Related references
Note: Only part of the references are listed.
Article
Engineering, Electrical & Electronic
Shuiqing Xu et al.
Summary: This paper proposes a simultaneous diagnosis method for power switch open-circuit faults and current sensor faults of grid-connected three-level neutral point clamped (NPC) inverters. By designing an adaptive reaching law and reducing the steady-state resonance, a novel interval sliding model observer is developed to accurately and rapidly track and estimate the three-phase currents. A faulty phase detection scheme and identification methods are proposed to achieve sensitive and robust detection and identification results. Hardware-in-the-loop test results validate the effectiveness and robustness of the proposed method.
IEEE TRANSACTIONS ON POWER ELECTRONICS
(2023)
Article
Computer Science, Information Systems
Shuguang Li et al.
Summary: This paper discusses the bicriteria problem of scheduling n jobs on an unbounded parallel-batch machine, aiming to minimize both makespan and maximum cost simultaneously. Improved algorithms with O(n3) time complexity are proposed for jobs with arbitrary processing times and equal release dates, as well as for jobs with equal processing times and arbitrary release dates with a precedence relation. The latter algorithm is the first polynomial time algorithm for this problem.
INFORMATION PROCESSING LETTERS
(2023)
Article
Automation & Control Systems
Bin Cao et al.
Summary: The wide area measurement system based on synchronous phasor measurement technology is crucial for dynamic monitoring and wide area protection in modern power systems. This article discusses incomplete observability under single PMU loss and its impact on PMU placement, proposing an improved two-archive algorithm for placement optimization and a fuzzy decision-making method for selecting the best solution. Tests on IEEE bus systems and the Polish 2383-bus system confirm the effectiveness of the proposed method.
IEEE TRANSACTIONS ON INDUSTRIAL INFORMATICS
(2023)
Article
Telecommunications
Mohammed Elbes et al.
Summary: Location-based services(LBS) have revolutionized the operation of smart cities and smart buildings by providing a complete layered architecture, offering new experiences to citizens, and providing collaborative features and services in power management.
TRANSACTIONS ON EMERGING TELECOMMUNICATIONS TECHNOLOGIES
(2022)
Article
Energy & Fuels
Leijiao Ge et al.
Summary: This paper discusses the importance of high-quality operation and maintenance in smart distribution networks (SDN) for meeting the requirements of high-tech enterprises for high power quality. Situation awareness (SA) is identified as a significant element in enhancing high-quality operation and maintenance, particularly after the integration of intermittent renewable energy into SDN. The paper decomposes SA into detection, comprehension, and projection stages and presents a five-layer visualization framework. It provides insights into the technical achievements, barriers, and future research directions of SDN SA for researchers and utility engineers.
Article
Green & Sustainable Science & Technology
Jiahao Chen et al.
Summary: This paper proposes a method for calculating the credible capacity of distributed generation (DG) based on equal power supply reliability criterion, taking into account both the unserved electricity under fault state and the insufficient power supply under normal state. By utilizing optimization models and a load curtailment model, it is found that ignoring the insufficient electricity under normal state can lead to a significant deviation in the credible capacity value.
Article
Energy & Fuels
M. Osama Abed Elraouf et al.
Summary: This paper mitigates misfire and fire-through faults in the inverter that connects renewable sources to the grid by optimizing a PI controller using particle swarm optimization. Improved system performance is achieved through voltage, current, and power waveforms, and the renewable sources remain connected during these faults.
Review
Engineering, Mechanical
Teng Gao et al.
Summary: Fiber-reinforced composites have been widely used in aviation and aerospace industries due to their high-strength performance. However, their complex structure makes them difficult to machine. This review summarizes the progress in understanding the damage formation mechanisms and the strategies to suppress them during milling and grinding of fiber-reinforced composites. The review covers mechanisms of milling damage, grinding mechanisms, and various suppression strategies such as ultrasonic vibration-assisted machining, cryogenic cooling, minimum quantity lubrication (MQL), and tool optimization design.
FRONTIERS OF MECHANICAL ENGINEERING
(2022)
Article
Automation & Control Systems
Haris M. Khalid et al.
