4.6 Article

A Cyclic Calibration Method of Milling Force Coefficients Considering Elastic Tool Deformation

Related references

Note: Only part of the references are listed.
Review Engineering, Electrical & Electronic

A State-of-the-Art Review on Chatter Stability in Machining Thin-Walled Parts

Yuwen Sun et al.

Summary: Thin-walled parts are widely used in various important fields due to their lightweight requirement and high-performance needs. However, the machining of such parts faces challenges, especially in terms of dynamics. The weak rigidity of the structure and slender cutting tool often lead to chatter, which affects surface quality and efficiency. This paper reviews previous studies on dynamic characteristics, chatter stability modeling and prediction, and methods/devices for chatter elimination/suppression. It concludes with a summary of existing problems and future research directions.

MACHINES (2023)

Article Engineering, Manufacturing

Extended classification of surface errors shapes in peripheral end-milling operations

Lorenzo Morelli et al.

Summary: This paper presents a comprehensive classification of the shape of cutting forces causing surface form errors in peripheral end-milling, along with proposed analytical equations to obtain key points defining surface error shape under various cutting conditions and tool geometries. Experimental validation was conducted to prove the reliability and effectiveness of the proposed approach, showing potential for extending knowledge about surface errors in peripheral milling. The proposed formulations could also be utilized to simplify error prediction methods based on simulations or significantly reduce surface measuring time in quality control.

JOURNAL OF MANUFACTURING PROCESSES (2021)

Article Automation & Control Systems

Predicting cutting force with unequal division parallel-sided shear zone model for orthogonal cutting

Jinhua Zhou et al.

INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2020)

Article Automation & Control Systems

Investigation of the milling stability based on modified variable cutting force coefficients

Xianli Liu et al.

INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2018)

Article Engineering, Multidisciplinary

Cutting force modeling for non-uniform helix tools based on compensated chip thickness in five-axis flank milling process

Qiang Guo et al.

PRECISION ENGINEERING-JOURNAL OF THE INTERNATIONAL SOCIETIES FOR PRECISION ENGINEERING AND NANOTECHNOLOGY (2018)

Article Engineering, Manufacturing

Predictive modeling of chatter stability considering force-induced deformation effect in milling thin-walled parts

Yuwen Sun et al.

INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2018)

Article Automation & Control Systems

A prediction method of cutting force coefficients with helix angle of flat-end cutter and its application in a virtual three-axis milling simulation system

Yung-Chou Kao et al.

INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2015)

Article Engineering, Manufacturing

An examination of the fundamental mechanics of cutting force coefficients

Minghai Wang et al.

INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2014)

Article Engineering, Manufacturing

Mechanistic identification of specific force coefficients for a general end mill

J Gradisek et al.

INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2004)

Article Engineering, Manufacturing

Identification of shearing and ploughing cutting constants from average forces in ball-end milling

JJJ Wang et al.

INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2002)