Related references
Note: Only part of the references are listed.
Article
Multidisciplinary Sciences
Mohsen Ebrahimi Naghani et al.
Summary: In this study, the linear and nonlinear optical properties of GO-ZnO and RGO-ZnO nanocomposites were investigated and compared with pure GO and RGO. The synthesized materials were characterized using FT-IR, UV-Vis, XRD, and EDX. The results showed successful reduction of GO and synthesis of GO-ZnO and RGO-ZnO nanocomposites. The UV-Vis spectra revealed the direct band gaps of the materials, consistent with the increased nonlinear absorption coefficient and refractive index values obtained from the z-scan technique.
SCIENTIFIC REPORTS
(2023)
Article
Materials Science, Ceramics
D. Sudha et al.
Summary: A simple and cost-effective co-precipitation method was used to prepare ZnO nanoparticles from a metal organic framework, which were then blended with graphene oxide (GO) to create the ZnO-GO nanocomposite. The physicochemical properties, structural behavior, functional groups, and optical properties of the nanoparticles and nanocomposite were analyzed through various techniques including XRD, FT-IR, UV-vis spectroscopy, FESEM, and EDX. Cyclic voltammetry was also employed to study the redox behavior of the ZnO and ZnO-GO composites.
CERAMICS INTERNATIONAL
(2023)
Article
Chemistry, Analytical
Yan Zhang et al.
Summary: The bimetallic PtPd-modified Bi2MoO6 (BMO) microspheres were synthesized using facile ultrasonic reduction and solvothermal methods. The sensor based on BMO-1.5% exhibited a significantly higher response value for CO gas compared to the initial BMO sensor. The enhanced gas properties were attributed to the metal-support interaction and sensitization of Pt and Pd.
SENSORS AND ACTUATORS B-CHEMICAL
(2023)
Article
Spectroscopy
Afroz Khan et al.
Summary: In this study, ZnO nanorods were successfully synthesized using the microwave-assisted technique. Zn1-xAgxO (x = 0.05, 0.1) was prepared using the solid-state reaction method, while graphene oxide (GO) was prepared using Hummer's modified method. The nanorods and nanocomposites were characterized using various techniques, and it was found that the nanocomposites exhibited improved antibacterial activity compared to pure ZnO nanorods.
SPECTROCHIMICA ACTA PART A-MOLECULAR AND BIOMOLECULAR SPECTROSCOPY
(2023)
Review
Chemistry, Analytical
Forough Ghasemi et al.
Summary: Paper-based nanosensors using various nanostructures for optical signal visualization are important components of paper-based analytical devices (PADs). They have the potential for point-of-care testing and on-site detection of analytes with chemical, biochemical, and environmental importance due to their low cost, convenience, scalability, portability, and biocompatibility. This review focuses on the fundamentals, state of the art, and future trends of PADs and discusses topics such as paper types, fabrication approaches, nanostructure stabilization, signal acquisition, data handling, sensing mechanisms, and application areas.
ANALYTICA CHIMICA ACTA
(2023)
Article
Biophysics
Hong Pan et al.
Summary: Electronic textiles are revolutionizing our lives, but their lack of effective recycling poses a significant environmental burden. This study presents a cotton fiber-based piezoresistive textile that is biocompatible, biodegradable, and environmentally friendly. The textile is fabricated using a scalable dip-coating method, achieving strong adhesion between MXene flakes and porous cotton cellulose fibers through hydrogen bonding. With high sensitivity, fast response time, and good cycle stability, this textile can detect various human biomechanical activities while ensuring comfort. Additionally, the cotton cellulose component can naturally degrade, making the electronic textile truly biodegradable. This work offers a cost-effective and ecologically-benign approach to developing high-performance wearable bioelectronics.
BIOSENSORS & BIOELECTRONICS
(2023)
Article
Chemistry, Analytical
Vinoda B. Patil et al.