Summary: The rapid adoption of electric vehicles has led to the development of vehicle-to-grid (V2G) technology in smart grids, but it may have negative effects on battery aging. To address this issue, a median expectation-based regression approach is proposed for parameter estimation of vehicle batteries in V2G systems. The method utilizes Gaussian processes and coherence models to predict and detect battery variations.
IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS
(2022)
Article
Engineering, Electrical & Electronic
Xiangmin Xie et al.
Summary: The piecewise probabilistic HPF method proposed in this paper can effectively evaluate the harmonic emission level of residential loads. This method combines the piecewise probabilistic harmonic coupled model and the decoupled calculation method, and uses field theory to evaluate the probabilistic harmonics of unbalanced residential distribution systems.
INTERNATIONAL JOURNAL OF ELECTRICAL POWER & ENERGY SYSTEMS
(2022)
Article
Energy & Fuels
Cheng Zhong et al.
Summary: This study proposes a DC-side synchronous active power control method for two-stage photovoltaic power generation without energy storage. The control strategy applies synchronous active power control to DC-DC converters while maintaining a constant DC-link voltage with the grid-tied inverter. A sensorless iterative maximum power estimation method is introduced and integrated into the DC-side virtual synchronous generator control strategy. Case studies on an islanded microgrid are conducted to validate the effectiveness and advantages of the control strategy, demonstrating improved frequency response and DC-link voltage stability under changing irradiance conditions.
Article
Energy & Fuels
Bing Sun et al.
Summary: This study proposes an optimization planning method considering wind and PV electricity curtailment measure, and solves the optimization model through the steady-state security region of the distribution network. Under the principle of economic consumption, the penetration rate of renewable energy electricity can be effectively improved.
Review
Engineering, Manufacturing
Wenhao Xu et al.
Summary: This study provides a comprehensive review and critical assessment of electrostatic atomization MQL, including its critical equipment, lubrication and heat transfer mechanisms, and comparison with pneumatic atomization MQL. Previous experiments have shown that electrostatic atomization MQL improves machining performance. Future development directions are proposed.
INTERNATIONAL JOURNAL OF EXTREME MANUFACTURING
(2022)
Review
Energy & Fuels
Leijiao Ge et al.
Summary: This paper provides a comprehensive and systematic review of virtual collection in distributed photovoltaic systems (DPVS). The challenges and main methods applicable to virtual collection are identified through problem analogy. The diversified application scenarios of virtual collection are also discussed, aiming to provide helpful information for the development of the DPVS industry.
Article
Engineering, Multidisciplinary
A. Ashabi et al.
Summary: The paper proposes a simple techno-economic model for evaluating the feasibility of a building-integrated battery energy storage system. By introducing the energy to power ratio factor, the model can calculate the optimal battery size based on the Benefit-cost ratio and a peak shaving iterative model.
INTERNATIONAL JOURNAL OF ENGINEERING
(2022)
Article
Engineering, Electrical & Electronic
Libang Guo et al.
Summary: This paper proposes a 5G-based centralized switch FCL framework and an optimal allocation method for flexible FCLs. By using the FD model, online FCL switching schemes are provided to meet the fast requirement of power system protection. Furthermore, a bi-level FCL allocation model is established, considering installation and expected switching costs, to determine the optimal FCL allocation strategy.
IEEE TRANSACTIONS ON POWER DELIVERY
(2021)
Article
Computer Science, Information Systems
Bin Cao et al.
Summary: An improved RFID reader anticollision model is proposed in this article, utilizing intelligent computing technologies and distributed parallel cooperative co-evolution particle swarm optimization to address the high-dimensional problem of dense deployment of large numbers of readers.
IEEE INTERNET OF THINGS JOURNAL
(2021)
Article
Engineering, Industrial
Yuying Yang et al.
Summary: A novel hybrid approach combining DED and thermal milling is developed for producing complex structural parts with ideal dimensional accuracy. The research findings show that 316L SS specimens exhibit high microhardness and tensile strength under optimal process parameters. The tensile strength values obtained from the hybrid DED and thermal milling process are significantly higher than those from other manufacturing methods.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY
(2021)
Article
Green & Sustainable Science & Technology
Mohammed Kharrich et al.
