4.7 Article

Impact of synthetic C-S-H seeds on early hydration and pore structure evolution of cement pastes: A study by 1H low-field NMR and path analysis

Related references

Note: Only part of the references are listed.
Article Construction & Building Technology

Structural supercapacitor electrolytes based on cementitious composites containing recycled steel slag and waste glass powders

Peimin Zhan et al.

Summary: Incorporating solid wastes into cement-based materials is beneficial for waste disposal and conservation of resources. This study proposes the use of recycled steel slag powder and waste glass powder in a cement-based electrolyte for assembling structural supercapacitor cells. The addition of these materials significantly improves the conductivity and capacitance of the cells, and their presence enhances ion transport paths and ion concentration, leading to enhanced energy storage performance. With the appropriate amount of waste glass powder, the strength loss caused by steel slag powder can be compensated, making the proposed cement-based electrolyte competitive for green building energy storage devices.

CEMENT & CONCRETE COMPOSITES (2023)

Article Construction & Building Technology

Novel in-situ controllably grown CSH: Synthesis, characterization and the effect on cement hydration

Bao Liu et al.

Summary: CSH nanoparticles can be used as ideal nucleation substrates for hydration products, but achieving good dispersion in the matrix is challenging. This study presents a novel method for in-situ growing CSH nanoparticles on the surface of iron tailings powder particles, which allows precise control over the growth amount and Ca/Si ratio of CSH. The results show that the dispersion of CSH nanoparticles can be improved by using the inert iron tailings powder admixture, leading to enhanced properties of the modified cement.

CEMENT & CONCRETE COMPOSITES (2023)

Article Construction & Building Technology

Reducing clinker factor in limestone calcined clay-slag cement using C-S-H seeding-A way towards sustainable binder

Xuerun Li et al.

Summary: C-S-H seeding was used to reduce the OPC content while maintaining comparable strength in LC3 cement. The combination of calcined clay with supplementary cementitious materials such as microsilica, slag, and fly ash was investigated. The results showed that C-S-H seeding significantly enhanced strength and allowed for a lower OPC content. Correlations of heat release and pore size with strength demonstrated that C-S-H seeding increased strength through acceleration and microstructural changes.

CEMENT AND CONCRETE RESEARCH (2023)

Article Engineering, Chemical

Design and assessment of eco-friendly ultra-high performance concrete with steel slag powder and recycled glass powder

Jing Xu et al.

Summary: An eco-friendly ultra-high performance concrete (UHPC) was designed by partially replacing cement with steel slag powder (SSP) and glass powder (GP) at a fixed mass ratio of 2:1 based on the modified Andreasen and Andersen packing model. The combination of SSP and GP replacement improved the strength and resistance to drying shrinkage, with the best performance achieved at a 20% replacement ratio. The leaching of ions from SSP and GP promoted cement hydration, leading to the formation of extra hydration products, such as high density C-S-H, which refined the pore structure of the paste matrix and enhanced the steel fiber/paste interaction. The UHPC developed with SSP and GP exhibited lower carbon emissions and non-renewable energy consumption, implying its potential for industrial applications.

POWDER TECHNOLOGY (2023)

Article Construction & Building Technology

Limestone calcined clay binders based on a Belite-rich cement

Cinthya Redondo-Soto et al.

Summary: LC3 is a type of concrete material that can reduce the CO2 footprint by 40%. It has high content of belite and exhibits excellent durability performance.

CEMENT AND CONCRETE RESEARCH (2023)

Article Construction & Building Technology

Use of recycled concrete aggregates as carriers for self-healing of concrete cracks by bacteria with high urease activity

Xianzhi Wang et al.

Summary: Microbial induced carbonate precipitation (MICP) is an attractive strategy for self-healing of concrete cracks. This study investigated the potential of using recycled concrete aggregates (RCAs) as microbial carriers and found that RCAs can retain bacterial activity and achieve significant crack healing in concrete. After microbial self-healing, the material regained its mechanical strength and water tightness, and the cracks were filled with densely packed calcite and vaterite crystals.

CONSTRUCTION AND BUILDING MATERIALS (2022)

Article Construction & Building Technology

The effect of bacteria Bacillus Cohnii on the synthesised calcium silicate hydrate (C-S-H) with various calcium to silica ratio in nanoscale

Linzhen Tan et al.

