Related references
Note: Only part of the references are listed.Partial replacement of OPC with CSA cements - effects on hydration, fresh and hardened properties
Ankit Kothari et al.
ADVANCES IN CEMENT RESEARCH (2023)
Blending eco-efficient calcium sulfoaluminate belite ferrite cement to enhance the physico-mechanical properties of Portland cement paste cured in refrigerated and natural winter conditions
Ahmad Alzaza et al.
CEMENT & CONCRETE COMPOSITES (2022)
Effects of sodium nitrate and OPC-GGBS concrete mix composition on phase transition of pore water at subzero temperatures
Ankit Kothari et al.
CONSTRUCTION AND BUILDING MATERIALS (2022)
Improved strength development and frost resistance of Portland cement ground-granulated blast furnace slag binary binder cured at 0 °C with the addition of calcium silicate hydrate seeds
Ahmad Alzaza et al.
JOURNAL OF BUILDING ENGINEERING (2022)
Environmental and economic sustainability of crack mitigation in reinforced concrete with SuperAbsorbent polymers (SAPs)
Davide di Summa et al.
JOURNAL OF CLEANER PRODUCTION (2022)
Hydration of calcium sulfoaluminate cement blended with blast-furnace slag
H. N. Yoon et al.
CONSTRUCTION AND BUILDING MATERIALS (2021)
Investigation of the mechanical and durability properties of sustainable high performance concrete based on calcium sulfoaluminate cement
Vahid Afroughsabet et al.
JOURNAL OF BUILDING ENGINEERING (2021)
Experimental and numerical research on development of synthetic heat storage form incorporating phase change materials to protect concrete in cold weather
Yushi Liu et al.
RENEWABLE ENERGY (2020)
Calcium sulphoaluminate cement used as mineral accelerator to improve the property of Portland cement at sub-zero temperature
Ge Zhang et al.
CEMENT & CONCRETE COMPOSITES (2020)
Hydration mechanism and early frost resistance of calcium sulfoaluminate cement concrete
Peiran Li et al.
CONSTRUCTION AND BUILDING MATERIALS (2020)
Novel selection of environment-friendly cementitious materials for winter construction: Alkali-activated slag/Portland cement
Ge Zhang et al.
JOURNAL OF CLEANER PRODUCTION (2020)
Calcium-silicate-hydrate seeds as an accelerator for saving energy in cold weather concreting
Ge Zhang et al.
CONSTRUCTION AND BUILDING MATERIALS (2020)
Effect of calcium oxide on mechanical properties and microstructure of alkali-activated slag composites at sub-zero temperature
Cheng Ju et al.
JOURNAL OF BUILDING ENGINEERING (2020)
1-Year development trend of concrete compressive strength using Calcium Sulfoaluminate cement blended with OPC, PFA and GGBS
Jaime S. K. Yeung et al.
CONSTRUCTION AND BUILDING MATERIALS (2019)
The effects of nano-C-S-H with different polymer stabilizers on early cement hydration
Fang Wang et al.
JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2019)
Advances in understanding ye'elimite-rich cements
Mohsen Ben Haha et al.
CEMENT AND CONCRETE RESEARCH (2019)
Hydration reaction and strength development of calcium sulfoaluminate cement-based mortar cured at cold temperatures
Guangping Huang et al.
CONSTRUCTION AND BUILDING MATERIALS (2019)
CSA and slag: towards CSA composite binders
Federica Bertola et al.
ADVANCES IN CEMENT RESEARCH (2019)
Effect of ground granulated blast furnace slag on the properties of calcium sulfoaluminate cement
Danying Gao et al.
CONSTRUCTION AND BUILDING MATERIALS (2019)
Use of tartaric acid for the production of sustainable Portland-free CSA-based mortars
L. Coppola et al.
CONSTRUCTION AND BUILDING MATERIALS (2018)
Improvement of workability and early strength of calcium sulphoaluminate cement at various temperature by chemical admixtures
Guoxin Li et al.
CONSTRUCTION AND BUILDING MATERIALS (2018)
Potential application of Portland cement-calcium sulfoaluminate cement blends to avoid early age frost damage
Ling Qin et al.
CONSTRUCTION AND BUILDING MATERIALS (2018)
Kinetics of water freezing in mesopores determined by differential scanning calorimetry
Marcin Koniorczyk et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2017)
Optimization of SEM-EDS to determine the C-A-S-H composition in matured cement paste samples
J. E. Rossen et al.
MATERIALS CHARACTERIZATION (2017)
Portland Cement Hydration Behavior at Low Temperatures: Views from Calculation and Experimental Study
Zhuangzhuang Liu et al.
ADVANCES IN MATERIALS SCIENCE AND ENGINEERING (2017)
Studies on the early hydration of two modifications of ye'elimite with gypsum
D. Jansen et al.
CEMENT AND CONCRETE RESEARCH (2017)
Using gypsum to control hydration kinetics of CSA cements
Frank Winnefeld et al.
CONSTRUCTION AND BUILDING MATERIALS (2017)
ImageJ2: ImageJ for the next generation of scientific image data
Curtis T. Rueden et al.
BMC BIOINFORMATICS (2017)
Hydration evolution and compressive strength of calcium sulphoaluminate cement constantly cured over the temperature range of 0 to 80 °C
Peiming Wang et al.
