Related references
Note: Only part of the references are listed.Quadratic multiple regression model and spectral relaxation approach for carreau nanofluid inclined magnetized dipole along stagnation point geometry
Sayed M. El Din et al.
SCIENTIFIC REPORTS (2022)
Thermal analysis characterisation of solar-powered ship using Oldroyd hybrid nanofluids in parabolic trough solar collector: An optimal thermal application
Faisal Shahzad et al.
NANOTECHNOLOGY REVIEWS (2022)
Numerical modelling of particle impact and residual stresses in cold sprayed coatings: A review
Ahmed Fardan et al.
SURFACE & COATINGS TECHNOLOGY (2021)
The role of particles flow characteristics in the performance of cold spray nozzles
Rocco Lupoi et al.
CIRP ANNALS-MANUFACTURING TECHNOLOGY (2020)
Residual Stress in High-Velocity Impact Coatings: Parametric Finite Element Analysis Approach
Felipe Oviedo et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2020)
Effects of Interface Bonding on the Residual Stresses in Cold-Sprayed Al-6061: A Numerical Investigation
Enqiang Lin et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2019)
Influence of cold spray parameters on the microstructures and residual stress of Zn coatings sprayed on mild steel
N. B. Maledi et al.
SURFACE & COATINGS TECHNOLOGY (2017)
Residual Stress Analysis of Cold-Sprayed Copper Coatings by Numerical Simulation
Wenya Li et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2016)
Numerical Analysis of Cold Spray Particles Impacting Behavior by the Eulerian Method: A Review
W. Y. Li et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2016)
New insights into the coating/substrate interfacial bonding mechanism in cold spray
Yingchun Xie et al.
SCRIPTA MATERIALIA (2016)
Feed rate effect on particulate acceleration in Cold Spray under low stagnation pressure conditions
M. C. Meyer et al.
SURFACE & COATINGS TECHNOLOGY (2016)
Interface behavior of particles upon impacting during cold spraying of Cu/Ni/Al mixture
Wenya Li et al.
MATERIALS & DESIGN (2016)
Residual stress induced by cold spray coating of magnesium AZ31B extrusion
G. Shayegan et al.
MATERIALS & DESIGN (2014)
Modelling of impact behaviour of cold spray particles: review
W. Y. Li et al.
SURFACE ENGINEERING (2014)
Deposition behavior of thermally softened copper particles in cold spraying
Shuo Yin et al.
ACTA MATERIALIA (2013)
Effect of particle and substrate preheating on particle deformation behavior in cold spraying
M. Yu et al.
SURFACE & COATINGS TECHNOLOGY (2013)
Surface roughness optimization of cold-sprayed coatings using Taguchi method
Tarun Goyal et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2012)
Influence of Particle Initial Temperature on High Velocity Impact Process in Cold Spraying
Yue Li et al.
2011 INTERNATIONAL CONFERENCE OF ENVIRONMENTAL SCIENCE AND ENGINEERING, VOL 12, PT A (2012)
Examination on Substrate Preheating Process in Cold Gas Dynamic Spraying
Shuo Yin et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2011)
Modeling of high velocity impact of spherical particles
Baran Yildirim et al.
WEAR (2011)
An Experimental and Finite Element Study of Cold Spray Copper Impact onto Two Aluminum Substrates
Peter C. King et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2010)
Optimal design of a cold spray nozzle by numerical analysis of particle velocity and experimental validation with 316L stainless steel powder
Wen-Ya Li et al.
MATERIALS & DESIGN (2007)