Related references
Note: Only part of the references are listed.
Article
Engineering, Electrical & Electronic
Feng Liu et al.
Summary: Benefiting from high power density, high reliability, and wide speed range, interior permanent magnet synchronous motors (IPMSMs) have gained significant attention. In this article, a dual-circulation cooling system based on improved magnetic circuit design is proposed to alleviate the torque ripple and heat dissipation difficulties. Additionally, an improved multiobjective optimization model considering electro-thermal coupling is studied to further enhance the performance of IPMSMs. The proposed cooling system and optimization model are validated through computational fluid dynamics and finite element analysis.
IEEE TRANSACTIONS ON TRANSPORTATION ELECTRIFICATION
(2023)
Article
Engineering, Electrical & Electronic
Peer-Ole Gronwald et al.
Summary: The study focuses on modeling heat transfer in electric traction motors with hairpin end windings and spray cooling systems. The model approach shows good agreement with measured temperatures and transient thermal simulations. However, deviations increase at high speeds, and the causes for this behavior are discussed.
IEEE TRANSACTIONS ON TRANSPORTATION ELECTRIFICATION
(2023)
Article
Thermodynamics
Pin Chen et al.
Summary: In this study, impinging jet was used as an efficient cooling technology to reduce the end-winding temperature of an electric machine stator. Infrared imaging and numerical simulation were utilized to analyze the heat dissipation efficiency of silicone oil jet on a real stator. The results showed that the configuration with an internal surface exhibited the best cooling performance, and the minimum and most cost-effective oil flow rates were determined for this configuration.
APPLIED THERMAL ENGINEERING
(2023)
Article
Energy & Fuels
Taewook Ha et al.
Summary: The study focused on maximizing the cooling performance of an electric vehicle motor with hairpin winding using the oil injection method. Numerical analysis showed that the dripping nozzle was the most effective in forming a thick oil film on the coil for optimal cooling. Experimental results indicated that the highest oil film formation rate of 83% was achieved at an oil temperature of 40 degrees C and flow rate of 6 LPM.
Proceedings Paper
Green & Sustainable Science & Technology
Chuan Liu et al.
Summary: This paper introduces a new modeling approach for electrical machines with hairpin windings and oil jet cooling, using experimental data for validation. The proposed workflow is shown to be effective in facilitating the design of similar electrical machines through good agreement between simulation and experimental results.
2021 IEEE ENERGY CONVERSION CONGRESS AND EXPOSITION (ECCE)
(2021)
Proceedings Paper
Automation & Control Systems
Antonino La Rocca et al.
Summary: This study conducted conjugate thermal analysis on a traction electric motor for EV, revealing that while spray cooling is effective, localized hotspots may occur at low speed-high torque conditions, and proposed adjusting the nozzle position to improve heat transfer rate.
IECON 2021 - 47TH ANNUAL CONFERENCE OF THE IEEE INDUSTRIAL ELECTRONICS SOCIETY
(2021)
Article
Automation & Control Systems
Chuan Liu et al.
IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS
(2020)
Article
Automation & Control Systems
Pia Lindh et al.
IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS
(2016)
Article
Engineering, Multidisciplinary
Bin Zhang et al.
IEEE TRANSACTIONS ON INDUSTRY APPLICATIONS
(2015)