CEMENT AND CONCRETE RESEARCH (2017)
The effect of antifreeze additives on fresh concrete subjected to freezing and thawing cycles
Riza Polat
COLD REGIONS SCIENCE AND TECHNOLOGY (2016)
Performance of carbonated calcium silicate based cement pastes and mortars exposed to NaCl and MgCl2 deicing salt
Yaghoob Farnam et al.
CONSTRUCTION AND BUILDING MATERIALS (2016)
Hydration of ordinary Portland cement and calcium sulfoaluminate cement blends
R. Trauchessec et al.
CEMENT & CONCRETE COMPOSITES (2015)
Behavior of fresh and hardened concretes with antifreeze admixtures in deep-freeze low temperatures and exterior winter conditions
Fatma Karagol et al.
CONSTRUCTION AND BUILDING MATERIALS (2015)
Hydration stage identification and phase transformation of calcium sulfoaluminate cement at early age
S. W. Tang et al.
CONSTRUCTION AND BUILDING MATERIALS (2015)
A hydration study of various calcium sulfoaluminate cements
A. Telesca et al.
CEMENT & CONCRETE COMPOSITES (2014)
The effects of urea on strength gaining of fresh concrete under the cold weather conditions
Ramazan Demirboga et al.
CONSTRUCTION AND BUILDING MATERIALS (2014)
Determination of ice content in hardened concrete by low-temperature calorimetry Influence of baseline calculation and heat of fusion of confined water
Min Wu et al.
JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2014)
Effect of low temperature on hydration performance of the complex binder of silica fume-portland cement
Liu Jun et al.
JOURNAL OF WUHAN UNIVERSITY OF TECHNOLOGY-MATERIALS SCIENCE EDITION (2014)
Hydration of Portland cement with additions of calcium sulfoaluminates
Gwenn Le Saout et al.
CEMENT AND CONCRETE RESEARCH (2013)
The influence of calcium nitrate as antifreeze admixture on the compressive strength of concrete exposed to low temperatures
Fatma Karagol et al.
COLD REGIONS SCIENCE AND TECHNOLOGY (2013)
Mechanical performance of shotcrete made with a high-strength cement-based mineral accelerator
Jong-Pil Won et al.
CONSTRUCTION AND BUILDING MATERIALS (2013)
Hydration Reactions and Mechanical Strength Developments of Iron-Rich Sulfobelite Eco-cements
Gema Alvarez-Pinazo et al.
INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2013)
Hydration of slag-blended cements
B. Kolani et al.
CEMENT & CONCRETE COMPOSITES (2012)
A physico-chemical basis for novel cementitious binders
Ellis M. Gartner et al.
CEMENT AND CONCRETE RESEARCH (2011)
The influence of gypsum ratio on the mechanical performance of slag cement accelerated by calcium sulfoaluminate cement
Marie Michel et al.
CONSTRUCTION AND BUILDING MATERIALS (2011)
Use of Industrial Byproducts as Alumina Sources for the Synthesis of Calcium Sulfoaluminate Cements
Maria Lucia Pace et al.
ENVIRONMENTAL SCIENCE & TECHNOLOGY (2011)
Energy-Efficient Approach to Cold-Weather Concreting
Lynette A. Barna et al.
JOURNAL OF MATERIALS IN CIVIL ENGINEERING (2011)
The ternary system Portland cement-calcium sulphoaluminate clinker-anhydrite: Hydration mechanism and mortar properties
Laure Pelletier et al.
CEMENT & CONCRETE COMPOSITES (2010)
Pore size and shape in mortar by thermoporometry
Zhenhua Sun et al.
CEMENT AND CONCRETE RESEARCH (2010)
The influence of lightweight aggregate on the physico-mechanical properties of concrete exposed to freeze-thaw cycles
Riza Polat et al.
COLD REGIONS SCIENCE AND TECHNOLOGY (2010)
Calorimetric and thermogravimetric study on the influence of calcium sulfate on the hydration of ye'elimite
Frank Winnefeld et al.
JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2010)
Heat evolution in hydrating expansive cement systems
W. Nocun-Wczelik et al.
JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2010)
The greening of the concrete industry
C. Meyer
CEMENT & CONCRETE COMPOSITES (2009)
Synthesis of belite cement clinker of high hydraulic reactivity
Larbi Kacimi et al.
CEMENT AND CONCRETE RESEARCH (2009)
Investigation of the microstructure and carbonation of CSA-based concretes removed from service
L Zhang et al.
CEMENT AND CONCRETE RESEARCH (2005)
Microstructure and mechanical performance of belite cements from high calcium coal fly ash
A Guerrero et al.
JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2005)
Experimental identification of ice formation in small concrete pores
JP Kaufmann
CEMENT AND CONCRETE RESEARCH (2004)
Backscattered electron imaging of cementitious microstructures: understanding and quantification
KL Scrivener
CEMENT & CONCRETE COMPOSITES (2004)
X-ray study of freezing and melting of water confined within SBA-15
K Morishige et al.
LANGMUIR (2003)
High-performance cement matrices based on calcium sulfoaluminate-belite compositions
FP Glasser et al.
CEMENT AND CONCRETE RESEARCH (2001)
Reactivity of blast-furnace slag in Portland cement blends hydrated under different conditions
JI Escalante et al.
CEMENT AND CONCRETE RESEARCH (2001)
Melting and freezing of water in ordered mesoporous silica materials
A Schreiber et al.
PHYSICAL CHEMISTRY CHEMICAL PHYSICS (2001)
Properties of blended sulfoaluminate belite cement
V Zivica
CONSTRUCTION AND BUILDING MATERIALS (2000)
Share Paper