Summary: This study investigates the individual impact of bacteria on synthesised C-S-H gel and the potential of biomineralisation of C-S-H gel. It is found that C-S-H can be biomineralised to produce a considerable amount of calcium carbonate. The amount of precipitated CaCO3 is closely related to Ca/Si ratio in C-S-H.

CEMENT & CONCRETE COMPOSITES (2022)

Article Construction & Building Technology

Impact of C-S-H seeding on hydration and strength of slag blended cement

Xuerun Li et al.

Summary: The impact of C-S-H seeding on the hydration of slag blended cement was investigated. Results showed that C-S-H seeding significantly improved the strength performance of slag blended cement by altering the microstructure and refining the porosity.

CEMENT AND CONCRETE RESEARCH (2022)

Article Construction & Building Technology

Synthesis and structure of calcium silicate hydrate (C-S-H) modified by hydroxyl-terminated polydimethylsiloxane (PDMS)

Zheyu Zhu et al.

Summary: Calcium silicate hydrate (C-S-H) is the main hydration product of cement, and its micro-nano-structure significantly affects the properties of cement-based materials. Modifying the structure of C-S-H with PDMS can improve connectivity and morphology, leading to enhanced water contact angles and overall performance of the materials.

CONSTRUCTION AND BUILDING MATERIALS (2021)

Article Construction & Building Technology

Investigation of hydration and setting process in nanosilica-cement blended pastes: In situ characterization using low field nuclear magnetic resonance

Anming She et al.

Summary: The effect of nano-SiO2 addition on early properties of Portland cement paste was characterized using low-field nuclear magnetic resonance (NMR). Results showed that increasing nano-SiO2 addition accelerates the hydration process of cement and enhances early compressive strength. Low-field NMR technology is effective in predicting the strength and setting time of cement due to its non-destructive and non-invasive characteristics.

CONSTRUCTION AND BUILDING MATERIALS (2021)

Article Construction & Building Technology

Pore connectivity of oil well cement in the early hydration stage by in situ electrical resistivity measurements and low-field nuclear magnetic resonance

Kaiqiang Liu et al.

Summary: This study developed an in situ evaluation method for the pore connectivity of cement slurry, which can investigate its porosity, pore size, and pore connectivity. The experimental results showed that the porosity and pore size of the cement slurry changed during hydration, while the pore connectivity was reduced by the presence of SiO4 species.

CONSTRUCTION AND BUILDING MATERIALS (2021)

Article Construction & Building Technology

Multi-scale study on synergistic effect of cement replacement by metakaolin and typical supplementary cementitious materials on properties of ultra-high performance concrete

Peimin Zhan et al.

Summary: The research discovered that partially replacing cement with metakaolin and other supplementary cementitious materials can significantly enhance the performance of ultra-high performance concrete, such as compressive strength and permeability resistance. In particular, the additional use of blast furnace slag plays a crucial role in improving mechanical properties and permeability, while maintaining dimensional stability and early strength.

CONSTRUCTION AND BUILDING MATERIALS (2021)

Article Construction & Building Technology

A novel method for semi-quantitative analysis of hydration degree of cement by 1H low-field NMR

Heng Liu et al.

Summary: A novel method and model have been developed to analyze the hydration degree of cement paste using the analytical H-1 low-field NMR technique. The hydration degree can be quantitatively calculated based on T-2 distributions, with significant correlations found between T-2 values and hydration degree under different curing conditions.

CEMENT AND CONCRETE RESEARCH (2021)

Article Construction & Building Technology

Hydration and microstructural development of calcined clay cement paste in the presence of calcium-silicate-hydrate (C-S-H) seed

Diandian Zhao et al.

Summary: The introduction of calcium-silicate-hydrate (C-S-H) seed clearly accelerated the hydration of cement and enhanced its hydration degree, even at later ages. The presence of seed also modified the composition of the inner products formed around the anhydrous cement grains. The combination of calcined clay and C-S-H seed allowed for high replacement levels of cement without compromising its mechanical properties.

CEMENT & CONCRETE COMPOSITES (2021)

Article Construction & Building Technology

Hydration of Portland cement accelerated by C-S-H seeds at different temperatures

Herman Camilo Pedrosa et al.

CEMENT AND CONCRETE RESEARCH (2020)

Article Construction & Building Technology

Enhanced performances of cement and powder silane based waterproof mortar modified by nucleation C-S-H seed

Haoxin Li et al.

