4.8 Article

Long-term phosphorus removal by Ca and Fe-rich drainage filter materials under variable flow and inlet concentrations

Journal

WATER RESEARCH
Volume 247, Issue -, Pages -

Publisher

PERGAMON-ELSEVIER SCIENCE LTD
DOI: 10.1016/j.watres.2023.120792

Keywords

Phosphorus losses; Agricultural tile drainage water; Filter materials; Long-term removal efficiency; Sensitivity analysis

Ask authors/readers for more resources

This study investigated the long-term phosphorus removal efficiency of 5 different filter materials and found that iron-based materials had higher phosphorus retention capacity. Specifically, ferric hydroxide granules were able to retain 99% and 98% of high and low inlet phosphorus concentrations respectively. In contrast, limestone retained only 25% of the high phosphorus load.
Phosphorus (P) losses from tile-drained agricultural fields may degrade surface water quality by accelerating eutrophication. Among the different edge-of-field technologies, compact filter systems using different filter materials have been identified as potentially effective solutions for removing P from drainage water before discharge downstream.This study investigated the long-term (>696 days) P removal efficiency of 5 different filter materials in a column setup, using artificial drainage water (pH 6). Filter materials included two iron-based granulates (cal-cinated diatomaceous earth (CDE), ferric hydroxide granules (CFH)), and three calcium-based granulates (sea-shells, limestone, calcinated silicate/calcium oxide (Filtralite-P)). Experiments were performed under variable flow rates (0.037 and 1.52 L h(-1); hydraulic retention time of 26-43 min and 18-30 h) and inlet P concentrations (0.14 and 0.7 mg L-1). An overall analysis revealed that the Fe-based materials achieved higher P retention than Ca-based materials. In particular, CFH was capable of retaining 99 and 98 % of the high and low inlet P concentrations, respectively. Conversely, limestone retained only 25 % of the high P load. CDE performed moderately well, independently of the inlet P concentration. Filtralite-P and Seashells performed well at high inlet P concentration but relatively poorly at low P concentration. The sensitivity of filter material P removal efficiency to variations in P loading was generally lowest for CFH and highest for limestone.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.8
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available