Related references
Note: Only part of the references are listed.Estimation of elastic-plastic strain response at two-dimensional notches
Dale L. Ball
FATIGUE & FRACTURE OF ENGINEERING MATERIALS & STRUCTURES (2020)
Frequency Dependent Fatigue Strength Investigations on Tempered Steel and Nodular Cast Iron
Philipp Thumann et al.
STEEL RESEARCH INTERNATIONAL (2019)
Use of non-destructive testing methods in a new one-specimen test strategy for the estimation of fatigue data
P. Starke et al.
INTERNATIONAL JOURNAL OF FATIGUE (2018)
Very High Cycle Fatigue Resistance of the Low Alloyed Steel 42CrMo4 in Medium- and High-Strength Quenched and Tempered Condition
K. -H. Lang et al.
21ST EUROPEAN CONFERENCE ON FRACTURE, (ECF21) (2016)
Influence of defects on fatigue strength and failure mechanisms in the VHCF-region for quenched and tempered steel and nodular cast iron
B. Pyttel et al.
INTERNATIONAL JOURNAL OF FATIGUE (2012)
New fatigue life calculation method for quenched and tempered steel SAE 4140
Peter Starke et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2009)
Fatigue Assessment and Fatigue Life Calculation of Metals on the Basis of Mechanical Hysteresis, Temperature, and Resistance Data
Peter Starke et al.
MATERIALS TESTING-MATERIALS AND COMPONENTS TECHNOLOGY AND APPLICATION (2009)
Investigation of the dependences of the mechanical characteristics of an alloyed steel on both the strain rate and the microstructure
M. Homayonifar et al.
JOURNAL OF STRAIN ANALYSIS FOR ENGINEERING DESIGN (2007)
PHYBAL - A new method for lifetime prediction based on strain, temperature and electrical measurements
P. Starke et al.
INTERNATIONAL JOURNAL OF FATIGUE (2006)
Local strain measurement for prediction of fatigue macrocrack initiation in notched specimens
OP Ostash et al.
STRAIN (2003)
Elasto-plastic stress and strain behaviour at notch roots under monotonic and cyclic loadings
Z Zeng et al.
JOURNAL OF STRAIN ANALYSIS FOR ENGINEERING DESIGN (2001)
Share Paper
