Related references
Note: Only part of the references are listed.
Article
Energy & Fuels
Xiaoli Zhu et al.
Summary: This study numerically investigated the gasification of biomass with CO2 in a pilot plant circulating fluidized bed gasifier. The results showed that the CO2 percentage in the gasifying agent had insignificant influence on gas-solid distribution, but directly affected the char conversion and product gas compositions. The optimal CO2 percentage was found to be 60 wt%, resulting in the best thermochemical performance of the gasifier.
Article
Green & Sustainable Science & Technology
Shaohua Du et al.
Summary: This study investigates the co-gasification process of coal and biomass in a bubbling fluidized bed gasifier using a coarse-grained computational fluid dynamics-discrete element method (CFD-DEM) simulation. The effects of particle size distribution and operating pressure on hydrodynamics, heat transfer, and co-gasification performance are analyzed. The results show that the increase in sand particle size distribution (PSD) width has a slight impact on particle concentration distribution, particle residence time distribution, and co-gasification performance. The convective heat transfer rate is significantly higher than that of conduction and radiation. An increase in PSD width leads to the formation of a vertical solid temperature gradient at the bottom of the bed due to deteriorated solid mixing. Higher operating pressure results in a decrease in bed temperature, and the variation in convective heat transfer rate dominates the heat transfer efficiency. Elevated operating pressure promotes the thermal-chemical conversion of blend fuel by accelerating the char conversion reaction.
Article
Energy & Fuels
Miao Yang et al.
Summary: This paper investigates biomass gasification in lab-scale fluidized bed gasifiers using the MP-PIC model coupled with the DKM and a new pyrolysis model. The results show that the DKM improves the robustness of the model and the new pyrolysis model enhances the sensitivity of gasification product yields to operating temperature. The simulation results agree well with experimental data and reveal the effects of steam/biomass ratio and operating temperature on gas product formation. The steam/biomass ratio has a minor effect on pyrolysis and heterogeneous reactions, while the gasifier temperature has a crucial impact on these processes and carbon conversion.
Article
Mechanics
Abhishek Kumar et al.
Summary: This study numerically investigates the flow past two spheres placed in a tandem arrangement using OpenFOAM at a fixed Reynolds number of 300. The diameters of the spheres are varied to determine the effects on the wake behavior, with a particular focus on the transition from steady to unsteady flow. It is found that the wake behavior is influenced by the diameter ratio and spacing between the spheres, and the drag force on the spheres increases with larger spacing.
Article
Engineering, Environmental
Dali Kong et al.
Summary: The study uses a particle-scale computational fluid dynamics-discrete element method to investigate biomass gasification in a bubbling fluidized bed reactor, exploring the effects of operating temperature and steam to biomass ratio on particle mixing and heat transfer modes. Increasing operating temperature and S/B ratio can enhance biomass mixing index and promote chemical reactions and heat transfer.
CHEMICAL ENGINEERING JOURNAL
(2022)
Article
Engineering, Chemical
Maulana G. Nugraha et al.
Summary: This study introduces new models for mass transfer to spheres under three different conditions: mass transfer without Stefan flow, mass transfer with even Stefan flow, and mass transfer with uneven flux driven Stefan flow. The new models, derived from high resolved computational fluid dynamic simulations, show improved accuracy and reduced relative error, especially for higher Sc numbers.
CHEMICAL ENGINEERING SCIENCE
(2022)
Article
Engineering, Chemical
Shaohua Du et al.
Summary: This study quantifies the combinational effect of Stefan flow, particle Reynolds number, and solid holdup on the drag force of a single reactive particle in the thermo-chemical conversion process of solid fuels inside fluidized bed reactors. The direction of Stefan flow affects the drag force, and the effect of Stefan flow weakens as the solid holdup or particle Reynolds number increases.
CHEMICAL ENGINEERING SCIENCE
(2022)
Article
Mechanics
Yingdong Wang et al.
Summary: For mixtures with dispersed reactive particles, especially highly concentrated particles, the interactions between particles and between particles and fluid are complex and have significant effects on the overall flow. This study focuses on the flow and fluid-particle heat transfer characteristics of supercritical water flowing around a fixed two-particle system. The effects of different particle configurations and the influence of Stefan flow are analyzed. The results show that the configurations of two particles have significant impacts on the drag coefficient, Nusselt number, and vortex structure, and the wake vortex structure is strongly affected by Stefan flow, which reduces the drag coefficient and Nusselt number.
INTERNATIONAL JOURNAL OF MULTIPHASE FLOW
(2022)
Article
Energy & Fuels
Maninderjit Singh et al.
Summary: A detailed process model for co-gasification of biomass and plastics in a fluidized bed reactor was developed using Aspen Plus software. The effects of process parameters such as plastic content and reactor temperature on the composition and properties of syngas were investigated. The results showed that increasing the plastic content led to higher hydrogen concentrations in the syngas, and increasing the gasification temperature resulted in increased hydrogen content and higher heating value of the syngas.
Article
Mechanics
Chia-Lin Chiu et al.
Summary: This study investigates the interaction between two free-falling spheres in water, verifies the predicted falling trajectories of the spheres, and explores the role of wake flows in the fluid-sphere interaction.
