4.6 Article

A magnetic-spring-based, low-frequency-vibration energy harvester comprising a dual Halbach array

Journal

SMART MATERIALS AND STRUCTURES
Volume 25, Issue 9, Pages -

Publisher

IOP PUBLISHING LTD
DOI: 10.1088/0964-1726/25/9/095017

Keywords

Halbach array; magnetic spring; resonant; electromagnetic; low frequency

Funding

  1. Pioneer Research Centre Program through National Research Foundation of Korea (NRF) - Ministry of Science, ICT and Future Planning, Korea [2010-0019313]
  2. Basic Science Research Program through National Research Foundation of Korea (NRF) - Ministry of Science, ICT and Future Planning, Korea [2013R1A1A2A10064810]
  3. National Research Foundation of Korea [2010-0019457, 2013R1A1A2A10064810] Funding Source: Korea Institute of Science & Technology Information (KISTI), National Science & Technology Information Service (NTIS)

Ask authors/readers for more resources

Energy harvesting that uses low-frequency vibrations is attractive due to the availability of such vibrations throughout the ambient environment. Significant power generation at low-frequency vibrations, however, is challenging because the power flow decreases as the frequency decreases; moreover, designing a spring-mass system that is suitable for low-frequency-vibration energy harvesting is difficult. In this work, our proposed device overcomes both of these challenges by using a dual Halbach array and magnetic springs. Each Halbach array concentrates the magnetic-flux lines on one side of the array while suppressing the flux lines on the other side; therefore, a dual Halbach array allows for an interaction between the concentrated magnetic-flux lines and the same coil so that the maximum flux linkage occurs. During the experiment, vibration was applied in a horizontal direction to reduce the gravity effect on the Halbach-array structure. To achieve an increased power generation at low-amplitude and low-frequency vibrations, the magnetic structure of the dual Halbach array and the magnetic springs were optimized in terms of the operating frequency and the power density; subsequently, a prototype was fabricated and tested. The prototype device offers a normalized power density of 133.45 mu W cm(-3) g(-2) that is much higher than those of recently reported electromagnetic energy harvesters; furthermore, it is capable of delivering a maximum average power of 1093 mu W to a 44 Omega optimum load, at an 11 Hz resonant frequency and under a 0.5 g acceleration.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.6
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available