Summary: Hybrid microgrids offer a solution to electrical energetic problems by integrating renewable energy sources, but their economic viability is limited. Therefore, the optimal configuration should be selected based on the quality and availability of sustainable energy sources, and the design of microgrid components.
Article
Chemistry, Multidisciplinary
Mohammad Ghiasi et al.
Summary: Today, in developing countries, achieving optimal energy management with cost reduction and emission reduction is crucial for power utilities. The use of renewable energy sources is an effective way to achieve these goals. In this research, an improved multi-objective differential evolutionary optimization algorithm is suggested for dispatching electricity in a smart microgrid system while considering economic and emission factors.
APPLIED SCIENCES-BASEL
(2021)
Article
Mathematics, Interdisciplinary Applications
Xianqiang Bao et al.
Summary: In this paper, an optimal energy storage system capacity determination method for a marine ferry ship with diesel generators and PV panels is proposed. The ESSs sizing optimization and power system scheduling optimization are conducted simultaneously, converted into a mixed-integer quadratic programming model. The study demonstrates that the method is flexible and effective, investigating the relationships between ESSs size and discharge rate, life cycle times, or initial investment cost.
DISCRETE DYNAMICS IN NATURE AND SOCIETY
(2021)
Article
Engineering, Electrical & Electronic
Chao Guo et al.
Summary: This paper develops a fragile model to evaluate nodal SCF probability and presents a response framework for extreme weather events, optimizing measures to ensure system transient stability.
IEEE TRANSACTIONS ON POWER DELIVERY
(2021)
Article
Engineering, Electrical & Electronic
Srinivas Sandeep Kumar Reddy Vaka et al.
Summary: Microgrids with suitable Energy Storage Systems (ESS) offer a solution to energy crisis by improving energy efficiency, reducing consumption, and enhancing power supply reliability. Proper energy management and power allocation can minimize operating costs, with optimal sizing of ESS contributing to meeting load criteria.
ELECTRIC POWER COMPONENTS AND SYSTEMS
(2021)
Article
Computer Science, Information Systems
Haris M. Khalid et al.
IEEE SYSTEMS JOURNAL
(2020)
Review
Computer Science, Information Systems
Zimran Rafique et al.
Article
Green & Sustainable Science & Technology
Jianchao Zhang et al.
JOURNAL OF CLEANER PRODUCTION
(2018)
Article
Engineering, Aerospace
Li Benkai et al.
CHINESE JOURNAL OF AERONAUTICS
(2016)
Article
Engineering, Electrical & Electronic
J. J. Jamian et al.
INTERNATIONAL JOURNAL OF ELECTRICAL POWER & ENERGY SYSTEMS
(2014)
Article
Engineering, Electrical & Electronic
Guido Carpinelli et al.
IEEE TRANSACTIONS ON SMART GRID
(2013)
Article
Engineering, Electrical & Electronic
Samuele Grillo et al.
IEEE TRANSACTIONS ON SMART GRID
(2012)
Article
Engineering, Electrical & Electronic
S. X. Chen et al.
IEEE TRANSACTIONS ON SMART GRID
(2012)
Article
Engineering, Electrical & Electronic
Changsong Chen et al.
IEEE TRANSACTIONS ON POWER ELECTRONICS
(2011)
Article
Engineering, Electrical & Electronic
Hamidreza Zareipour et al.
IEEE TRANSACTIONS ON POWER SYSTEMS
(2011)
Article
Engineering, Electrical & Electronic
Yasser Moustafa Atwa et al.
IEEE TRANSACTIONS ON POWER SYSTEMS
(2010)
Article
Automation & Control Systems
Srdjan M. Lukic et al.
IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS
(2008)
Article
Energy & Fuels
Tsung-Ying Lee
IEEE TRANSACTIONS ON ENERGY CONVERSION
(2007)
Article
Energy & Fuels
Chi Zhang et al.
IEEE TRANSACTIONS ON ENERGY CONVERSION
(2007)
Article
Engineering, Electrical & Electronic
PF Ribeiro et al.
PROCEEDINGS OF THE IEEE
(2001)
