Related references
Note: Only part of the references are listed.
Article
Engineering, Chemical
Kexin Xu et al.
Summary: This study proposes a generalized method for optimizing the design of gasket and welded plate heat exchangers. By establishing temperature relations, the optimal solution with minimum total transfer area is obtained. Two case studies demonstrate the effectiveness of this method.
Article
Engineering, Chemical
Xianglong Zhuge et al.
Summary: This paper evaluates the performance of a wellhead multistage bundle gas-liquid separator using numerical simulation. The results show that increasing the water cut improves the uniformity of the separation flow field and enhances the swirl effect, leading to higher separation efficiency. The flow rate and pressure of the separation flow field also affect the separation performance. By optimizing the number and diameter of the secondary separation bundles, further improvement in separation efficiency can be achieved.
Article
Engineering, Chemical
Anton Beck et al.
Summary: This article presents a new optimization model that allows for the simultaneous optimization of the design and operation of a supply and heat recovery system and production scheduling. The model was used to retrofit a small brewery's energy system and identify decarbonization measures for different future scenarios.
Article
Engineering, Chemical
Kexin Xu et al.
Summary: Improving energy efficiency in heat exchanger networks is still a significant problem, especially in energy-intensive operations. This study proposes a step-by-step automated retrofit approach based on Pinch Analysis and utilizes high-efficiency plate heat exchangers for retrofit. The results show that this method is flexible and applicable to various retrofit problems.
Article
Engineering, Chemical
Yanqing Ma et al.
Summary: The study analyzed the technoeconomic performance of four CO2 capture alternatives for the CTEG process, with results showing that the Rectisol technology has the best comprehensive performance.
Article
Engineering, Chemical
Wenjin Zhou et al.
Summary: This paper establishes a mathematical model for the optimal design and operation of a multi-period water supply network, considering the fluctuation of water demand and raw water availability, as well as introducing an operating cost penalty factor. The model provides guidance on technology and capacity selection under multi-period demand variations.
Article
Engineering, Chemical
Xiao Yang et al.
Summary: This study investigated the flow characteristics of desulphurization ash particles in a riser in a circulating fluidized bed (CFB) for semi-dry flue gas desulphurization using CFB technology. The findings showed a relatively high solids holdup near the bottom of the riser, gradually decreasing as the height increases, and a stable value from the middle to the top of the riser. The radial distribution also found low solids holdup in the center and high in the wall region. The particle-based Archimedes number was found to have a linear relationship with the solids holdup at all operating conditions.