Article
Mechanics
T. J. J. M. van Overveld et al.
Summary: This paper investigates the dynamics of spherical particles in oscillating flows. It is found that the dynamics of particle pairs in oscillating channel flows are fundamentally different from those in oscillating boxes due to the presence of a Stokes boundary layer. The results show that the oscillating channel flow and the oscillating box are only equivalent in a limited region of the parameter space.
Article
Energy & Fuels
Chuang Wu et al.
Summary: This paper proposes a novel liquid carbon dioxide energy storage system based on the conventional transcritical compressed carbon dioxide energy storage system. Mathematical models are established and verified, and the effects of decision parameters on performance are studied. The results show that the novel system has significantly improved round-trip efficiency, energy generated per unit volume of storage, and Levelized cost of electricity compared to the conventional system.
JOURNAL OF ENERGY STORAGE
(2022)
Review
Green & Sustainable Science & Technology
Naresh Hanchate et al.
Summary: Biomass gasification is a widely explored research area for synthetic gas production. Dual fluidized bed gasifiers are a recent technology capable of producing medium heating value syngas.
JOURNAL OF CLEANER PRODUCTION
(2021)
Article
Green & Sustainable Science & Technology
Yi Fang et al.
Summary: This review summarized recent developments in modeling concentrated solar thermochemical gasification of biomass, the method of concentrated solar thermal for gasification, and applications and development of concentrated solar thermal biomass gasification. The study found that CSTGB could improve the utilization of biomass feedstocks and the total energy efficiency by 30% and 40%, respectively.
RENEWABLE & SUSTAINABLE ENERGY REVIEWS
(2021)
Article
Mechanics
Hui Jin et al.
Summary: This study investigates the impact of varying Stefan flow intensity on the drag coefficient and Nusselt number of supercritical water flowing around a fixed spherical particle. Results show that with increasing Stefan flow intensity, both Cd and Nu decrease while the thickness of velocity and temperature boundary layers increases. Additionally, a model for particles with Stefan flow is constructed and correlation formulas for Cd and Nu are derived.
Article
Green & Sustainable Science & Technology
Shaohua Du et al.
Summary: The study focuses on the co-gasification of PET and coal in a fluidized bed reactor, taking into account variations in particle size, density, and devolatilization reaction rate modification. The model's effectiveness is verified by comparing simulation results with experimental data. Furthermore, the study discusses the impacts of inlet gas velocity, solid feed position, and initial particle size on hydrodynamics and co-gasification reaction.
Article
Engineering, Environmental
Xihao Chen et al.
Summary: Stefan flow, induced by reactions or component diffusion inside particles, affects mass transfer between gas and solid phases significantly. Simulation results show that drag force on particles decreases with increasing Stefan Reynolds number, but the reduction is weakened as solid volume fraction increases. An innovative drag correction coefficient considering Stefan Reynolds number, particle Reynolds number and solid volume fraction is proposed based on the findings.
CHEMICAL ENGINEERING JOURNAL
(2021)
Article
Engineering, Chemical
Shuai Wang et al.
Summary: This study simulated the multiphase flow and thermochemical behaviors of char combustion in a bubbling fluidized bed using the CFD-DEM approach. By validating the model and examining heat transfer contributions, the study revealed the particle-scale behaviors of char and sand in the system.
CHEMICAL ENGINEERING SCIENCE
(2021)
Article
Mechanics
Thamali R. Jayawickrama et al.
Summary: This study investigates the effect of Stefan flow on momentum exchange and heat transfer between a particle and fluid, providing insights into the mechanisms and influencing factors of Stefan flow.
INTERNATIONAL JOURNAL OF MULTIPHASE FLOW
(2021)
Article
Physics, Fluids & Plasmas
Xitong Zhang et al.
PHYSICAL REVIEW FLUIDS
(2020)
Article
Thermodynamics
Hancong Zhang et al.
COMBUSTION AND FLAME
(2020)
Article
Mechanics
Thamali R. Jayawickrama et al.
INTERNATIONAL JOURNAL OF MULTIPHASE FLOW
(2019)
Review
Green & Sustainable Science & Technology
Sahar Safarian et al.
RENEWABLE & SUSTAINABLE ENERGY REVIEWS
(2019)
Article
Energy & Fuels
Peter Ostermeier et al.
Article
Mathematics, Applied
Chunhai Ke et al.
ADVANCES IN APPLIED MATHEMATICS AND MECHANICS
(2018)
Article
Computer Science, Interdisciplinary Applications
Qiang Zhou et al.
JOURNAL OF COMPUTATIONAL PHYSICS
(2014)
Article
Engineering, Chemical
L. W. Rong et al.
CHEMICAL ENGINEERING SCIENCE
(2013)
Article
Engineering, Chemical
Engin Pinar et al.
INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH
(2013)
Article
Engineering, Mechanical
Rahim Hassanzadeh et al.
JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY
(2013)
Article
Computer Science, Interdisciplinary Applications
Wim-Paul Breugem
JOURNAL OF COMPUTATIONAL PHYSICS
(2012)
Article
Mechanics
L. Prahl et al.
INTERNATIONAL JOURNAL OF MULTIPHASE FLOW
(2009)
Article
Mechanics
Dong-Hyeog Yoon et al.
Article
Mechanics
L. Prahl et al.
INTERNATIONAL JOURNAL OF MULTIPHASE FLOW
(2007)
Article
Mechanics
T Tsuji et al.
INTERNATIONAL JOURNAL OF MULTIPHASE FLOW
(2003)
Article
Mechanics
R Kurose et al.