CONSTRUCTION AND BUILDING MATERIALS (2020)

Article Construction & Building Technology

A comparison of the influence of micro- and nano-silica on hydration kinetics of Portland cement under different temperatures

Cong Ma et al.

CONSTRUCTION AND BUILDING MATERIALS (2020)

Article Construction & Building Technology

The acceleration mechanism of nano-C-S-H particles on OPC hydration

Fang Wang et al.

CONSTRUCTION AND BUILDING MATERIALS (2020)

Article Construction & Building Technology

Study on the hydration and moisture transport of white cement containing nanomaterials by using low field nuclear magnetic resonance

Ai Zhang et al.

CONSTRUCTION AND BUILDING MATERIALS (2020)

Article Construction & Building Technology

Evolution of pore structure of oil well cement slurry in suspension-solid transition stage

Kaiqiang Liu et al.

CONSTRUCTION AND BUILDING MATERIALS (2019)

Article Engineering, Multidisciplinary

Effects of microstructure and pore water on electrical conductivity of cement slurry during early hydration

Kaiqiang Liu et al.

COMPOSITES PART B-ENGINEERING (2019)

Article Construction & Building Technology

Effects of nano-SiO2 on early strength and microstructure of steam-cured high volume fly ash cement system

Min Liu et al.

CONSTRUCTION AND BUILDING MATERIALS (2019)

Article Construction & Building Technology

Pore-size resolved water vapor adsorption kinetics of white cement mortars as viewed from proton NMR relaxation

Chunsheng Zhou et al.

CEMENT AND CONCRETE RESEARCH (2018)

Review Construction & Building Technology

Nucleation seeding with calcium silicate hydrate - A review

Elisabeth John et al.

CEMENT AND CONCRETE RESEARCH (2018)

Article Construction & Building Technology

Why permeability to water is anomalously lower than that to many other fluids for cement-based material?

Chunsheng Zhou et al.

CEMENT AND CONCRETE RESEARCH (2017)

Article Construction & Building Technology

In situ 1H-TD-NMR: Quantification and microstructure development during the early hydration of alite and OPC

Dominique Ectors et al.

CEMENT AND CONCRETE RESEARCH (2016)

Article Construction & Building Technology

A 1H NMR relaxometry investigation of gel-pore drying shrinkage in cement pastes

A. M. Gajewicz et al.

CEMENT AND CONCRETE RESEARCH (2016)

Article Chemistry, Physical

Surface Relaxivity of Cement Hydrates

Florent Dalas et al.

JOURNAL OF PHYSICAL CHEMISTRY C (2014)

Review Construction & Building Technology

The morphology of C-S-H: Lessons from 1H nuclear magnetic resonance relaxometry

A. Valori et al.

CEMENT AND CONCRETE RESEARCH (2013)

Article Construction & Building Technology

Rietveld refinement of the structures of 1.0 C-S-H and 1.5 C-S-H

Francesco Battocchio et al.

CEMENT AND CONCRETE RESEARCH (2012)

Article Construction & Building Technology

Synthesis and nano-mechanical characterization of calcium-silicate-hydrate (C-S-H) made with 1.5 CaO/SiO2 mixture

Emmy M. Foley et al.

CEMENT AND CONCRETE RESEARCH (2012)

Article Construction & Building Technology

Use of nano-silica to reduce setting time and increase early strength of concretes with high volumes of fly ash or slag

Min-Hong Zhang et al.

CONSTRUCTION AND BUILDING MATERIALS (2012)

Article Construction & Building Technology

Embedded NMR sensors to monitor evaporable water loss caused by hydration and drying in Portland cement mortar

P. F. de J. Cano-Barrita et al.

CEMENT AND CONCRETE RESEARCH (2009)

Article Chemistry, Physical

Influence of Nucleation Seeding on the Hydration Mechanisms of Tricalcium Silicate and Cement

Jeffrey J. Thomas et al.

JOURNAL OF PHYSICAL CHEMISTRY C (2009)

Article Materials Science, Ceramics

A new approach to modeling the nucleation and growth kinetics of tricalcium silicate hydration

Jeffrey J. Thomas

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2007)

Article Construction & Building Technology

Microstructure and texture of hydrated cement-based materials: A proton field cycling relaxometry approach

J. -P. Korb et al.

CEMENT AND CONCRETE RESEARCH (2007)