Journal
SURFACE & COATINGS TECHNOLOGY
Volume 473, Issue -, Pages -Publisher
ELSEVIER SCIENCE SA
DOI: 10.1016/j.surfcoat.2023.129980
Keywords
DLC; Hydrogen; HiPIMS; DOMS; Mechanical properties; Tribology
Ask authors/readers for more resources
The automobile industry is working towards reducing emissions by improving the efficiency of internal combustion engines. One method being explored is the application of low friction carbon coatings on engine parts. This study found that depositing films with increasing hydrogen content resulted in improved mechanical and tribological properties, suggesting the potential benefits of higher hydrogen content as piston ring coatings to decrease friction losses.
The automobile industry has increased its efforts in reducing the emissions of internal combustion engines by improving their efficiency. Decreasing the energy losses by friction in the engines parts is at the core of this attempt. One of the technologies that have been applied in achieving this is the application of carbon coating in engine parts surfaces because of their low friction coefficient characteristics. In this study, DLC films, a specific type of carbon coatings, were deposited using the Deep oscillation magnetron sputtering (DOMS) method, which is a variation of the high-power impulse magnetron sputtering (HiPIMS) method. Those films were deposited with an increasingly higher hydrogen content, and then their mechanical, morphological, and tribological properties were studied. All of this was carried out to verify if the higher hydrogen content is beneficial to use as piston ring coatings in order to decrease friction losses. The variation in the hydrogen content was achieved by increasing the partial pressure of methane inside the deposition chamber during the deposition, which allowed the deposition of films with up to 30 at. % of hydrogen. The variation allowed the depositions of films with a hardness above 10 GPa, a friction coefficient lower than 0.16 (30 % lower when compared to hydrogen-free DLCs), and with specific wear rates in the order of 10-16 mm3/Nm. The hydrogen content also changed the morphology of the films' surface, as well as increasing its deposition rates by 27 %.
Authors
I am an author on this paper
Click your name to claim this paper and add it to your profile.
Reviews
Recommended
No Data Available