetics of silicon electrowinning, diffusion coefficients of silicon ions, and the structure and morphology of the deposited silicon were studied.
RUSSIAN METALLURGY
(2022)
Article
Chemistry, Multidisciplinary
Jae Hyun Park et al.
Summary: This article presents a characterization platform for the sub-cell analysis of monolithic two-terminal PVSK/Si TSCs and reports a comprehensive set of electrical characterization methods.
CELL REPORTS PHYSICAL SCIENCE
(2022)
Article
Engineering, Electrical & Electronic
Yesica B. Castillo-Sanchez et al.
Summary: PbS thin films were chemically deposited on glass substrates using alkaline aqueous solutions containing glycine-Pb complexes, forming highly compact and adherent films with pyramid-like particles. The specular nature and compactness of the films were enhanced with the increase of the bath pH, confirmed through the analysis of optical and electrical properties. The optical band gap energy and conductivity of the photosensitive PbS films were found in a specific range, leading to investigation of photovoltaic characteristics in CdS/PbS heterojunction devices.
MATERIALS SCIENCE IN SEMICONDUCTOR PROCESSING
(2021)
Article
Engineering, Electrical & Electronic
S. Aldawood et al.
Summary: The study developed an (n)PbS-(p)Si hetero-structure by depositing lead sulfide (PbS) nanostructure thin films on a p-type Si wafer using the SILAR method. The effects of gamma-ray irradiation on the structural and optical properties of the hetero-structure were investigated, showing improvements in crystalline structure and reduction in recombination rate at 50 kGy dose level. However, a reverse trend was observed at 75 kGy dose.
JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS
(2021)
Article
Engineering, Electrical & Electronic
L. N. Maskaeva et al.
Summary: The study demonstrated the possibility of forming thin-film two-phase compositions CdxPb1-xS/Cd1-delta S using chemical bath deposition with the addition of various cadmium salts. The results showed that the composition of the films deposited with different cadmium salts could vary due to the effect of the salts' anionic component on the kinetics of thiourea decomposition. This finding may have significant implications for the development of solar cells.
JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS
(2021)
Article
Physics, Condensed Matter
L. N. Maskaeva et al.
Article
Chemistry, Physical
R. Kh. Saryeva et al.
RUSSIAN JOURNAL OF PHYSICAL CHEMISTRY A
(2020)
Article
Electrochemistry
M. Laptev et al.
JOURNAL OF THE ELECTROCHEMICAL SOCIETY
(2020)
Review
Chemistry, Applied
Mihir Kumar Sahoo et al.
MICROPOROUS AND MESOPOROUS MATERIALS
(2019)
Article
Chemistry, Inorganic & Nuclear
Mohsen Kord et al.
MAIN GROUP METAL CHEMISTRY
(2017)
Article
Engineering, Electrical & Electronic
Umit Cagri Ust et al.
MATERIALS SCIENCE IN SEMICONDUCTOR PROCESSING
(2016)
Article
Materials Science, Multidisciplinary
B. P. Singh et al.
MATERIALS RESEARCH EXPRESS
(2015)
Article
Materials Science, Multidisciplinary
W. Han et al.
MATERIALS TECHNOLOGY
(2009)