Summary: In this study, a carbon paste electrode modified with graphene oxide and copper oxide nanoparticles was fabricated for the electrochemical analysis of theophylline. The electro-kinetic parameters and the sensing performance of the modified electrode were investigated using electrochemical methods. The results showed that the modified electrode exhibited higher sensitivity and excellent sensing function for the detection of theophylline.
Article
Chemistry, Analytical
Chunxu Chen et al.
Summary: This work presents a new metal phosphide nanomaterial for energy storage and catalysis, replacing chemical sensors. The material exhibits high sensitivity, low hysteresis, and good repeatability in a wide range of humidity. By adjusting the composition, the humidity sensing performance can be efficiently modulated, showing great potential in respiratory analysis and non-contact human-machine interfacing. This research opens up new possibilities for developing high-performance wearable sensing devices.
SENSORS AND ACTUATORS B-CHEMICAL
(2022)
Article
Energy & Fuels
Fathia Chekired et al.
Summary: Near-Zero-Energy Buildings present challenges in various aspects of energy, but accessing affordable technological solutions remains difficult in developing countries. A low-cost and reliable home energy-management prototype was developed and implemented on a scale model, showcasing the optimization of energy consumption and savings through a PWM charge controller and battery storage management. The prototype's successful energy management system was then applied to a large-scale smart solar home, focusing on lighting management and achieving additional energy savings.
Article
Engineering, Electrical & Electronic
Cheng Yang et al.
Summary: This study focuses on the fabrication of flexible strain sensors using vertical graphene nanowalls (VG) and their applications in physiological assessment. The sensors were used to collect radial and carotid pulses as well as respiratory rate for risk assessment of cardiac bradycardia, arrhythmias, arrest, and artery stiffening. A wearable circuit was also designed and fabricated for portable physiological monitoring.
ACS APPLIED ELECTRONIC MATERIALS
(2022)
Article
Engineering, Electrical & Electronic
Fanli Meng et al.
Summary: This article presents a one-step hydrothermal method for the preparation of rGO/Co3O4 nanocomposites and their performance testing. The results show that 1rGO/Co3O4 (335 wt%) has the best sensitivity to xylene gas, with an optimal working temperature of 175 degrees Celsius, and can detect xylene gas with a minimum concentration of 1 pph.
IEEE TRANSACTIONS ON INSTRUMENTATION AND MEASUREMENT
(2021)
Article
Chemistry, Analytical
Wenbo Qin et al.
Article
Chemistry, Physical
Mona Mirmotallebi et al.
JOURNAL OF ALLOYS AND COMPOUNDS
(2018)
Article
Chemistry, Analytical
Jin Wu et al.
SENSORS AND ACTUATORS B-CHEMICAL
(2018)
Review
Chemistry, Physical
Jisoo Park et al.
ENERGY STORAGE MATERIALS
(2018)
Article
Chemistry, Analytical
N. B. Tanvir et al.
SENSORS AND ACTUATORS B-CHEMICAL
(2017)
Proceedings Paper
Engineering, Multidisciplinary
Alexander G. Bannov et al.
PROCEEDINGS OF THE 30TH ANNIVERSARY EUROSENSORS CONFERENCE - EUROSENSORS 2016
(2016)
Article
Nanoscience & Nanotechnology
Anthony P. Taylor et al.
Article
Chemistry, Analytical
S. M. Balashov et al.
SENSORS AND ACTUATORS B-CHEMICAL
(2015)
Review
Chemistry, Analytical
Fan-Li Meng et al.
TRAC-TRENDS IN ANALYTICAL CHEMISTRY
(2015)
Proceedings Paper
Materials Science, Multidisciplinary
Nauman Bin Tanvir et al.
MATERIALS TODAY-PROCEEDINGS
(2015)
Review
Chemistry, Analytical
S. Basu et al.
SENSORS AND ACTUATORS B-CHEMICAL
(2012)
Article
Chemistry, Analytical
Hyeun Joong Yoon et al.
SENSORS AND ACTUATORS B-CHEMICAL
(2011)
Article
Chemistry, Multidisciplinary
Jeremy T. Robinson et al.
